Subject Areas :
Electrical Engineering
Mansoor Zeinali
1
,
Somaye Yaghoubi
2
1 - Department of Electrical Engineering, Najafabad Branch, Islamic Azad University, Najafabad, Iran
2 - Department of Electrical Engineering, Najafabad Branch, Islamic Azad University, Najafabad, Iran
Received: 2022-09-23
Accepted : 2022-12-30
Published : 2022-12-01
Keywords:
References:
Brock, D. Łuczak, K. Nowopolski, T. Pajchrowski, K. Zawirski, "Two approaches to speed control for multi-mass system with variable mechanical parameters", IEEE Trans. on Industrial Electronics, vol. 64, no. 4, pp. 3338-3347, April 2017.
Shahgholian, P. Shafaghi, M. Zinali, S. Moalem, "State space analysis and control design of two-mass resonant system", Proceeding of the IEEE/ICCEE, pp. 668-672, Dubai, Dec. 2009.
Tezuka, T. Yamashita, T. Sato, Y. Abiko, T. Kanai, M. Sawada, "Application of a new automatic gauge control system for the tandem cold mill", IEEE Trans. on Industry Applications, vol. 38, no. 2, pp. 553-558, March/April 2002 .
Luczak, T. Pajchrowski, "Application of adaptive neural controller and filter tune for multi-mass drive system", Proceeding of the IEEE/EPE, pp. 1-9, Riga, Latvia, Sept. 2018.
Jafari, G. Shahgholian, “Analysis and simulation of a sliding mode controller for mechanical part of a doubly-fed induction generator based wind turbine”, IET Generation, Transmission and Distribution, Vol. 11, No. 10, pp. 2677-2688, July 2017.
Bendrat, C. Sourkounis, "Comparison of multi-mass models and modal models for state estimation of high power drives", Proceeding of the IEEE/EVER, pp. 1-7, Monte-Carlo, Monaco, May 2021.
R. Yousefi, G. Shahgholian, A. Etesami, P. Shafaghi, "Small signal modeling and analysis of control speed for two mass resonant system", Proceeding of the IEEE/IPEC, pp. 1000-1003, Singapore, Oct. 2010.
Shahgholian, “Modeling and simulation of a two-mass resonant system with speed controller”, International Journal of Information and Electronics Engineering, vol. 3, no. 5, pp. 448-452, Sept. 2013.
Lee, M. Kato, Y. Doi, K. Hirata, "A new method to control intrinsic localized mode using a variable magnetic spring structure", IEEE Trans. on Magnetics, vol. 58, no. 2, pp. 1-5, Feb. 2022.
Fooladgar, E. Rok-Rok, B. Fani, G. Shahgholian, “Evaluation of the trajectory sensitivity analysis of the DFIG control parameters in response to changes in wind speed and the line impedance connection to the grid DFIG”, Journal of Intelligent Procedures in Electrical Technology, Vol. 5, No. 20, pp. 37-54, March 2015 .
Nandana, A.S. Anas, "An efficient speed control method for two mass drive systems using ADALINE", Proceeding of the IEEE/ICSTM, pp. 418-423 Avadi, India, May 2015.
Shahgholian, "Controller design for three-mass resonant system based on polynomial method", International Journal of Science, Technology and Society, Vol. 5, No. 2, pp. 13-25, March 2017.
Szabat, T. Tran-Van, M. Kamiński, "A modified fuzzy luenberger observer for a two-mass drive system", IEEE Trans. on Industrial Informatics, vol. 11, no. 2, pp. 531-539, April 2015.
Jin, C. Lu, P. Ju, C. Rehtanz, F. Wu, X. Pan, "Probabilistic preassessment method of parameter identification accuracy with an application to identify the drive train parameters of DFIG", IEEE Trans. on Power Systems, vol. 35, no. 3, pp. 1769-1782, May 2020 .
Taslimi, A. Chatraei, M. Hosseini, “A robust neuroadaptive control of three link SCARA robot with mass uncertainty”, Journal of Intelligent Procedures in Electrical Technology, vol. 4, no. 15, pp. 11-18, Nov. 2013 .
Shahgholian, A. Hakimi, N. Behzadfar, ”Motor speed maximum control in the resonance ratio controller for two-mass system using self-organizing fuzzy controller”, International Journal of Research Studies in Electrical and Electronics Engineering, vol. 1, no. 6, pp. 1-8, 2020.
K. Kundu, S. Chatterjee, “Nonlinear feedback self-excitation of modal oscillations in a class of under-actuated two degrees-of-freedom mechanical systems”, International Journal of Non-Linear Mechanics, vol. 135, Article Number: 103768, Oct. 2021 .
