Analysis of airflow on an airfoil using electro-hydrodynamic actuators
Subject Areas : Journal of Simulation and Analysis of Novel Technologies in Mechanical EngineeringMohammad Bigdeli 1 , Alireza Ansari 2 , Gholamreza Tathiri 3 , Vahid Monfared 4
1 - Department of Mechanical Engineering, Zanjan Branch, Islamic Azad University, Zanjan, Iran.
2 - Department of Mechanical Engineering, Zanjan Branch, Islamic Azad University, Zanjan, Iran
3 - IAUZ
4 - IAUZ
Keywords: Flow separation, Plasma (DBD), Airflow, Electro-hydrodynamics, Stall Angle,
Abstract :
Nowadays the application of plasma actuators has drawn much attention due to the possibility of creating a volumetric force and, therefore, controlling airflow around rigid bodies. These actuators are among common flow control methods because of availability, lack of need for special repairs, very short response time, and low power consumption. The aim of this study is to reduce the flow separation region and delay the stall angle. Therefore, the airflow over a NACA 0012 airfoil and with a Reynolds number of 1.4×10^6 was simulated using Spalart-Allmaras turbulence model. In the first step, the lift coefficients in the plasma-off mode were investigated at different angles. The stall angle of attack was shown to be 15°. Then, the lift coefficients and the stall angle for different Reynolds numbers were compared. In the second step, the plasma (DBD) actuator was defined using UDF code in Ansys Fluent software as the body force exerted on the airfoil. Plasma activation led to an increase in the lift coefficients at different angles compared to the plasma-off mode. Subsequently, it was shown that the plasma actuator minimizes the flow separation area on the airfoil. Defining this actuator at an optimal position at a constant RE of 1.4×10^6 on a NACA 0012 airfoil where flow separation occurs changed the stall angle of the airfoil from 15° under normal conditions to 19°. The results of the lift coefficient with the help of plasma actuators showed that the airflow on the airfoil is well controlled at sensitive attack angles.
[1] Malik, M., Weinstein, L., & Hussaini, M. (1983, January). Ion wind drag reduction. In 21st Aerospace Sciences Meeting (p. 231).
[2] Singh, K. P., Roy, S., & Gaitonde, D. V. (2006). Study of control parameters for separation mitigation using an asymmetric single dielectric barrier plasma actuator. Plasma Sources Science and Technology, 15(4), 735.
[3] Forte, M., Jolibois, J., Pons, J., Moreau, E., Touchard, G., & Cazalens, M. (2007). Optimization of a dielectric barrier discharge actuator by stationary and non-stationary measurements of the induced flow velocity: application to airflow control. Experiments in fluids, 43(6), 917-928.
[4] Vlad, M., & Spineanu, F. (2015). Evolution of plasma turbulence beyond the quasilinear regime; a semi-analytical study. Romanian Reports in Physics, 67(3), 1074-1086.
[5] Diplasu, C., Giubega, G., Ungureanu, R., Cojocaru, G., Serbanescu, M., Marcu, A., & Zamfirescu, M. (2021). Commissioning experiment on laser-plasma electron acceleration in supersonic gas jet at cetal-pw laser facility. Romanian Reports in Physics, 73, 401.
[6] Šerá, B., Vanková, R., Roháček, K., & Šerý, M. (2021). Gliding Arc Plasma Treatment of Maize (Zea mays L.) Grains Promotes Seed Germination and Early Growth, Affecting Hormone Pools, but Not Significantly Photosynthetic Parameters. Agronomy, 11(10), 2066.
[7] Ramirez, C., Hauser, A. D., Vucic, E. A., & Bar-Sagi, D. (2019). Plasma membrane V-ATPase controls oncogenic RAS-induced macropinocytosis. Nature, 576(7787), 477-481.
[8] Anderson Jr, J. D. (2010). Fundamentals of aerodynamics. Tata McGraw-Hill Education.
[9] Castellanos, A. (Ed.). (1998). Electrohydrodynamics (Vol. 380). Springer Science & Business Media..
[10] Nagaraja, S., Yang, V., & Adamovich, I. (2013). Multi-scale modelling of pulsed nanosecond dielectric barrier plasma discharges in plane-to-plane geometry. Journal of Physics D: Applied Physics, 46(15), 155205.
[11] Babou, Y., Martin, E. N., & Peña, P. F. (2017, July). Simple body force model for Dielectric Barrier Discharge plasma actuator. In Proceedings of the 7th European Conference for Aeronautics and Aerospace Sciences (EUCASS), Milan, Italy (pp. 3-6).
[12] Critzos, C. C., Heyson, H. H., & Boswinkle, R. W. (1955). Aerodynamic characteristics of NACA 0012 airfoil section at angles of attack from 0 to 180 degrees. National Advisory Committee for Aeronautics.
