Experimental Investigation of Pool Boiling of Single Wall Carbon Nanotubes (SWCNTs) with Different Grooved Surfaces
Subject Areas : Mechanical EngineeringAmir Vasei Moghadam 1 , Hamid Reza Goshayeshi 2
1 - Department of Mechanical Engineering
Islamic Azad University, Mashhad Branch, Mashhad, Iran
2 - Department of Mechanical Engineering
Islamic Azad University, Mashhad Branch, Mashhad, Iran
Keywords: Single Wall Carbon Nanotube, Pool Boiling, Grooved Surface, Heat Transfer Coefficient,
Abstract :
The enhancements in boiling heat transfer can bring immediate benefits to improve the efficiency and cost of heat energy transfer. In this study, heat transfer coefficient in pool boiling of single wall carbon nanotube-water (SWCNTs) at a concentration of 0. 05, 0. 1 and 0. 15 vol. % on smooth and grooved surfaces has been investigated experimentally at atmospheric pressure. The effect of some shapes namely circular groove, square groove and straight groove on the boiling heat transfer has been also investigated. The experimental results indicated that making different grooved surfaces and also using (SWCNTs)-water enhanced the boiling heat transfer coefficient. The highest increase in heat transfer coefficient was seen in circular grooved, which is 76% higher than the base fluid water on the smooth surface. The heat flux has been changed from 0 to 140 kW/m2. By comparing the results, the circular groove with 0.15% concentration of SWCNTs has higher heat transfer coefficient for the boiling heat transfer. Based on pool boiling surfaces, a new type of grooves pool pooling surface was designed and constructed, which is consisted of inclined circular groove at angle of 45°. Outcome of the present work definitely indicates that the inclination of the circular groove could be excellent option for the increasing of pool boiling heat transfer. Cornwel-Houston correlation has been modified to take care of the effect of grooved surfaces for correlating the Nusselt number as a function of Reynolds number and Prandtl number in pool boiling. This new correlation agrees with the experimental data from the augmented surface satisfactory.
[1] Wen, D., Ding. Y., Experimental Investigation into the Pool Boiling Heat Transfer of Aqueous Based C-Alumina Nanofluids, J. Nanopart. Res. Vol. 7, No. 2, 2005, pp. 265–274.
[2] Wen, D., Ding, Y., Experimental Investigation into the Pool Boiling Heat Transfer of Aqueous Based γ-Alumina Nanofluids, J. of Nanoparticle Research, Vol. 7, No. 2, 2005, pp. 265-274.
[3] Ham, J., Kim, H., Shin, Y., and Cho, H., Experimental Investigation of Pool Boiling Characteristics in Al2O3 Nanofluid According to Surface Roughness and Concentration, Int. J. of Thermal Sciences, Vol. 114, 2017, pp. 86-97.
[4] Bang, I. C., Chang, S. H., Boiling Heat Transfer Performance and Phenomena of Al2O3–Water Nanofluids from A Plain Surface in a pool, Int. J. Heat Mass Transf. Vol. 48, No. 12, 2005, pp. 2407–2419.
[5] Cieslinski, J. T., Kaczmarczyk, T. Z., Pool Boiling of Water-Al2O3 and Water-Cu Nanofluids on Horizontal Smooth Tubes, Nanoscale Research Letters, Vol. 6, No. 1, 2011, pp. 220-221.
[6] Kwark, S. M., Kumar, R., Moreno, G., Yoo, J., and Yoo, S. M., Pool Boiling Characteristics of Low Concentration Nanofluids, Int. J. Heat and Mass Transfer, Vol. 53, No. 5, 2010, pp. 972-981.
[7] Karimipour, A., New Correlation for Nusselt Number of Nanofluid with Ag/Al2O3/Cu Nanoparticles in a Microchannel Considering Slip Velocity and Temperature Jump by Using Lattice Boltzmann Method, Int. J. Thermal Science, Vol. 91, 2015, pp. 146-156.
[8] Vafaei, S., Nanofluid Pool Boiling Heat Transfer Phenomenon, Vol. 277, 2015, pp. 181-192
[9] Heris, S. Z., Experimental Investigation of Pool Boiling Characteristics of Low-Concentrated CuO/Ethylene Glycol–Water Nanofluids, Int. Communications in Heat and Mass Transfer, Vol. 38, No. 10, 2011, pp. 1470 -1473.
[10] Sarafraz, M. M., Hormozi, F., Pool Boiling Heat Transfer to Dilute Copper Oxide Aqueous Nanofluids, Int. J. of Thermal Sciences, Vol. 90, 2015, pp. 224-237.
