Design of a Novel High-Reliability Step-up DC-DC Converter with ZCS Characteristics
محورهای موضوعی : Electrical EngineeringSeyed Reza Mosayyebi 1 , Mojtaba Ajoudani 2 , Ramazan TeimouriYansari 3
1 - Department of Electrical Engineering, Bandargaz Branch, Islamic Azad University, Bandargaz, Iran.
2 - Department of Electrical Engineering, Bandargaz Branch, Islamic Azad University, Bandargaz, Iran.
3 - Department of Electrical Engineering, Bandargaz Branch, Islamic Azad University, Bandargaz, Iran
کلید واژه: Photovoltaic (PV), Reliability, High Step converters, Zero Current Switching (ZCS),
چکیده مقاله :
In many applications such as photovoltaic (PV) farms, high-reliability step-up DC-DC converters have gained increasing attention. One of the issues with the power converter is the reliability problem. The high-step converters with lower-power semiconductors are more reliable. This article introduces a novel step-up DC-DC converter with zero current switching (ZCS) for semiconductor equipment. The suggested converter has only one switch and therefore is more reliable. The performance of the traditional converter and the suggested one has been investigated in the MATLAB/Simulink environment. The simulation results show that the suggested converter has a higher gain than the traditional one and when employed in a PV system, it injects more power into the network, indicating its superiority. At the same time, under similar variations in radiation and to reach the maximum power point, the suggested converter's duty cycle changes less, which shows its more suitable performance.
In many applications such as photovoltaic (PV) farms, high-reliability step-up DC-DC converters have gained increasing attention. One of the issues with the power converter is the reliability problem. The high-step converters with lower-power semiconductors are more reliable. This article introduces a novel step-up DC-DC converter with zero current switching (ZCS) for semiconductor equipment. The suggested converter has only one switch and therefore is more reliable. The performance of the traditional converter and the suggested one has been investigated in the MATLAB/Simulink environment. The simulation results show that the suggested converter has a higher gain than the traditional one and when employed in a PV system, it injects more power into the network, indicating its superiority. At the same time, under similar variations in radiation and to reach the maximum power point, the suggested converter's duty cycle changes less, which shows its more suitable performance.
[1] J.A. Pec as Lopes , N. Hatziargyriou , J. Mutale , P. Djapic , N. Jenkins, “Integrating distributed generation into electric power systems A review of drivers, challenges and opportunities,” Electric Power Systems Research, vol.77, pp. 1189–1203, 2007.
[2] F. Blaabjerg, F. Iov, T. Kerekes, and R. Teodorescu, “Trends in power electronics and control of renewable energy systems”, 14th Int. Power Electronics and Motion Control Conf. (EPE/PEMC) 1, K-1–K-19, 2010.
[3] EPIA, “Global market outlook for photovoltaics until 2013”, Eur. Photovoltaic Industry Association 1, CD-ROM , 2010.
[4] Kesraoui M, Korichi N, Belkadi A, “ Maximum power point tracker of wind energy conversion system,” Renew Energy, vol. 36, pp. 2655- 2662, 2011.
[5] Shuhui L, Timothy AH, Dawen L, Fei H, “ Integrating photovoltaic and power converter characteristics for energy extraction study of solar PV systems,” Renew Energy, vol.36, pp. 3238-3245, 2011.
[6] Rahimi, T.; Hosseini, S.H., “EMI consideration of high reliability electrical power subsystem (EPS) of satellite”, in 6th Power Electronics, Drives Systems & Technologies Conference (PEDSTC) , Tehran, Iran, pp. 412 - 417 , 2015.
[7] Rahimi, T., Yousefi Khangah, S., & Yousefi, B, “ Reduction EMI due to di/dt and dv/dt DC and AC Sides of BLDC Motor Drive”, In 5th Power Electronics, Drive Systems and Technologies Conference (PEDSTC); 5-6 Feb., Tehran, Iran, pp. 428-433, 2014.
[8] Chen, Z., Liu, S., Shi, L, “A soft switching full bridge converter with reduced parasitic oscillation in a wide load range”, IEEE Trans. Power Electron., vol. 29, pp. 801–812, 2014.
[9] Hu, X., Gong, C, “A high voltage gain dc–dc converter integrating coupled-inductor and diode–capacitor techniques”, IEEE Trans. Power Electron., vol. 29, pp. 789–800, 2014.
[10] Garth, D.R., Muldoon, W.J., Benson, G.C., Costague, E.N, “Multi-phase, 2-kilowatt, high-voltage, regulated power supply”, Proc. IEEE Power Conditioning Specialists Conf., pp. 110–116, 1971.
[11] Lin, B.-R., Hsin-Hung, L., Yei-Lang, H., “Single-phase power factor correction circuit with three-level boost converter”, Proc. IEEE Int. Symp. on Industrial Electronics, pp. 445–45, 1999.
[12] Huber, L., Jovanovic, M.M., “A design approach for server power supplies for networking applications”, Proc. IEEE Applied Power Electronics Conf. and Exposition, pp. 1163–116, 2000.
[13] Xiaogang, F., Jinjun, L., Lee, F.C. , “Impedance specifications for stable dc distributed power systems”, IEEE Trans. Power Electron., vol. 17, pp. 157–162 , 2002.
[14] Yang, P., Xu, J., Zhou, G., Zhang, S. , “ A new quadratic boost converter with high voltage step-up ratio and reduced voltage stress”, Proc. IEEE Seventh Int. Power Electronics and Motion Control Conf., pp. 1164–1168, 2012.
[15] Himmelstoss, F.A., Wurm, P.H., “ Low-loss converters with high step-up conversion ratio working at the border between continuous and discontinuous mode”, Proc. IEEE Int. Conf. on Electronics, Circuits and Systems, pp. 734–737, 2000.
[16] Zhao, Q., Lee, F.C., “ High-efficiency, high step-up dc–dc converters’, IEEE Trans.Power Electron. ”, vol. 18, pp. 65–73, 2003.
[17] Tseng, K.C., Liang, T.J., “ Novel high-efficiency step-up converter”, IEE Proc., Electr. Power Appl., vol.151, pp. 182–190, 2004.
[18] Liang, T.-J., Chen, S.-M., Yang, L.-S., Chen, J.-F., Ioinovici, A., “ Ultra-large gain step-up switched-capacitor dc-dc converter with coupled inductor for alternative sources of energy”, IEEE Trans. Circuits Syst. I, Regul. Pap., vol.59, pp. 864–874, 2012.
[19] Rosas-Caro, J.C., Ramirez, J.M., Peng, F.Z., Valderrabano, A., “ A dc-dc multilevel boost converter’, IET Power Electron. ”, vol. 3, pp. 129–137, 2010.
[20] Yungtaek, J., Jovanovic, M.M., “ New two-inductor boost converter with auxiliary transformer ”, IEEE Trans. Power Electron., vol. 19, pp. 169–175, 2004.
