Design of 4 Transistors and 1 Memristor Hybrid Nonvolatile Memory Cell with Low Power, High Speed, and High Density

Subject Areas : Renewable energy

Arash  Alijani ¹ (Department of Electrical and Computer Engineering- Science and Research Branch, Islamic Azad University, Tehran, Iran)
Behzad  Ebrahimi ² (Department of Electrical and Computer Engineering- Science and Research Branch, Islamic Azad University, Tehran, Iran)
Massoud  Dousti ³ (Department of Electrical and Computer Engineering- Science and Research Branch, Islamic Azad University, Tehran, Iran)

Received: 2021-09-14 Accepted : 2021-12-01 Published : 2021-12-22

Keywords: Low power, High speed, Memristor, hybrid memory, high density, non-volatile,

Abstract :

Memristor is the fourth fundamental element after resistor, capacitor, and inductor. Memristor can become an essential element of SRAM and DRAM caches because of its zero power consumption in data storage and non-volatile state. It can effectively improve the efficiency, speed, and power consumption of circuits. In this paper, we propose a 4T1M memory cell reducing the cell area by maintaining the maximum properties of 6T1M. To simulate the proposed memory cell, the length of the memristors is 10 nm, and the resistance of their on and off states is selected as 1 kΩ and 200 kΩ, respectively. Also, the cell MOS transistors are simulated by the 32 nm HP CMOS PTM model. Simulations in H-Spice software, at 0.9 V power supply, have been conducted to compare the proposed cell characteristics with two conventional six-transistor (6T) and six-transistor one-memristor (6T1M) cells. The results show that using a memristor in a memory cell causes zero power consumption during data storage for a long time and reduces the occupied area by 36.7% compared to the 6T1M cell. The speed of writing “1” data on the proposed cell is only 30 ps, which shows a 3-fold improvement compared to the 6T1M cell, but no significant change is observed when writing “0” data. The static power of the proposed cell is 133 times less than that of a six-transistor cell, and its dynamic power is about the same as the 6T1M cell, but it consumes 60 times less energy than a six-transistor cell.

References:

[1] A. Farmahini-Farahani, J.H. Ahn, K. Morrow, N.S. Kim, “NDA: Near-DRAM acceleration architecture leveraging commodity DRAM devices and standard memory modules”, Proceeding of the IEEE/HPCA, pp. 283–295, Burlingame, CA, USA, Feb. 2015 (doi: 10.1109/HPCA.2015.7056040).

[2] N.H.E. Weste, M. Harris, “CMOS VLSI design: A circuits and systems perspective”, 4th Ed. London, U.K.: Pearson, 2011.

[3] J. Rabaey, “Low power design essentials”, Springer, 2009.

[4] L. Chua, “Memristor–the missing circuit element”, IEEE Trans. on Circuit Theory, vol. CT-18, no. 5, pp. 507–519, Sept. 1971 (doi: 10.1109/TCT.1971.1083337).

[5] O. Kavehei, A. Iqbal, Y.S. Kim, K. Eshraghian, S.F. Al-Sarawi, D. Abbott, “The fourth element: Characteristics, modelling and electromagnetic theory of the memristor”, Proceedings of the Royal Society A, Mathematical, Physical and Engineering Sciences, vol. 466, no. 2120, pp. 2175–2202, Aug. 2010 (doi: 10.1098/rspa.2009.0553).

[6] K. Karami, S.M.A. Zanjani, M. Dolatshi, "Design and simulation of 4 Transistor and 2 memristors memory with the least power and power-delay product", Journal of Intelligent Procedures in Electrical Technology, vol. 12, no. 47, pp.103-113, Dec. 2021 (dor: 20.1001.1.23223871.1400.12.3.4.4) (in persian).

[7] S.S. Sarwar, S.A.N. Saqueb, F. Quaiyum, A. Rashid, "Memristor-based non-volatile random access memory: hybrid architecture for low power compact memory design", IEEE Access, vol. 1, no. 23, pp. 29-35, May 2013 (doi: 10.1109/ACCESS.2013.2259891).