[11] Umesh, V., Raja, B., A Study on Nucleate Boiling Heat Transfer Characteristics of Pentane and CuO-Pentane Nonofluid on Smooth and Milled Surfaces, Thermal Fluid Sci, Vol. 64, 2015, pp. 23-29.
[12] Dehghani Ashkezari, E., Salimpour, M. R., Effect of Groove Geometry on Pool Boiling Heat Transfer of Water-Titanium Oxide Nonofluid, J. of Heat and Mass Transfer, Vol. 11, 2018.
[13] Das, S., Saha, B., and Bhaumik, S., Experimental Study of Nucleate Pool Boiling Heat Transfer of Water by Surface Functionalization with Crystalline TiO2 Nanostructure, Applied Thermal Engineering, Vol. 113, 2017, pp. 1345-1357.
[14] Ali, H. M., Generous, M. M., Ahmad, F., and Irfan, M., Experimental Investigation of Nucleate Pool Boiling Heat Transfer Enhancement of TiO2-Water Based Nanofluids, Applied Thermal Engineering, Vol. 113, 2017, pp. 1146-1151.
[15] Amiri, A., Shanbedi, M., Amiri, H., Heris, S. Z., Kazi, S. N., Chew, B. T., and Eshghi, H., Pool Boiling Heat Transfer of CNT/water Nanofluids, Applied Thermal Engineering, Vol. 71, No. 1, 2014, pp. 450-459.
[16] Kathiravan, R., Kumar, R., Gupta, A., Chandra, R., and Jain, P. K., Pool Boiling Characteristics of Multiwall Carbon Nanotube (CNT) Based Nanofluids over a Flat Plate Heater, Int. J. of Heat and Mass Transfer, Vol. 54, No. 5, 2011, pp. 1289-1296.
[17] Shahmoradi, Z., Etesami, N., and Nasr Esfahani, M., Pool Boiling Characteristics of Nanofluid on Flat Plate Based on Heater Surface Analysis, Int. Communication in Heat and Mass Transfer, Vol. 47, 2013, pp. 113-120.
[18] Das, S. K., Putra, N., and Roetzel, W., Pool Boiling of Nanofluids on Horizontal Narrow Tubes, International J. of Multiphase Flow, Vol. 29, No. 8, 2003, pp. 1237-1247.
[19] Das, S., Saha, B., and Bhaumik, S., Experimental Study of Nucleate Pool Boiling Heat Transfer of Water by Surface Functionalization with SiO2 Nanostructure, Experimental Thermal and Fluid Science, Vol. 81, 2017, pp. 454-465.
[20] Qu, Z. G., Xu, Z., Zhao, C., and Tao, W., Experimental Study of Pool Boiling Heat Transfer on Horizontal Metallic Foam Surface with Crossing and Single- Directional V- Shaped Grooved in Saturated Water, Int. J. of Multiphase Flow, Vol. 41, 2012, pp. 44-55.
[21] Quan, X., Gao, M., Cheng, P., and Li, J., An Experimental Investigation of Pool Boiling on Smooth/Rib Surfaces Under an Electric Field, Int. J. of Heat and Mass Transfer, Vol. 85, 2015, pp. 595-606.
[22] Das, A. K., Das, P. K., and Saha, P., Nucleate Boiling of Water from Plain and Structured Surfaces, Experimental Thermal and Fluid Science, Vol. 31, No. 8, 2007, pp. 967-977,
[23] Das, A. K., Das, P. K., and Saha, P., Performance of Different Structured Surfaces in Nucleate Pool Boiling, Applied Thermal Engineering, Vol. 29, No. 17, 2009, pp. 3643-3653.
[24] Goshayeshi, H. R., Missenden, J. F., The Investigation of Cooling Tower Packing in Various Arrangements, J. of Applied Thermal Engineering, Vol. 20, 2000, pp. 69-80.
[25] Moffat, R. J., Describing the Uncertainties in Experimental Results, Experimental Thermal and Fluid Science, Vol. 1, No. 1, 1988, pp. 3-17.
[26] Passos, C. J., Reinaldo, R. F., Analysis of Pool Boiling Within Smooth and Grooved Tubes, Experimental Thermal and Fluid Science, Vol. 22, 2000, pp. 35-44.
[27] Lay, K. K., Ong, J. S., Young, K. Y., Tan, M. K., Hung, Y. M., Nucleate Pool Boiling Enhancement by Ultrafast Water Permeation in Graphene-Nanostructure. Vol. 101, 2019, pp. 26-34.
[28] Cornwell, M., Houston, S. D., Nucleate Pool Boiling on Horizontal Tubes: A Convective-Based Correlation, Int. J. of Heat and Mass Transfer, Vol. 37(suppl.1) 1994, pp. 303-309.