Improving the energy efficiency of existing residential buildings by applying passive and cost-effective solutions in the Hot and humid region of Iran

الموضوعات : Space Ontology International Journal

Amin Mohammadi ¹ , Joseph Daraio ²

1 - Department of Architectural Engineering, Faculty of Art and Architecture, Persian Gulf University, Bushehr, Iran. 7516913817
2 - Faculty of Engineering and Applied Science, Memorial University of Newfoundland (MUN), St. John‘s, NL, Canada.

تاريخ الإرسال : 24 الأربعاء , ذو القعدة, 1441 تاريخ التأكيد : 18 الثلاثاء , رجب, 1442 تاريخ الإصدار : 16 الثلاثاء , ربيع الثاني, 1442

الکلمات المفتاحية: Energy efficiency, hot and humid climate, Cost-Effectiveness, Energy simulation, passive Solutions,

ملخص المقالة :

This paper aims to investigate the improvement of the energy efficiency of typical apartment buildings in the hot and humid region of Iran by applying passive and cost-effective solutions. For this purpose, a residential building, that reflects the current typology, is selected in Bushehr, Iran, and its annual energy consumption is explored using electric and gas bills. Then, a primary and calibrated model of the building is made using a real occupancy schedule and hourly weather data of Bushehr in Design Builder Software to simulate its energy performance. Considering the architectural design of the baseline model and using passive solutions (including low-E glazing, thermal insulation of external walls, roof and ceilings, and pre-heating of domestic hot water), a developed model is made. The simulation results indicate that the annual carbon dioxide emission and energy consumption of the developed model is reduced by 18.7% and 20%, respectively. These passive solutions can be used to improve the energy efficiency of existing buildings to achieve low Carbon buildings and neighborhoods in this part of Iran. This study also proposed a new reference for the annual energy consumption of low-energy houses in the hot and humid area of Iran and the Persian Gulf region (75-76 kWh/m2/Year). Moreover, the economic analysis in this study demonstrates that the above-mentioned passive solutions will be cost-effective if the government subsidies for the residential buildings’ energy use are eliminated in this region.

المصادر:

1.  Abazari, T., & Mahdavinejad, M. (2017). Integrated Model for Shading and Airflow Window in BSk. Energy Procedia, 122, 571-576. doi:https://doi.org/10.1016/j.egypro.2017.07.423


2. Aghamolaei, R. (2019). Evaluation of Supply and Demand in Building Energy Performance: Application of Retrofit Scenarios in Residential Building. Energy Engineering, 116(1), 60-79. doi:10.1080/01998595.2019.12043339


3. Albatayneh, A., Alterman, D., Page, A., & Moghtaderi, B. (2018). The Impact of the Thermal Comfort Models on the Prediction of Building Energy Consumption. Sustainability, 10(10). doi:10.3390/su10103609


4. Aldossary, N., Rezgui, Y., & Kwan, A. (2017). Establishing domestic low energy consumption reference levels for Saudi Arabia and the Wider Middle Eastern Region. Sustainable Cities and Society, 28, 265-276. doi:10.1016/j.scs.2016.09.015


5. Alvand, M., Gholami, Z., Ferrara, M., & Fabrizio, E. (2017). Assessment of Cost Optimal Solutions for High Performance Multi-family Buildings in Iran. Energy Procedia, 111, 318-327. doi:https://doi.org/10.1016/j.egypro.2017.03.102


6. Ameer, B., & Krarti, M. (2016). Impact of subsidization on high energy performance designs for Kuwaiti residential buildings. Energy and Buildings, 116, 249-262. doi:10.1016/j.enbuild.2016.01.018


7. ASHRAE. (2009). Fundamentals; American society of Heating, Refrigerating and Air-Conditioning Engineers. In. Atlanta, USA: ASHRAE.


8. Balali, A., Hakimelahi, A., & Valipour, A. (2020). Identification and prioritization of passive energy consumption optimization measures in the building industry: An Iranian case study. Journal of Building Engineering, 30, 101239. doi:https://doi.org/10.1016/j.jobe.2020.101239


9. Brahmand Zadeh, D. R. G., Z. (2014). Investigating the trend of changes in power consumption in different sectors during the period from 2001 to 2012. Srtc-amar, 2, 29-33 (In persian).


