The effect of volume fraction and size of Al2O3 nanoparticle on heat transfer and flow characteristics in the heat exchanger with louvered strip inserts

Subject Areas :

Meysam  Pouyanian ¹ (Department of Mechanical Engineering, Ahvaz Branch, Islamic Azad University, Ahvaz, Iran)
Ashkan  Ghafouri ² (Advanced computing Research Center, Department of Mechanical Engineering, Ahvaz Branch, Islamic Azad University, Ahvaz, Iran)

Received: 2023-03-08 Accepted : 2023-05-25 Published : 2023-05-22

Keywords: Thermal conductivity coefficient, Skin friction coefficient, Nusselt number, Louvered strip insert, Nanofluid,

Abstract :

In this study, the effect of using louvered strip inserts in heat exchangers on flow and transfer characteristics is numerically investigated. The continuity, momentum, and energy equations have been solved using a finite volume method. The wall of the tube is heated with a uniform heat flux boundary condition. This paper uses a louvered strip insert arrangement (forward) with a Reynolds number of 10,000. The effects of louvered strip slant angle of  and pitch of 50 mm were used for Al2O3 nanoparticles with different volume fractions in the range of 1% to 4% and different nanoparticle diameters in the range of 20 nm to 50 nm, mixed in a base fluid (water) is used. The comparison of numerical analysis results with existing equations has shown a good convergence. The numerical results reveal that the Nusselt number has increased with decreasing the nanoparticle diameter. The results indicate a slight change in the skin friction coefficient when nanoparticle diameters of Al2O3 nanofluid are varied. The Nusselt number increases with increasing nanoparticle volume fraction of Al2O3 /water nanofluid, while it is found that pure water has the lowest Nusselt number value. Also, the nanofluid has reduced the wall's temperature more than the base fluids (water), which indicates the advantage of using nanofluids in improving the system's thermal performance.

References:

 

[1] Kakaç, S., Bergles, A. E., Mayinger, F., Yüncü, H., (2013), Heat transfer enhancement of heat exchangers, Springer Science & Business Media (Vol. 355).‏

[2] Choi, S. U., Eastman, J. A., (1995), Enhancing thermal conductivity of fluids with nanoparticles, in: D.A. Signer, H.P. Wang (Eds.), Developments Applications of Non-Newtonian Flows, FED-vol. 231/MD, 66, pp. 99–105.

[3] Masuda, H., Ebata, A., Teramae, K., (1993), Alteration of thermal conductivity and viscosity of liquid by dispersing ultra-fine particles (dispersion of c-Al2O3, SiO2 and TiO2 ultra-fine particles), Netsu Bussei (Japan) 4, pp.227–233.

[4] Lee, S., Choi, S. S., Li, S. A., Eastman, J. A., (1999), Measuring thermal conductivity of fluid containing oxide nanoparticles", Journal of Heat Transfer, 121, pp.280–289.

[5] Saidur, R., Kazi, S. N., Hossain, M. S., Rahman, M. M., Mohammed, H. A., (2011), A review on the performance of nanoparticles suspended with refrigerants and lubricating oils in refrigeration systems, Renewable & Sustainable Energy Reviews, 15, pp. 310–323.

[6] Fan, A., Deng, J., Guo, J., Liu, W., (2011), A numerical study on thermo-hydraulic characteristics of turbulent flow in a circular tube fitted with conical strip inserts, Applied Thermal Engineering, 31, pp. 2819–2828.

[7] Kherbeet, A. S., Mohammed, H. A., Salman, B. H., Ahmed, H. E., Alawi, O. A., Rashidi, M. M., (2015), Experimental study of nanofluid flow and heat transfer over microscale backward- and forward-facing steps, Experimental Thermal and Fluid Science, 65, pp.13–21.

[8] Murshed, S. S., de Castro, C. N., (2016), Conduction and convection heat transfer characteristics of ethylene glycol based nanofluids–a review. Applied energy, 184, pp. 681-695.‏

[9] Mashayekhi, R., Arasteh, H., Toghraie, D., Motaharpour, S. H., Keshmiri, A., Afrand, M., (2020), Heat transfer enhancement of Water-Al2O3 nanofluid in an oval channel equipped with two rows of twisted conical strip inserts in various directions: A two-phase approach. Computers & Mathematics with Applications, 79(8), pp.2203-2215.‏

[10] Ho, C. J., Cheng, C. Y., Yang, T. F., Rashidi, S., Yan, W. M., (2021), Experimental study on cooling performance of nanofluid flow in a horizontal circular tube, International Journal of Heat and Mass Transfer, 169, 120961.‏

[11] Akyürek, E. F., Geliş, K., Şahin, B., Manay, E., (2018), Experimental analysis for heat transfer of nanofluid with wire coil turbulators in a concentric tube heat exchanger, Results in Physics, 9, pp. 376-389.‏

[12] W. H. Azmi, K V Sharma, Rizalman Mamat, A B S Alias, Izan Izwan Misnon, (2012), Correlations for thermal conductivity and viscosity of water based nanofluids, Materials Science and Engineering, 36, 012029.

[13] Hamilton, R.L., and Crosser, O.K., (1962), Thermal Conductivity of Heterogeneous Two Component Systems, Industrial & Engineering Chemistry Fundamentals, 1(3), pp. 187-191.

[14] Mohammed, H. A., Hasan, H. A., Wahid, M. A., (2013), Heat transfer enhancement of nanofluids in a double pipe heat exchanger with louvered strip inserts, International Communications in Heat and Mass Transfer, 40, pp. 36-46.

[15] Webb, R.L., (1981), Performance Evaluation Criteria for use of Enhanced Heat Transfer Surfaces in Heat Exchanger Design, international journal of heat and mass transfer, 24, pp. 715–726.

[16] نعمت زاد، ا، غفوری، ا، فلاوند جوزایی، ع، (1399)، بررسی تجربی عملکرد هیدروترمودینامیکی مبدل حرارتی دو لوله ای با استفاده از نانوسیال و نوار تابیده دوگانه، نشریه مهندسی مکانیک، انجمن مهندسان مکانیک ایران.