Design of 0.4 V operational amplifier using low-power techniques
محورهای موضوعی : Majlesi Journal of Telecommunication DevicesSaber Izadpanah tous 1 , Mahmoud Behroozi 2 , Vahid Asadpoor 3
1 - Sadjad Institute for Higher Education
2 - Sadjad Institute for Higher Education
3 -
کلید واژه: en,
چکیده مقاله :
In this paper a low-power low-voltage CMOS operational amplifier (op amp) using sub-threshold region of MOSFET for bio-medical instrumentation operating with a 0.4 V supply is described. A two stage operational amplifier is designed and simulated using 0.18 μm CMOS technology. Two types of low-power low-voltage design techniques (a) bulk-driven (b) dynamic threshold voltage MOSFET (DTMOS) are used. With bulk-driven technique, the open loop gain is 69.88 dB, the unity gain-bandwidth (UGBW) is 87.1 kHz, CMRR obtained is 83 dB and phase margin is 88.78 degree with 10pF load. The power consumption is 1.8 μW. With DTMOS technique, the open loop gain is 83.31 dB, the unity gain-bandwidth is 758.6 kHz, CMRR obtained is 157.1 dB and phase margin is 71.5 degree with 10pF load. The power consumption is 1.8 μW. DTMOS technique provides high unity gain-bandwidth and high open loop gain as compared to bulk-driven technique.
[1] F. Assaderaghi, D. Sinitsky, S. Parke, J. Bokor, P. K. Ko, and C. Hu, “A dynamic threshold voltage MOSFET (DTMOS) for ultra-low voltage operation,” International Electron Devices Meeting, Technical Digest, pp. 809–812, 1994.
[2] F. Assaderaghi, D. Sinitsky, S. Parke, J. Bokor, P.K. Ko, Hu. Chenming, “Dynamic Threshold-Voltage MOSFET (DTMOS) for Ultra-Low Voltage VLSI,” IEEE Transaction on Electron Device, Vol. 44, No. 3, pp. 414-422, 1997.
[3] F. Assaderaghi, “DTMOS: Its derivatives and variations, and their potential applications,” International Conference on Microelectronic, pp. 9–10, 2000.
[4] H.F. Achigui, C.J.B. Fayomi, M. Sawan “A DTMOS-based 1 V op amp,” IEEE International Conference on Electronics, Circuits and systems , Vol. 1, pp. 252–255, 2003.
[5] H.F. Achigui, C.J.B. Fayomi, M. Sawan “A 1 V Low-Power Low-Noise DTMOS Based Class AB Op amp,” IEEE-NEWCAS, pp. 307–310, 2005.
[6] H.F. Achigui, C.J.B. Fayomi, and M. Sawan, “1 V DTMOS based class AB operational amplifier: Implementation and experimental results,” IEEE Journal of Solid-State Circuits, Vol. 41, No. 11, 2006.
[7] H.F. Achigui, M. Sawan, C.J.B. Fayomi, “A 1 V Fully Differential, Fully Balanced Op amp: Implementation and Experimental Results,” Analog Integrated Circuits and Signal Processing, Vol. 53, No. 1, pp.19-25, 2007.
[8] E. Kargaran, M. Sawan, Kh. Mafinezhad, H. Nabovati, “Design of 0.4V, 386nW OTA Using DTMOS Technique for Biomedical Applications,” 55th IEEE International Midwest Symposium on Circuits and Systems, pp. 270–273, 2012.
[9] A. suadet, T. Thongleam, A. Kanjanop, P. Singhanath, B. Hirunsing, W. Chuenta, V. Kasemsuwan, “A 0.8 V class-AB linear OTA using DTMOS for high-frequency applications,” 4th International Conference on Modeling, Simulation and Applied Optimization, pp. 1-5, 2011.
[10] ZhiYuan Li, MingYan Yu, JianGuo Ma, “A Novel Input Stage Based on DTMOS for Low-Voltage Low-Noise Operational Amplifier” APCCAS, pp. 1591-1594, 2006.
[11] M.Razzaghpour, A.Golmakani, “An Ultra-Low-Voltage Ultra-Low-Power OTA with Improved Gain-Bandwidth Product,” in proc. IEEE ICM, 2008.
[12] Sheng-Wen Pan, Chiung-Cheng Chuang, Chung-Huang Yang, Yu-Sheng Lai, “A Novel OTA with Dual Bulk- Driven Input Stage,” IEEE International Symposium on Circuits and Systems, pp. 2721-2724, May 2009.
[13] S. Sbaraini, A. Richelli and Zs.M. Kovacs-Vajna, “EMI susceptibility in bulk-driven Miller opamp,” Electronics Letters, Vol. 46, No. 16, August 2010.
[14] B. Razavi, Design of Analog CMOS Integrated Circuits. New York, NY: McGraw-Hill, 2001.
[15] S. Voldman, D. Hui, D. Young, R. Williams, D. Dreps, J. Howard, M. Sherony, F. Assaderaghi, G. Shahidi, “Silicon-on-insulator dynamic threshold ESD networks and active clamp circuitry”, Electrical Overstress/Electrostatic Discharge Symposium, pp. 29-40, 2000.
[16] A. Guzinski, M. Bialko, and J. C. Matheau, “Body-Driven Differential Amplifier for Application in Countinous-Time Active-C Filter,” Proceedings of the European Conference on Circuit Theory and Design, pp. 315-319, June 1987.
[17] Zuo, Liang, "Low-Voltage Bulk-Driven Amplifier Design and Its Application in Implantable Biomedical Sensors," PhD diss., University of Tennessee, 2012.
[18] G. Raikos, S. Vlassis, “0.8 V bulk-driven operational amplifier,” Analog Integrated Circuits and Signal Processing, Vol.63, No. 3, pp. 425-432, 2010.