10. Burgett, J., Chini, A., & Oppenheim, P. (2013). Specifying residential retrofit packages for 30 % reductions in energy consumption in hot–humid climate zones. Energy Efficiency, 6(3), 523-543. doi:10.1007/s12053-012-9190-6


11. Chartered Institution of Building Services, E. (2006). Environmental design : CIBSE guide A. London: CIBSE.


12. Chuan-Rui, Y., Han-Sen, G., Qian-Cheng, W., & Rui-Dong, C. (2020). Revealing the Impacts of Passive Cooling Techniques on Building Energy Performance: A Residential Case in Hong Kong. Applied Sciences, 10(12), 4188. doi:http://dx.doi.org/10.3390/app10124188


13. EIA. (2016). International Energy Outlook 2016. U.S. Energy Information Administration.


14. Expert Working Groupe and Editor, E. (2019). Price List for Buildings. (97/747815). Tehran: Planning and Budget Organization of Iran (In Persian).


15. Haase, M., & Amato, A. (2009). An investigation of the potential for natural ventilation and building orientation to achieve thermal comfort in warm and humid climates. Solar Energy, 83(3), 389-399. doi:10.1016/j.solener.2008.08.015


16. Jorissen, F., Himpe, E., Picard, D., Buso, T., Laverge, J., Boydens, W., & Helsen, L. . (2018). hybridGEOTABS project : MPC for controlling the power of the ground by integration. (J. Hogeling, Ed.). Rehva Journal, 55(3), 58–64.


17. Khodabakhsh, P., Fathi, H., & Mashayekhi, S. (2015). Achieving energy efficiency through designing eco-friendly built environment (Tehran case study). International Journal of Sustainable Building Technology and Urban Development, 6(3), 129-139. doi:10.1080/2093761X.2015.1025449


18. Kwame, A. B. O., Troy, N. V., & Hamidreza, N. (2020). A Multi-Facet Retrofit Approach to Improve Energy Efficiency of Existing Class of Single-Family Residential Buildings in Hot-Humid Climate Zones. Energies, 13(5). doi:10.3390/en13051178


19. Mohammadi, A., Saghafi, M., Tahbaz, M., & Nasrollahi, F. (2018). The study of climate-responsive solutions in traditional dwellings of Bushehr City in Southern Iran. Journal of Building Engineering, 16, 169-183. doi:10.1016/j.jobe.2017.12.014


20. Mohammadi, A., Saghafi, M. R., Tahbaz, M., & Nasrollahi, F. (2017). Effects of Vernacular Climatic Strategies (VCS) on Energy Consumption in Common Residential Buildings in Southern Iran: The Case Study of Bushehr City. Sustainability, 9(11). doi:10.3390/su9111950


21. Monstvilas, E., Stankevičius, V., Karbauskaitė, J., Burlingis, A., & Banionis, K. (2012). Hourly Calculation Method of Building Energy Demand for Space Heating and Cooling Based on Steady-State Heat Balance Equations. Journal Of Civil Engineering And Management, 18(3), 356-368. doi:10.3846/13923730.2012.689994


22. National Building Regulatory Office, M. o. R. a. U. D. (2011). National Building Regulations- Topic 19: Energy Saving in Buildings. Tehran: Iranian Development Publication (In Persian).


23. Nooraei, M., Littlewood, J., & Evans, N. (2013). Passive Cooling Strategies for Multi-storey Residential Buildings in Tehran, Iran and Swansea, UK. Paper presented at the Sustainability in Energy and Buildings, Berlin, Heidelberg.


24. Pacheco-Torgal, F. (2017). Chapter 1 - Introduction to Cost-Effective Energy-Efficient Building Retrofitting. In F. Pacheco-Torgal, C.-G. Granqvist, B. P. Jelle, G. P. Vanoli, N. Bianco, & J. Kurnitski (Eds.), Cost-Effective Energy Efficient Building Retrofitting (pp. 1-20): Woodhead Publishing.


