-
مقاله
1 - The Strain Rate Effect on Bending Properties of Basalt and Carbon Fibers Reinforced Phenolic CompositesInternational Journal of Advanced Design and Manufacturing Technology , شماره 4 , سال 5 , پاییز 2012In this study, the strain rate effect on the bending properties of fiber reinforced composites for three types of polymer composites namely phenolic resin reinforced by woven basalt fibers, woven carbon fibers, and woven basalt/ woven carbon fibers at a total volume fra چکیده کاملIn this study, the strain rate effect on the bending properties of fiber reinforced composites for three types of polymer composites namely phenolic resin reinforced by woven basalt fibers, woven carbon fibers, and woven basalt/ woven carbon fibers at a total volume fraction of approximately 35% has been determined. Flexural tests have been conducted at low range of strain rates included 0.03 min-1, 0.06 min-1 and 0.09 min-1. Specimens with identical geometry have been used in all the tests. Experimental results showed that the strain rate has a significant effect on the material response in bending. Results showed that, both the flexural modulus and the ultimate flexural strength of the three types of composites are increased with the increasing in the strain rate. Also, the bending properties of composites reinforced with woven carbon fibers are very sensitive to the strain rate during the test. پرونده مقاله -
مقاله
2 - Behavior of Lightweight Smart Sandwich Panels Subjected to Tensile and Bending Loads- An Experimental StudyInternational Journal of Advanced Design and Manufacturing Technology , شماره 59 , سال 15 , بهار 2024In this research work, sandwich composite panels made by fiber metal laminate (FML) as the facesheets and polymer foams as the core material are investigated in tensile and bending loads. To change or enhance the behaviour of sandwich panels in tensile and bending loads چکیده کاملIn this research work, sandwich composite panels made by fiber metal laminate (FML) as the facesheets and polymer foams as the core material are investigated in tensile and bending loads. To change or enhance the behaviour of sandwich panels in tensile and bending loads, shape memory alloy wires with pseudoelastic behaviour are also embedded in between FML layers in facesheets. The shape memory wires are also pre-strained in the FML facesheets of sandwich panels. To study the tensile and flexural properties of sandwich panels with smart FML facesheets three types of sandwich panels are considered and made including panels without shape memory alloy wire, panels with shape memory wires with 0% tensile pre-strain, and panels with shape memory wires with 5% tensile pre-strain for the same cross section. By placing SMA wires in the FML, the strength and stiffness of the smart sandwich specimens are increased significantly in tensile and bending loads. However, the effect of pre-straining the SMA wires is more predominant on stiffness of the specimens. The tensile and flexural toughness or energy absorption is much higher in case of the specimen with 5% pre-strained SMA wires. At the expenses of adding the SMA wires in the sandwich structures, the densities of various specimens are changed by nearly 1% to 5% for various specimens, but a significant increase in mechanical properties such as the strength and particularly the stiffness and toughness were achieved by the present lightweight smart sandwich structures. پرونده مقاله -
مقاله
3 - Experimental investigation of ballistic behavior of sandwich panel with corrugated coreJournal of Mechanical Research and Application , شماره 2 , سال 10 , زمستان 2020