The Comparative Study of ADI Machinability with 42CrMo4 Steel in Turning Process

Subject Areas : journal of New Materials

M. SH ¹ (دانشیار دانشکده مهندسی مکانیک، دانشگاه تبریز)
H. عباسی ایروانلو ² (کارشناسی ارشد مهندسی مکانیک، دانشگاه آزاد اسلامی، واحد شیراز، باشگاه پژوهشگران جوان)
H. عیوضی باقری ³ (کارشناس ارشد مهندسی مکانیک، عضو باشگاه پژوهشگران جوان دانشگاه آزاد اسلامی تبریز)
A. جعفری ⁴ (استادیار دانشکده فنی مهندسی ، دانشگاه آزاد شیراز)

Received: 2014-02-05 Accepted : 2014-02-05 Published : 2014-05-22

Keywords: ADI, 42CrMo4, cutting special energy, surface roughness,

Abstract :

This paper studies, the effect of input parameters (cutting speed and feed rate) on the output parameters (cutting special energy and surface roughness) in machining of ADI cost iron and 42CrMo4 steel and the machinability of these materials compared. Based on the results it was found that ADI cutting special energy is greater than 42CrMo4 steel and with increasing cutting speed in both types of materials, cutting special energy decreases. Also, the results show that ADI surface roughness is much less than the surface roughness of 42CrMo4 steel parts. The comparison was determined with increasing feed rate cutting special energy for both materials decreased and surface roughness of machined components increase.