The role of slope shape roofs in heating energy consumption Based on thermal comfort

Subject Areas : environmental management

Ali Sharghi ¹ , Nazanin Azimi Fereidani ²

1 - Assistant Professor, Department of Architecture, Faculty of Architecture and urbanization, Shahid Rajaee Teacher Training University, Tehran,Iran
2 - Msc of Architecture, Department of Architecture, Faculty of Architecture and urbanization, Shahid Rajaee Teacher Training University, Tehran, Iran*(Corresponding Author).

Received: 2015-11-03 Accepted : 2016-01-04 Published : 2017-06-22

Keywords: architecture, Roof shape, Thermal Comfort, mean radiant temperature, energy saving,

Abstract :

Background and Objective: In the past, thermal comfort was created through the design of buildings and a handful of construction equipment. Selection of appropriate crust form was one of the noteworthy methods in architecture. Such circumstances were changed in 1960s. Heating, cooling and lighting supply of buildings by mechanical equipment and the use of fossil fuels became pivotal aspect. In the past years following the energy crisis created in this way and environmental pollution, again the best case of heating and cooling, became the accordance to building design and use of clean energy. In these circumstances, appropriate and followed by that reduction of energy consumption of buildings. Among these components, roofing, which plays a fundamental role in thermal exchange, is often overlooked. Method: In this article, research method is done based on computer modeling and simulation by Revit 2014 and energy plus with version of 8.1.  Findings:So, ahead research intends to discuss in the mountainous of Karaj comparison between the four dominant type of roof including flat, one-way, two-way and four-way with the different angles. Its target is to achieve the optimum form and a roof sloping angle in this region based on the average radiant temperature, the man factors of thermal comfort. Discussion and Conclusion:  Results of Analysis of simulated models, shows optimal roof and its most appropriate angle in the sloping roof with constant floor area according to the average mean radiant temperature in the studied model. 

References:

1. مردانی. شیوا،1390، مجموعه اقامتی محیطی خود کفا از لحاظ انرژی، پایان نامه کارشناسی ارشد، دانشگاه علم وصنعت، صص3-10.


2. گرامیان. فرناز،1390،طراحی مجتمع مسکونی پایدار، پایان نامه کارشناسی ارشد، دانشگاه علم و صنعت، صص56-57 .


3. مسندی. مریم، حیدری. شاهین، 1389، شبیه سازی بام ها راه کار بررسی دقیق تاثیرات دمایی درمحیطی مجازی، نشریه هنرهای زیبا، معماری وشهرسازی، شماره 42،صص5-12.
   
   
   1. Ghaedi, Abdolkarim ,Ghaedi , Hojat and Hamed Ghaedi,(2012),” ‘The role of roof shapes in design of green building systems(case study:iran, Bandar abbas), procedia apcbee,p 335-340،
   
   
   2. mahdavi nejad, mohammad javad, badri, negar ,fakhari , haghshenas.(2013)  , “the role of domed shape roofs in energy loss at night in hot and dry climate(case study :Isfahan historical mosques domes in iran), american journal of civil engineering and architecture, vol , 1 , no, 6. 117-121
   
   


4. کاری. بهروز محمد،1388،اصول و روش های عایق کاری بر اساس مبحث 19 مقررات ملی ساختمان(صرفه جویی در مصرف انرژی)، مرکز تحقیقات ساختمان و مسکن، چاپ دوم، نشریه ک-443، صص 26-28


5. قیابکلو.زهرا،1392،مبانی فیزیک ساختمان2:تنظیم شرایط محیطی، انتشارات جهاد دانشگاهی واحد صنعتی امیرکبیر،چاپ دوم،تهران، ص114.


6. نیلسن. هالگر کاک،1389، معماری هم ساز با اقلیم ، اصول طراحی معماری زیست محیطی در مناطق گرم، سفلای. فرزانه(مترجم)، مرکز مطالعاتی و تحقیقاتی شهرسازی و معماری،چاپ اول. صص 94و 95.
   
   
   1. al-ghamdi, m,(1993).assessment and improvement of thermal conditions inside pilgrimage tents at makah, Saudi Arabia, architecture ph.d thesis, university of Newcastle
   
   


7. کسمایی. مرتضی،1387، اقلیم و معماری، نشر خاک، چاپ پنجم، اصفهان.
   
   
   1. ahmad, a, m,(1974).ceiling heights and human comfort,building in hot climates,no 2, ERS Press, England
   
   


8. سیری. اسدالله،1389، مصرف بهینه انرژی در زندگی روزمره، نشریه اقتصاد انرژی، شماره 135، بهمن ماه، صص 57-66.