Heat Transfer has special importance in engineering applications. So, researchers have suggested different new idea to increase heat transfer and using nanofluid is one of these methods In recent years, new methods have been used. One of these methods is the use of nanofluids, ., because nanofluids have higher heat transfer potential than base conventional fluids. In this investigation effect of suspended CuO nanoparticles with volume fraction of 0.005 into base water fluid is considered under turbulent flow regime inside double tube counter heat exchanger. It was observed that suspending pre-mentioned amount of nanoparticle augmentate heat transfer capability of conventional water fluid. On the other side, it leads to increase pressure drop and friction factor of water base fluid. Finally they conclude that positive effect of heat transfer augmentation is so stronger than negative effect of increasing pressure drop and friction factor that motivate to utilize this nanofluid in practical applications. Manuscript profile

In this study, the behavior of nanoparticles using a numerical model is discussed. For this study a model for the expansion in free convection heat transfer and mix in a rectangular container with dimensions of 1 × 4 cm using Nano-aerosols in the air is going when copper nanoparticles, use and by changing the temperature difference between hot and cold wall, we will examine its impact on the rate of heat transfer. The simulation involves two-dimensional flow simulation and relaxed state of constant flux in free convection on the two lateral sides and on the top face of constant temperature (cold plate) at 300 K was considered And at low temperature (heat plate) in three modes 350, 400 and 450 K were compared. Temperature distribution, velocity, surface heat flux and Nusselt number during the course of our review.Finally, enhanced heat transfer in the presence of copper nanoparticles and changes in the temperature difference between warm and cold wall was observed Manuscript profile