Experimental Investigation of the Effects of the Roller Burnishing Parameters on the Surface Roughness and Micro-hardness of Ti6Al4V Alloy

Subject Areas :

Mohammad Asadbeiki ¹ , Reza Nosouhi ²

1 - Modern Manufacturing Technologies Research Center, Najafabad Branch, Islamic Azad University, Najafabad, Iran|Department of Mechanical Engineering, Najafabad Branch, Islamic Azad University, Najafabad, Iran
2 - Modern Manufacturing Technologies Research Center, Najafabad Branch, Islamic Azad University, Najafabad, Iran|Department of Mechanical Engineering, Najafabad Branch, Islamic Azad University, Najafabad, Iran

Received: 2019-11-08 Accepted : 2020-02-13 Published : 2019-08-01

Keywords:

References:

[1] Rodríguez, A., López de Lacalle, L.N., Celaya, A., Lamikiz, A., Albizuri, J. 2012. Surface improvement of shafts by the deep ball-burnishing technique. Surface and Coatings Technology. 206 (11–12): 2817-2824.

[2] El-Tayeb, N.S.M., Low, K.O., and Brevern P.V. 2007. Influence of roller burnishing contact width and burnishing orientation on surface quality and tribological behaviour of Aluminium 6061. Journal of Materials Processing Technology. 186(1–3): 272-278.

[3] El-Axir, M.H. and El-Khabeery, M.M. 2003. Influence of orthogonal burnishing parameters on surface characteristics for various materials. Journal of Materials Processing Technology. 132(1–3): 82-89.

[4] Luo, H., Liu, J., Wang, L., and Zhong, Q. 2006. The effect of burnishing parameters on burnishing force and surface microhardness. The International Journal of Advanced Manufacturing Technology. 28(7): 707-713.

[5]  Revankar, G.D., Shetty, R., Rao, S.S., Gaitonde, V.N. 2016. Wear resistance enhancement of titanium alloy (Ti–6Al–4V) by ball burnishing process. Journal of Materials Research and Technology. 6 (1): 13-32.

[6] Chomienne, V., Valiorgue, F., Rech, J., Verdu, C. 2016. Influence of ball burnishing on residual stress profile of a 15-5PH stainless steel. CIRP Journal of Manufacturing Science and Technology. 13: 90-96.

[7] Yen, Y.C., Sartkulvanich, P., and Altan, T. 2005. Finite Element Modeling of Roller Burnishing Process. CIRP Annals. 54 (1): 237-240.

[8] Klocke, F., Liermann, J. 1998. Roller burnishing of hard turned surfaces. International Journal of Machine Tools and Manufacture. 38 (5–6): 419-423.

[9] Sartkulvanich, P., Altan, T., Jasso, F. and Rodriguez, C. 2007. Finite Element Modeling of Hard Roller Burnishing: An Analysis on the Effects of Process Parameters Upon Surface Finish and Residual Stresses. Journal of Manufacturing Science And Engineering, 129(4): 705-716.

[10] Klocke, F., Bäcker, V., Wegner, H. and Zimmermann, M. 2010. Finite Element Analysis of the Roller Burnishing Process for Fatigue Resistance Increase of Engine Components. Proceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture. 225 (1): 2-11.