فهرس المقالات Ahmmadreza Azimian


  • المقاله

    1 - A model for enhanced heat transfer in an enclosure using Nano-aerosols
    Journal of Simulation and Analysis of Novel Technologies in Mechanical Engineering , العدد 4 , السنة 9 , بهار 2016
    In this study, the behavior of nanoparticles using a numerical model is discussed. For this study a model for the expansion in free convection heat transfer and mix in a rectangular container with dimensions of 1 × 4 cm using Nano-aerosols in the air is going when أکثر
    In this study, the behavior of nanoparticles using a numerical model is discussed. For this study a model for the expansion in free convection heat transfer and mix in a rectangular container with dimensions of 1 × 4 cm using Nano-aerosols in the air is going when copper nanoparticles, use and by changing the temperature difference between hot and cold wall, we will examine its impact on the rate of heat transfer. The simulation involves two-dimensional flow simulation and relaxed state of constant flux in free convection on the two lateral sides and on the top face of constant temperature (cold plate) at 300 K was considered And at low temperature (heat plate) in three modes 350, 400 and 450 K were compared. Temperature distribution, velocity, surface heat flux and Nusselt number during the course of our review.Finally, enhanced heat transfer in the presence of copper nanoparticles and changes in the temperature difference between warm and cold wall was observed تفاصيل المقالة

  • المقاله

    2 - Study Effect of Deformation Nanochannel Wall Roughness on The Water-Copper Nano-Fluids Poiseuille Flow Behavior
    Journal of Simulation and Analysis of Novel Technologies in Mechanical Engineering , العدد 1 , السنة 8 , زمستان 2015
    In the nanochannel flow behavior with respect to expand their applications in modern systems is of utmost importance. According to the results obtained in this study, the condition of nonslip on the wall of the nanochannel is not acceptable because in the nano dimension أکثر
    In the nanochannel flow behavior with respect to expand their applications in modern systems is of utmost importance. According to the results obtained in this study, the condition of nonslip on the wall of the nanochannel is not acceptable because in the nano dimensions, slip depends on different parameters including surface roughness. In this study, keeping the side area roughness, deformation effects on fluid flow behavior is investigated. Modeling software open source LAMMPS with equilibrium molecular dynamics simulations have been carried out. Unlike previous studies, existence fluid in laboratory conditions as water-copper nanofluids used. The results showed that rectangular was the most effective and triangular was least effective roughness on flow behavior, resulting in a rough triangular nanochannel slip occurs with more intensity.Existence roughness on the surface increases the number of oscillations in the fluid layer but amplitude near the wall is smooth to rough increased. Nanoparticles also increase the impact on the flow properties تفاصيل المقالة