Paktinat.Hossein
Finite Element Analysis and Experimental Investigation on the Conventional and Vibration Assisted Drilling
[
Vol.6,
Issue
4
- AutumnYear
2017]
Pandey.Ankit
Analysis of Wrinkled Composite Membrane of Inflatable Antenna Using Shape Memory Alloy
[
Vol.11,
Issue
4
- AutumnYear
2022]
parsafar.mahdis
The Effect of the Third Element on Corrosion Behavior and Phase Structure of Fe35Mn Alloy Fabricated by Spark Plasma Sintering (SPS)
[
Vol.7,
Issue
4
- AutumnYear
2018]
pasamehr.fatemeh
Prioritization of Lean-production Components with Fuzzy Network Analysis: A Case Study (Sam Electric Co.)
[
Vol.8,
Issue
1
- WinterYear
2019]
Paygane.gholamhasan
Numerical and Experimental Study of Residual Stress Measurement and Thickness Distribution of T-shape Steel Tube Produced by Tube Hydroforming
[
Vol.8,
Issue
1
- WinterYear
2019]
Payganeh.Gholamhasan
Computer Aided Design of the Tube Hydroforming and Dual Hydroforming Processes
[
Vol.4,
Issue
4
- AutumnYear
2015]
pishkar.iman
Exploring the Impact of Rubber Friction in the Localized Pipe Hollowing Process Using a Rubber Pad
[
Vol.13,
Issue
4
- AutumnYear
2024]
Poorshaban.Reza
The Effect of Power, Maximum Cutting Speed and Specific Point Energy on the Material Removal Rate and Cutting Volume Efficiency in CO2 Laser Cutting of Polyamide Sheets
[
Vol.9,
Issue
3
- SummerYear
2020]
Pouladsaz.Kamran
Machinability evaluation of Titanium alloy in Laser Assisted Turning
[
Vol.2,
Issue
3
- SummerYear
2013]
pourkamali anaraki.ali
Comparing the Performance of Composite Polymer Structure and Single Polymer Material by Manufacturing Artificial Hand using 3D Printing Method
[
Vol.13,
Issue
3
- SummerYear
2024]
pourkamali.ali
Comparing the Performance of Composite Polymer Structure and Single Polymer Material by Manufacturing Artificial Hand using 3D Printing Method
[
Vol.13,
Issue
3
- SummerYear
2024]
Poursafar.Amin
Analysis of Surface Roughness and Micro-hardness in Roller Burnishing of Aluminum Alloy 6061
[
Vol.8,
Issue
3
- SummerYear
2019]
Poursina.Mehrdad
Desiging, Part Selecting and Fabrication Procedure of the Vaccum Section of a Leaf Vacuum Shredder Machine
[
Vol.2,
Issue
2
- SpringYear
2013]