Metallurgical Investigation of Under Water Friction Stir Welding (UWFSW) Process
Subject Areas : Journal of Environmental Friendly Materials
M Sadeghi
1
(MAPNA Boiler and Equipment Engineering and Manufacturing Co., Karaj, Iran)
Keywords: Mechanical Properties, Friction Stir Welding, grain size, Under Water, Weld Nugget,
Abstract :
[1] S,Shahabuddin, V. K. Dwivedi, A. Sharma, Int. J. Eng. Adv. Technol. (IJEAT), Volume-8 Issue-4, April 2019.
[2] I. Sabry , A. M. El-Kassas, Int. J. Eng. Tech., 11, 2019, 78.
[3] A. W. Mohd, A. K. Zahid , A. N. Siddiquee, Trans. Nonferrous Met. Soc. China, 28, 2018, 193.
[4] A. M. El-Kassas, J. Adv. Eng. Tech., 4, 2017, 158.
[5] I. Sabry, I. Mourad, D. T. Thekkuden , Joints Inter. Rev. Aerosp. Eng. 14, 2020, 64.
[6] H. Papahn, Int. J. Adv. Manuf. Tech., 78, 2015, 1101.
[7] M. Sadeghi , H. Sabet, 1st International Conference on Welding and Non Destructive Testing (ICWNDT 2014), Islamic Azad University Karaj Branch, Karaj, Iran, pp.30, 2014.
[8] H. J. Lue, H. J. Zhang , Y. Lu, Mat. des., 32, 2011, 1548.
[9] S. K. Maiti, S. Namdeo , I. Mourad, Eng. Des., 238, 2008, 787.
[10] Aaron L. Stahl, Experimental measurements of longitudinal load distributions on friction stir weld pin tool, department of Mech. Eng. Brigham Young University, December 2005.
[11] R. S. Mishra and Z. Y. Ma, A Rev. J. Chinese Accademy Sci., Shenyang 110016, China, 18 August 2005.
[12] T. S. Srivatsan and S. Vasudevan, Dept Mech. Eng., Cin, Ohio, Usa, October 15-19, 2006.
[13] V. Balasubramanian, Dept. Manuf. Eng., Annamalai University, Annamalainagar 608002, Tamil Nadu, India, 6 July 2007.
[14] T. R. McNelley, S. Swaminathan, J. Q. Su, Recrystallization mechanisms during friction stir welding/processing of aluminum alloys, Department of Mechanical and Astronautical Engineering, Naval Postgraduate School, Monterey, CA 93943-5146, USA, 28 September 2007
