Selecting Remotely Sensed Images Radiometric Calibration Site (Case Study: Tehran Province)

Subject Areas : Journal of Radar and Optical Remote Sensing and GIS

Mohammad Javad Khodam ¹ , Abbas Bashiri ² , Hasan Hasani Moghaddam ³ , Seyyed Mohammad Afghahi ⁴ , Hasan Tabarsi ⁵

1 - M.Sc. of Physic, Institute for Advanced Studies in Basic Sciences (IASBS), Zanjan, Iran
2 - Instructor of Electornic, Department of Information and Communication Technology, Imam Hossein University (IHU), Tehran, Iran
3 - M.Sc. of Remote Sensing, Kharazmi University, Tehran, Iran
4 - - M.Eng of metalogic, , Imam Hossein University, Tehran, Iran
5 - M. Eng. of Electornic, Microelectronic and Nanoelectronic Devices, Department of Information and Communication Technology, Imam Hossein University (IHU), Tehran, Iran

Received: 2021-01-13 Accepted : 2020-05-25 Published : 2020-12-01

Keywords: Tehran, remote sensing, atmosphere, Radiometric Calibration Site,

Abstract :

Radiometric errors are the most common errors of data acquired by remote sensing sensors. Correction of this type of error requires knowledge about the atmospheric conditions during imaging of the sensor. The aim of this study is to select an ideal location for the construction of a radiometric calibration site. Tehran province was selected as a case study to conduct research in a pilot environment. Based on the studies performed on the CEOS standards in site selection as well as the criteria observed in Cal Val sites, 14 parameters were selected as important and necessary parameters for calibration site selection. The data used in this research include two categories of satellite data and GIS layers. After applying the preprocessing on the data and obtaining the weight of each layers, suitable places were obtained for the construction of the calibration site between 2012 to 2019 years. Due to the importance of the consistency of the selected place during different years, the places that were always suitable between the evaluated years, were selected. The results of the research show an ideal location in the western region of Tehran for site construction, which has been selected very well suitable in terms of all criteria. In addition to developing the appropriate location for the calibration site uses, instruments such as san-photometer and goniometer were also developed to be installed on the site to provide services to multispectral and hyperspectral sensors.