[13] Winslow, J., Otsuka, H., Govindarajan, B., & Chopra, I. (2018). Basic understanding of airfoil characteristics at low Reynolds numbers (10 4–10 5). Journal of Aircraft, 55(3), 1050-1061.
[14] Malhotra, A., Gupta, A., & Kumar, P. (2017). Study of static stall characteristics of a NACA 0012 aerofoil using turbulence modeling. In Innovative Design and Development Practices in Aerospace and Automotive Engineering (pp. 369-378). Springer, Singapore.
[15] Barnard, R. H., & Philpott, D. R. (2010). Aircraft flight: a description of the physical principles of aircraft flight. Pearson education.
[16] Pope, S. B., & Pope, S. B. (2000). Turbulent flows. Cambridge university press.
[17] Mathieu, J. M., & Scott, J. F. (2000). Turbulent flows.
[18] Eleni, D. C., Athanasios, T. I., & Dionissios, M. P. (2012). Evaluation of the turbulence models for the simulation of the flow over a National Advisory Committee for Aeronautics (NACA) 0012 airfoil. Journal of Mechanical Engineering Research, 4(3), 100-111.
[19] Spalart, P., & Allmaras, S. (1992, January). A one-equation turbulence model for aerodynamic flows. In 30th aerospace sciences meeting and exhibit (p. 439).
[20] Alipour, H., Karimipour, A., Safaei, M. R., Semiromi, D. T., & Akbari, O. A. (2017). Influence of T-semi attached rib on turbulent flow and heat transfer parameters of a silver-water nanofluid with different volume fractions in a three-dimensional trapezoidal microchannel. Physica E: Low-Dimensional Systems and Nanostructures, 88, 60-76.
[21] Akbari, O. A., Toghraie, D., & Karimipour, A. (2016). Numerical simulation of heat transfer and turbulent flow of water nanofluids copper oxide in rectangular microchannel with semi-attached rib. Advances in Mechanical Engineering, 8(4), 1687814016641016.
[22] Rezaei, O., Akbari, O. A., Marzban, A., Toghraie, D., Pourfattah, F., & Mashayekhi, R. (2017). The numerical investigation of heat transfer and pressure drop of turbulent flow in a triangular microchannel. Physica E: Low-dimensional Systems and Nanostructures, 93, 179-189.
[23] Pourfattah, F., Motamedian, M., Sheikhzadeh, G., Toghraie, D., & Akbari, O. A. (2017). The numerical investigation of angle of attack of inclined rectangular rib on the turbulent heat transfer of Water-Al2O3 nanofluid in a tube. International Journal of Mechanical Sciences, 131, 1106-1116.
[24] Parsaiemehr, M., Pourfattah, F., Akbari, O. A., Toghraie, D., & Sheikhzadeh, G. (2018). Turbulent flow and heat transfer of Water/Al2O3 nanofluid inside a rectangular ribbed channel. Physica E: Low-Dimensional Systems and Nanostructures, 96, 73-84.
[25] Hosseinnezhad, R., Akbari, O. A., Afrouzi, H. H., Biglarian, M., Koveiti, A., & Toghraie, D. (2018). Numerical study of turbulent nanofluid heat transfer in a tubular heat exchanger with twin twisted-tape inserts. Journal of Thermal Analysis and Calorimetry, 132(1), 741-759.
[26] Toghraie, D. (2016). Numerical thermal analysis of water's boiling heat transfer based on a turbulent jet impingement on heated surface. Physica E: Low-Dimensional Systems and Nanostructures, 84, 454-465.
[27] Pourdel, H., Afrouzi, H. H., Akbari, O. A., Miansari, M., Toghraie, D., Marzban, A., & Koveiti, A. (2019). Numerical investigation of turbulent flow and heat transfer in flat tube. Journal of Thermal Analysis and Calorimetry, 135(6), 3471-3483.
[28] Bigdeli, M., & Monfared, V. (2020). Investigation and comparison of stall angle of airfoil naca 0012 in reynolds number of 3× 106 with k-ω sst, realizable k-ε, spalart-allmaras turbulence models. Comptes rendus de l’Académie bulgare des Sciences, 73(3).
[29] Bigdeli, M., Mohammadi, R., Bigdeli, J., & Monfared, V. (2021). Study on drag coefficient via dielectric barrier discharge (DBD) plasma actuators. Digest Journal of Nanomaterials & Biostructures (DJNB), 16(2).
[30] Monfared, V., Tathiri, G., Ansari, A., & Bigdeli, M. (2020). Reducing the Airflow Separation Region and Turbulence around the Airfoil using a Body Force. Journal of Mechanical Research and Application, 10(2), 34-47.