Design of a 12-Bit 200MS/S CMOS Sample-and-Hold Circuit

Subject Areas : Semiconductor devices

Hamid  Mahmoodian ¹ (ACECR Institute of Higher Education (Isfahan Branch), Khomeinishahr)
Mehdi  Dolatshahi ² (Najafabad Branch, Islamic Azad University)

Received: 2013-08-01 Accepted : 2014-08-15 Published : 2014-09-01

Keywords: CMOS, Sample-and-hold, charge injection, bootstrapped switch,

Abstract :

In this paper, a new 12bit, 200MS/s fully differential sample and hold circuit is presented. In order to increase the linearity and input voltage dynamic range; bootstrapped-switches are used for sampling the input signal. Furthermore, a tunable gain buffer is used as the output stage of the circuit to prevent the loading effects of the succeeding stages on the proposed circuit. The circuit is simulated in HSPICE using 0.35µm CMOS technology parameters. As it is discussed in the paper, simulation results justify the good performance of the proposed circuit for using in 12bit, 200MS/s applications.

References:

[1] B. Razavi, "Principle of data conversion system design", IEEE press, 1995.

[2] D.A. Johns, K. Martin, "Analog integrated circuit design", John Wiley &Sons, 1997.

[3] C.C. Kok, "CMOS sample/hold circuits for high speed A/D conversion", 1991.

[4] D.W. Cline, "Noise, speed, and power trade-offs in pipelined analog to digital", Memorandum No. UCB/ERL M95/94, Electronics Research Laboratory, U. C. Berkeley, 1995.

[5] P.R. Gray, R.G. Meyer, "Analysis and design of analog integrated circuits", 3rd Edition, New York, Wiley, 1984.

[6] R. Gregorian, G.C. Temes, "Analog MOS integrated circuit for signal processing", New York: John Wiley and Sons, 1998.

[7] M. Gustavsson, J. Wikner, N. Tan, "CMOS data conversion for communication", Kluwer Academic Publishers, 2002.

[8] C.J.B. Fayomi, J. W.Roberts, M. Sawan, "Low-voltage CMOS analog switch for high precision sample-and-hold circuit", Circuits and systems.MVVSCAS o4.Vol. 3, pp. 315-318, 2000.

[9] T.S. Lee, C.C. Lu, J.T. Zahn, "A 250MHz 11Bit 20mW CMOS low-hold-pedestal fully differential track-and-hold circuit", Soc Conference, IEEE International, pp. 47-50, 2006.

[10] T.S. Lee, C.C. Lu, "A 1.5-v 50-MHz pseudodifferential CMOS sample-and-hold circuit with low hold pedestal", IEEE Trans. on Circuits and System, Vol. 52, No. 9, 2005.

[11] M. Sadollahy, K. Hadidi, "A high-speed highly-linear CMOS S/H circuit", Proceeding of the Int. Conf. on Computer and Communication Engineering, pp. 550-553, 2008.

[12] A. Boni, A. Pierazzi, "A 10-b 185MS/s track-and-hold in 0.35-µm CMOS", IEEE J.Solid-State Circuits, Vol. 36, No. 2, pp. 195-203, 2001.

[13] B. Razavi, "Design of analog CMOS integrated circuits", McGraw-Hill Co., Inc., pp. 53-57, 2000.

[14] K. Hadidi, M. Sasaki, T. Watanabe, D. Muramatsu, T. Matsumoto, "An open-loop full CMOS 103MHz -61dB THD S/H crcuit", IEEE Custom Integrated Circuits Conference, Proceeding of the IEEE, pp. 381-383, 1998.