In this paper, the effect of pre-stress condition on the resonance frequency of the transducer is studied by using numerical and analytical methods. To compare the obtained results, two sandwich-type transducers with nominal frequency of 25 kHz and 30 kHz are considered More
In this paper, the effect of pre-stress condition on the resonance frequency of the transducer is studied by using numerical and analytical methods. To compare the obtained results, two sandwich-type transducers with nominal frequency of 25 kHz and 30 kHz are considered. Experimental determination of pre-stress value in transducer is described and measured. Then resonance frequency of transducers in the presence of pre-stress is determined by impedance analyser. Numerical analysis is conducted by modelling three-dimensional transducer in details at ABAQUS software. The resonance frequency is determined with and without pre-stress. The FE results show that by applying pre-stress on the transducers, the resonance frequency of transducers decreased. Furthermore, the FE results are very close to experimental results. Furthermore, a systematic analytical solution is presented based on one-dimensional wave propagation. The resultant displacement for each sub-section of the transducer is calculated and then all of them are assembled and solved by considering the continuity conditions of displacement and force components. It is found that pre-load condition that is produced by central bolt reduces resonance frequency of the transducer. The obtained analytical results provide fast and reliable model for predicting resonance frequency of transducer.
Manuscript profile
