Process capability improvement through DMAIC for aluminum alloy wheel machining
الموضوعات :G. V. S . S. Sharma 1 , P. Srinivasa Rao 2 , B. Surendra Babu 3
1 - Department of Mechanical Engineering, GMR Institute of Technology, Rajam, A.P., 532127, India
2 - Department of Mechanical Engineering, Centurion University, Parlakhemundi, Odisha, 761211, India
3 - Department of Industrial Engineering, GITAM University, Visakhapatnam, A.P., 530045, India
الکلمات المفتاحية: analyze, Measure, to, Alloy wheel . CTQ (critical, quality) characteristic . DMAIC (define, improvecontrol) . Ishikawa diagram . PFMEA (process failure modes and effects analysis) . Control charts,
ملخص المقالة :
This paper first enlists the generic problems of alloy wheel machining and subsequently details on the process improvement of the identified critical-to-quality machining characteristic of A356 aluminum alloy wheel machining process. The causal factors are traced using the Ishikawa diagram and prioritization of corrective actions is done through process failure modes and effects analysis. Process monitoring charts are employed for improving the process capability index of the process, at the industrial benchmark of four sigma level, which is equal to the value of 1.33. The procedure adopted for improving the process capability levels is the define-measure-analyze-improve-control (DMAIC) approach. By following the DMAIC approach, theCp,CpkandCpmshowed signs of improvement from an initial value of 0.66, −0.24 and 0.27, to a final value of 4.19, 3.24 and 1.41, respectively.
