Omid Sam Daliri Articles List

List of Articles Omid Sam Daliri

Open Access Article
- Abstract Page
- Full-Text
1 - Characterization of Stress Concentration in Thin Cylindrical Shells with Rectangular Cutout Under Axial Pressure
O. Sam Daliri M. Farahani

In this paper, stress concentration in the thin cylindrical shell with rectangular cutout subjected to uniform axial pressure was investigated using a parametric finite element model. Design of experiments techniques and statistical analysis was used to provide a model More

In this paper, stress concentration in the thin cylindrical shell with rectangular cutout subjected to uniform axial pressure was investigated using a parametric finite element model. Design of experiments techniques and statistical analysis was used to provide a model for characterizing the critical stress in these components. The influences of the geometrical parameters and their combinations were studied in detail. It was observed that the length to width ratio of the cutout, the length and the radius to thickness ratio of the cylinder were significant parameters for describing the stress concentration around the cutout, respectively. By increasing the length to width ratio as a main effective geometrical factor in the stress concentration, the stress around the cutout was increased significantly. Based on the statistical analysis conducted in this study, a formula was derived which can predict the stress concentration around the cutout of the cylinder with the accuracy more than 84% (R2 = 88.7%, R2pred = 84.6%, R2adj= 86.7%). Manuscript profile
Open Access Article
- Abstract Page
- Full-Text
2 - Experimental Correlation Between Microstructure, Residual Stresses and Mechanical Properties of Friction Stir Welded 2024-T6 Aluminum Alloys
Majid Farhang Mohammadreza Farahani Mohammad Nazari O. Sam Daliri
10.30486/admt.2022.1943845.1322

Friction stir welding was performed on AA2024- T6 aluminum plates using different rotation and traverse speeds with the objective of improving the mechanical strength and microstructure properties. The influence of the traverse and rotation speed on the microstructures, More

Friction stir welding was performed on AA2024- T6 aluminum plates using different rotation and traverse speeds with the objective of improving the mechanical strength and microstructure properties. The influence of the traverse and rotation speed on the microstructures, mechanical properties and residual stresses of the welded Aluminum plates were investigated. By increasing the rotation speed, stirred zone grain size became larger. Besides, the homogenous second phase distribution was obtained. Furthermore, by increasing both rotational and traverse speeds, hardness of the thermo-mechanically affected zone and the stirred zone increase to base metal hardness. These welded plates that were fractured at advancing side have a maximum tensile strength equal to 71% of base plate strength which was obtained at 31.5 mm/min traverse speeds and 1120 rpm rotational speed. The longitudinal residual stress was diminished with decreasing of rotational speed by 1120 rpm at a constant traverse speed. In this conditions and by increasing the traverse speed by 31.5 mm/min, the maximum tensile strength was obtained as many as 48%. It was attributed to more plastic deformation and minimum grain size in the weld zone due to higher traverse speed. Manuscript profile

Current Issue

Published Issues

Menu

Browse

List of Articles Omid Sam Daliri