E. Saarakkala, M. Hinkkanen, "Identification of two-mass mechanical systems using torque excitation: Design and experimental evaluation", IEEE Trans. on Industry Applications, vol. 51, no. 5, pp. 4180-4189, Sept./Oct. 2015 .
E. Saarakkala, M. Hinkkanen, "State-space speed control of two-mass mechanical systems: Analytical tuning and experimental evaluation", IEEE Trans. on Industry Applications, vol. 50, no. 5, pp. 3428-3437, Sept./Oct. 2014 .
Fuentes, D. Kalise, R.M. Kennel, "Smoothened quasi-time-optimal control for the torsional torque in a two-mass system", IEEE Trans. on Industrial Electronics, vol. 63, no. 6, pp. 3954-3963, June 2016.
Katsura, K. Ohnishi, "Force servoing by flexible manipulator based on resonance ratio control", IEEE Trans. on Industrial Electronics, vol. 54, no. 1, pp. 539-547, Feb. 2007.
Ilchmann, H. Schuster, "PI-funnel control for two mass systems", IEEE Trans. on Automatic Control, vol. 54, no. 4, pp. 918-923, April 2009.
J. Serkies, K. Szabat, "Application of the MPC to the position control of the two-mass drive system", IEEE Trans. on Industrial Electronics, vol. 60, no. 9, pp. 3679-3688, Sept. 2013.
Hori, H. Sawada, Y. Chun, "Slow resonance ratio control for vibration suppression and disturbance rejection in torsional system", IEEE Trans. on Industrial Electronics, vol. 46, no. 1, pp. 162-168, Feb. 1999.
Orlowska-Kowalska, M. Dybkowski, K. Szabat, "Adaptive sliding-mode neuro-fuzzy control of the two-mass induction motor drive without mechanical sensors", IEEE Trans. on Industrial Electronics, vol. 57, no. 2, pp. 553-564, Feb. 2010.
Shahgholian, J. Faiz, P. Shafaghi, "Analysis and simulation of speed control for two-mass resonant system", Proceeding of the IEEE/ICCEE, pp. 668-672, Dubai, Dec. 2009.
Shahgholian, J. Faiz, "An analytical approach to synthesis and modeling of torque control strategy for two-mass resonant systems", International Review of Automatic Control, Vol. 2, No. 4, pp. 459-468 , July 2009.
Szabat, T. Orlowska-Kowalska, "Optimization of the two-mass drive dynamics using different compensation feedbacks", Proceeding of the IEEE/OPTIM, pp. 19-24, Brasov, Romania , May 2008.
Ellis, R.D. Lorenz, "Resonant load control methods for industrial servo drives", Proceeding of the IEEE/IAS, vol. 3, pp. 1438-1445, Rome, Italy , Oct. 2000.
Nakayama, K. Fujikawa, H. Kobayashi, "A torque control method of three-inertia torsional system with backlash", Proceeding of the IEEE/AMC, pp. 193-198, Nagoya, Japan, April 2000.
Odai, Y. Hori, "Speed control of 2-inertia system with gear backlash using gear torque compensator", Proceeding of the IEEE/AMC, pp. 234-239, Coimbra, Portugal, June/July 1998.
Lotfi-Forushani, B. Karimi, G. Shahgholian, “Optimal PID controller tuning for multivariable aircraft longitudinal autopilot based on particle swarm optimization algorithm”, Journal of Intelligent Procedures in Electrical Technology, vol. 3, no. 9, pp. 41-50, June 2012.
Taheri, H. Orojlo, F. Ebrahimi, "Damping controller design in offshore wind power plants to improve power system stability using fractional order PID controllers based on optimized exchange market algorithm", Journal of Intelligent Procedures in Electrical Technology, vol. 13, no. 51, pp. 91-110, Dec. 2022.
Shahedi, K. Sabahi, M. Tayana, A. Hajizadeh, “Self-tuning fuzzy PID controller for load frequency control in ac micro-grid with considering of input delay”, Journal of Intelligent Procedures in Electrical Technology, vol. 9, no. 35, pp. 19-26, Dec. 2019.
Shahgholian, A. Etesami, M. R. Yousefi, F.M. Tehrani, "Development of state space model and control design of two-mass system using standard forms", Proceeding of the IEEE/ICCSN, pp. 342-346, Xi'an, China, May 2011.
Jeddi-Golfazani,M. Vahedi,M. Gandomkar, "Design of robust reset controller based on optimal after reset performance to improve the performance of an industrial robot control", Journal of Intelligent Procedures in Electrical Technology, vol. 14, no. 55, pp. 83-100, Dec. 2023.