[8] V. Saminathan, K. Parasamivam, "Design and analysis of low power hybrid memristor-CMOS based distinct binary logic non-volatile SRAM cell", Circuit and System, vol. 7, no. 8, pp. 119-127, March 2016 (doi: 10.42-36/cs.2016.73012).

[9] A. Rezaei, S.M.A. Zanjani, “Design and analysis of 2 memristor-based non-volatile SRAM cells”, Journal of Novel Researches on Electrical Power, vol. 9, no. 2, pp. 47-56, Summer 2020 (in Persian).

[10] M. Teimoori, A. Amirsoleimani, A. Ahmadi, M. Ahmadi, "A 2M1M crossbar architecture: Memory", IEEE Trans. on Very Large Scale Integration (VLSI) Systems, vol. 26, no. 12, pp. 2608-2618, Dec. 2018, 10.1109/TVLSI.2018.2799951 (doi: 10.1109/TVLSI.2018.2799951).

[11] M.N. Sakib, R. Hassan, S.N. Biswas, S.R. Das, "Memristor-based high-speed memory cell with stable successive read operation", IEEE Trans. on Computer-Aided Design of Integrated Circuits and Systems, vol. 37, no. 5, pp. 1037-1049, May 2018 (doi: 10.1109/TCAD.2017.2729464).

[12] S. Birla, N.K. Shukla, M. Pattnaik, R.K. Singh, “Analysis of the data stability and leakage power in the various SRAM cells topologies”, International Journal Engineering Science and Technology, vol. 2, no. 7, pp. 2936-2944, July 2010.

[13] R.E. Aly, M.A. Bayoumi, “Low-power cache design using 7T SRAM cell”, IEEE Trans, on Circuits and Systems II: Express Briefs, vol. 54, pp. 318-322, April 2007 (doi: 10.1109/TCSII.2006.877276).

[14] J.P. Kulkarni, K. Roy, “Ultralow-voltage process-variation-tolerant schmitt-trigger-based SRAM design”, IEEE Trans. on Very Large Scale Integration (VLSI) Systems, vol. 20, no. 2, pp. 319-332, Feb. 2012 (doi: 10.1109/TVLSI.2010.2100834).

[15] C. Sun, K. Han, X. Gong, "Performance evaluation of static random access memory (SRAM) based on negative capacitance finFET", Proceeding of the IEEE/ICICDT, pp. 1-4, Suzhou, China, June 2019 (doi: 10.1109/ICICDT.2019.8790831).

[16] D. Biolek, Z. Biolek, V. Biolkova, Z. Kolka, “Reliable modeling of ideal generic memristors via state-space transformation”, Radioengineering, vol 24, no. 2, pp. 393–407, June 2015 (doi: 10.13164/re.2015.0393).

[17] Y. Zhang, Y. Shen, X. Wang, Y. Guo, “A novel design for memristor-based or gate”, IEEE Trans. on Circuits and Systems II: Express Briefs, vol. 62, no. 8, pp. 781–785, Aug. 2015 (doi: 10.1109/TCSII.­2015­.243­5354).

[18] V. Mladenov, "A new simplified model for HfO2-based memristor", Proceeding of the IWWW/MOCAST, pp. 1-4, Thessaloniki, Greece, May 2019 (doi: 10.1109/MOCAST.2019.8741953).

[19] M.A. Bahloul, R. Naous, M. Masmoudi, "Hardware emulation of memristor based ternary content addressable memory", Proceeding of the IEEE/SSD, pp. 446-449, Marrakech, Morocco, March 2017 (doi: 10.1109/SSD.2017.8167029).

[20] A. Abubakr, A. Ibrahim, Y. Ismail, H. Mostafa, "The impact of soft errors on memristor-based memory", Proceeding of the IEEE/NGCAS, pp. 229-232, Genova, Italy, Sept. 2017 (doi: 10.1109/NGCAS.2017.72).

[21] K. Mehrabi, B. Ebrahimi, R. Yarmand, A. Afzali-Kusha, H. Mahmoodi, “Read static noise margin aging model considering SBD and BTI effects for FinFET SRAMs”, Microelectronics Reliability, vol. 65, pp.20-26, Oct. 2016 (doi: 10.1016/j.microrel.2016.07.003).