Ultrasonic Assisted Drilling (USD) is new technique to drill difficult to machine materials. In this method, tool or workpiece vibrates with amplitude of few microns in addition to conventional drill bite rotation. In this experimental research, the bone was drilled both conventionally and using UAD, then the thrust was measured in two methods at feed rates of 50, 75 and 125 mm/s and 500, 710 and 1000 RPMs. The results show that USD method causes the thrust force decreases considerably in compare whit conventional drilling. The maximum temperature is less in USD at low RPMs. پرونده مقاله

In this paper, an attempt has been made to provide a numerical method for investigating the mechanical properties of multilayer scaffolding. These scaffolds can be used as implants in bone fractures. For this purpose two numerical simulation methods are introduced to predict the elastic properties of multilayer cell scaffolds. These simulations are based on two models: a 3D model with a volumetric element, and a 1D model with a linear element. To compare the results of these models, three types of two- and three-layer titanium alloy scaffolds have been simulated by the two methods. Also, Young's modulus of the scaffolds has been compared with the experimental conclusions of earlier studies. The results confirm that simulations with 1D models are more cost-effective compared to 3D ones. Additionally, because of the more reliable agreement of Young's modulus results of numerical modeling with the linear element (1.8 to 5 times) compared to the volumetric element (11 to 23 times) compared to the experimental findings, the numerical method with the linear elements can be a reliable tool for studying multilayer scaffoldings. پرونده مقاله

Advances in the additive manufacturing technology have led to the production of complex microstructures with unprecedented accuracy and due todesigning an effective implant is a major scientific challenge in bone tissue regeneration and bone growth. In this research, titanium alloy cylindrical scaffolds with three-dimensional architectures have been simulated and compared for curing partial bone deficiencies. The cylindrical networks in the scaffold (outer diameter 15 and length 30 millimeters) were designed in 36 different convergent, two-layer and three-layer types with 50% and 70% porosity. In all the samples, outer layers were denser than the inner layers. Mechanical characteristics of these scaffolds have been determined by simulating uniform compression load. The stress-strain curve of the samples showed that Young’s modulus and yield stress in the scaffolds with constant porosity were related to a unit-cell and the two-layer scaffolds, without changing Young’s modulus, had higher yield stress. This advantage was more significant in high-density scaffolds. پرونده مقاله