A model for enhanced heat transfer in an enclosure using Nano-aerosols
الموضوعات : فصلنامه شبیه سازی و تحلیل تکنولوژی های نوین در مهندسی مکانیک
نوید قاجاری
1
(
کارشناسی ارشد، دانشکده مکانیک، دانشگاه آزاد اسلامی خمینی شهر، اصفهان، ایران.
)
داود طغرایی
2
(
استادیار، دانشکده مکانیک، دانشگاه آزاد اسلامی خمینی شهر ، اصفهان، ایران.
)
احمدرضا عظیمیان
3
(
استاد، دانشکده مکانیک، دانشگاه آزاد اسلامی خمینی شهر ، اصفهان، ایران.
)
الکلمات المفتاحية: Convective heat transfer, Nano-fluid, Nano-Particle, Aerosol,
ملخص المقالة :
In this study, the behavior of nanoparticles using a numerical model is discussed. For this study a model for the expansion in free convection heat transfer and mix in a rectangular container with dimensions of 1 × 4 cm using Nano-aerosols in the air is going when copper nanoparticles, use and by changing the temperature difference between hot and cold wall, we will examine its impact on the rate of heat transfer. The simulation involves two-dimensional flow simulation and relaxed state of constant flux in free convection on the two lateral sides and on the top face of constant temperature (cold plate) at 300 K was considered And at low temperature (heat plate) in three modes 350, 400 and 450 K were compared. Temperature distribution, velocity, surface heat flux and Nusselt number during the course of our review.Finally, enhanced heat transfer in the presence of copper nanoparticles and changes in the temperature difference between warm and cold wall was observed
[1] Murshed S.M.S., Leong K.C., and Yang C., Thermophysical and electrokinetic properties of Nanofluids – A critical review, Applied Thermal Engineering, Vol. 28, 2008, pp. 2109-2125.
[2] Kreidenweis S.M, Asa Awuku A, Aerosol Hygroscopicity: Particle Water Content and Its Role in Atmospheric Processes,Reference Module in Earth Systems and Environmental SciencesTreatise on Geochemistry (Second Edition), Vol. 5, 2014, pp. 331-361.
[3] Masuda H., Ebata A., Teramae K., Hishinuma N., Alternation of thermal conductivity and viscosity of liquid by dispersing ultra-fine particles (Dispersion of g-Al2O3, SiO2, and TiO2 ultra-fine particles(, Netsu Bussei, 7, 1993, pp. 227.233.
[4] Schild A, Gutsch A, M¨uhlenweg H, Pratsinis, S.E, Simulation of nanoparticle production in premixed aerosol flow reactors byinterfacing fluid mechanics and particle dynamics, Journal of Nanoparticle Research,Vol. 10, 1991, pp. 305-315.
[5] Akbar M.K, Rahman M, Ghiaasiaan S.M, Particle transport in a small square enclosure in laminar natural convection, Journal of Aerosol Science, Vol. 40, 2009, pp.747-761.
[6] Pommerenck J, Alanazi Y, Gzik T, Vachkov R, Hackleman D.E, Recovery of a multicomponent, single phase aerosol with a difference in vapor pressures entrained in a large air flow, Journal. Chem. Thermodynamics, Vol. 46, 2012, pp. 109-115.
[7] Lee S., Choi S.U.S., Li S., Eastman J.A., Measuring thermal conductivity of fluids containing oxid nanoparticles, Journal of heat transfer, Vol. 121, 1999, pp. 280.289.
[8] Zeinali Heris S., Kazemi-Beydokhti A., Noie S.H., Rezvan S., Numerical study on convective heat transfer of Al2O3/water, CuO/water, Cu/water nanofluids through square crass-section duct in laminar flow, Engineering Applications of Computational Fluid Mechanics, Vol. 6, 2012, pp. 1-14.
[9] Santra A.K, Sen S. and Chakraborty N, Study of heat transfer due to laminar flow of copper–water nanofluid through two isothermally heated parallel plates, International Journal of Thermal Sciences, Vol. 48, 2009, pp. 391-400.
[10] Shukla K.N., Solomon A.B., Pillai B.C., Ruba Singh B.J., Kumar S.S., Thermal performance of heat pipe with suspended nano-particles, Heat Mass Transfer, Vol. 46, 2012, pp. 1913-1920.
[11] Buongiorno J., Convective transport in nano fluids, Journal of Heat Transfer-Transactions of the ASME, Vol. 128, 2006, pp. 240-250.
[12] Hakan F.O., Abu-Nada E., Numerical study of natural convection in partially heated rectangular enclosures filled with nanofluids, International Journal of Heat and Fluid Flow. Vol. 29, 2008, pp. 1326.1336.
[13] Pallares J.N., Grau F.X., Particle dispersion in a turbulent natural convection channel flow, Journal of Aerosol Science, Vol. 43, 2012, pp. 45-56.
[14] Hudson A., Computational Analysis to Enhance Laminar Flow Convective Heat Transfer Rate in an Enclosure Using Aerosol Nanofluids, Electronic Theses & Dissertations, Vol. 12, 2013,pp. 10-48.
[15] Ounis H., Ahmadi G., Mclaughlin J.B., Dispersion and Deposition of Brownian Particles from Point Sources in a Simulated Turbulent Channel Flow, Journal of Colloid and Interface Science, Vol. 147, 1991, pp. 233-250.
[16] Talbot L., Cheng R.K., Schefer R.W., Willis D.R., Thermophoresis of Particles in a Heated Boundary Layer, Journal of. Fluid Mechanics, Vol. 101, 1980, pp. 737-758.
[17] Cheng P, Two-Dimensional Radiating Gas Flow by a Moment Method, AIAA Journal, Vol. 2, 1964, pp. 1662-1664.
