Superplastic forming (SPF) is a manufacturing process utilized in the automotive industry to produce complex geometry aluminum or magnesium alloy components which cannot be fabricated at room temperature. This paper investigates the effects of the die entry radius and t More
Superplastic forming (SPF) is a manufacturing process utilized in the automotive industry to produce complex geometry aluminum or magnesium alloy components which cannot be fabricated at room temperature. This paper investigates the effects of the die entry radius and the interfacial friction coefficient on the required forming time and thickness distribution of a superplastic formed part. A commercial finite element software, ABAQUS/Implicit, is applied to simulate forming of AA5083 aluminum alloy into a license plate pocket panel. The results indicate that for a fixed friction coefficient, increasing the entry radius reduces the forming time and enhances the formed part quality, in terms of thickness distribution. It is also shown that the lower the friction coefficient, the higher the sensitivity of the forming time to the die entry radius variations.//
Manuscript profile
The vehicle driving comfort has become one of the important factors of vehicle quality and receives increasing attention. In this paper, optimal points of vehicle suspension parameters are generated using modified non-dominated sorting genetic algorithm (NSGA-II) for Pa More
The vehicle driving comfort has become one of the important factors of vehicle quality and receives increasing attention. In this paper, optimal points of vehicle suspension parameters are generated using modified non-dominated sorting genetic algorithm (NSGA-II) for Pareto optimization of 5-degree of freedom vehicle vibration model considering three conflicting functions simultaneously. In this way random profile is considered for the road excitation. Objective functions are vertical acceleration of seat, relative displacement between sprung mass and forward tire and relative displacement between sprung mass and rear tire. Results are compared with the previous works. Such comparison shows good behaviour of the optimum design points proposed in this work.
Manuscript profile