25. Rehman, H. (2015). Steady State Experimental Analysis of Various Solar Insulation Materials and Techniques for Buildings in Climatic Condition of Ras Al Khaimah, UAE. Energy Procedia, 75, 1419-1424. doi:10.1016/j.egypro.2015.07.241


26. Rotimi, A., Bahadori-Jahromi, A., Mylona, A., Godfrey, P., & Cook, D. (2017). Estimation and Validation of Energy Consumption in UK Existing Hotel Building Using Dynamic Simulation Software. Sustainability, 9(8), 1391-undefined. doi:10.3390/su9081391


27. Sadineni, S. B., Madala, S., & Boehm, R. F. (2011). Passive building energy savings: A review of building envelope components. Renewable and Sustainable Energy Reviews, 15(8), 3617-3631. doi:https://doi.org/10.1016/j.rser.2011.07.014


28. Sağlam, N., Yılmaz, A. Z., Becchio, C., & Corgnati, S. (2017). A comprehensive cost-optimal approach for energy retrofit of existing multi-family buildings: Application to apartment blocks in Turkey. Energy and Buildings, 150, 224-238. doi:10.1016/j.enbuild.2017.06.026


29. Silvero, F., Montelpare, S., Rodrigues, F., Spacone, E., & Varum, H. (2018). Energy retrofit solutions for heritage buildings located in hot-humid climates. Procedia Structural Integrity, 11, 52-59. doi:10.1016/j.prostr.2018.11.008


30. Silvero, F., Rodrigues, F., & Montelpare, S. (2019). A Parametric Study and Performance Evaluation of Energy Retrofit Solutions for Buildings Located in the Hot-Humid Climate of Paraguay—Sensitivity Analysis. Energies, 12(3), 427-undefined. doi:10.3390/en12030427


31. reference, E. (2007). Heating systems in buildings-Method for calculation of system energy requirements and system efficiencies-Part 3-1 Domestic hot water systems, characterisation of needs (tapping requirements). In CEN/TC 228: Technical Committee CEN/TC 228.


32. Sun, X., Gou, Z., & Lau, S.-Y. (2018). Cost-effectiveness of active and passive design strategies for existing building retrofits in tropical climate: Case study of a zero energy building. Journal of Cleaner Production, 183, 35-45. doi:10.1016/j.jclepro.2018.02.137


33. Sun, X., Gou, Z., & Lau, S. S.-Y. (2018). Cost-effectiveness of active and passive design strategies for existing building retrofits in tropical climate: Case study of a zero energy building. Journal of Cleaner Production, 183, 35-45. doi:https://doi.org/10.1016/j.jclepro.2018.02.137


34. Tahsildoost, M., & Zomorodian, Z. (2020). Energy, carbon, and cost analysis of rural housing retrofit in different climates. Journal of Building Engineering, 30, 101277. doi:https://doi.org/10.1016/j.jobe.2020.101277


35. Tan, Y., Liu, G., Zhang, Y., Shuai, C., & Shen, G. (2018). Green retrofit of aged residential buildings in Hong Kong: A preliminary study. Building and Environment, 143, 89-98. doi:10.1016/j.buildenv.2018.06.058


36. Wu, J., Guo, S., Huang, H., Liu, W., & Xiang, Y. (2018). Information and Communications Technologies for Sustainable Development Goals: State-of-the-Art, Needs and Perspectives. IEEE Communications Surveys & Tutorials, 20, 2389-2406. doi:10.1109/COMST.2018.2812301


37. Wu, J., Rangan, S., & Zhang, H. (2012). Green communications theoretical fundamentals, algorithms and applications. Boca Raton, FL: Boca Raton, FL : CRC Press.


38. Yudelson, J. (2010). Greening existing buildings: McGraw-Hill New York.

  Online References

1. Brebbia, C. A. B., E. (2011). Sustainable Development and Planning V.  Retrieved 8/8/2019 https://www.witpress.com/books/978-1-84564-544-1


2. DesignBuilderLtd. (2019). EnergyPlus simulation key features.  Retrieved 10/11/2019, from DesignBuilder Wesite https://designbuilder.co.uk/simulation


3. Hourly Weather Data of Bushehr. (2018).  Retrieved 8/18/2018, from Islamic Republic of Iran Meteorological Organization (IRIMO)- Meteorological data request system https://data.irimo.ir/


4. IDA, T. W. B. I. (2019). CO2 Emissions (Metric Tons Per Capita).  Retrieved 8/8/2019 https://data.worldbank.org/indicator/EN.ATM.CO2E.PC


5. MOP. (2018). Electricity Tariffs and  their general conditions.  Retrieved 9/7/2019, from Ministry of Power- Islamic Rebuplic of Iran http://tariff.moe.gov.ir/


6. NGC. (2018). Household gas tariffs.  Retrieved 9/7/2019, from Tariffs and Contracts Affairs- National Gas company- Islamic Republic of Iran http://mgd.nigc.ir/Portal/Home/