Subject Areas : Electronics

Yasin Safari ¹ (Department of Electrical Engineering, Najafabad Branch, Islamic Azad University, Najafabad, Iran.)
S. Mohammadali Zanjani ² (Department of Electrical Engineering, Najafabad Branch, Islamic Azad University, Najafabad, Iran.)

Received: 2024-05-20 Accepted : 2024-08-20 Published : 2024-10-02

Keywords:

References:

[1] A. Baghi-Rahin, V. Baghi-Rahin, “A 0.5 V operational transconductance amplifier based on dynamic threshold-voltage MOSFET and floating gate MOSFET inverters in 180 nm CMOS technology,” Journal of Intelligent Procedures in Electrical Technology (JIPET), Vol. 15, no. 60, pp. 1-18, March 2025 (in Persian).
[2] L. Safari, & S. Minaei, “A novel resistor-free electronically adjustable current-mode instrumentation amplifier,” Circuits, Systems and Signal Processing, 32(3):1025–1038, 2013.
[3] E. Yuce, “Various current-mode and voltage-mode instrumentation amplifier topologies suitable for integration,” Journal of Circuits, Systems, and Computers, 19(3):689–699, 2011.
[4] A. Baghi Rahin, and V. Baghi Rahin, “A new 2-input CNTFET-based XOR cell with ultra-low leakage power for low-voltage and low-power full adders,” Journal of Intelligent Procedures in Electrical Technology (JIPET), 10(37), pp. 2322-3871, 2019
[5] Zanjani, S. M. A., & Parvizi, M. (2021). Design and simulation of a bulk driven operational trans-conductance amplifier based on CNTFET technology. Journal of Intelligent Procedures in Electrical Technology (JIPET),12(45), 65-76.
[6] W. J. K. Michiel, and A. P. Pertij, “A 140dB-CMRR current-feedback instrumentation amplifier employing ping-pong auto-zeroing”, IEEE Int. Solid-State Circuits Conf. (2009), San Francisco, USA, pp. 324–325, 2009.
[7] T. Ettaghzouti, M. Bchir, & N. Hassen, “High CMRR voltage mode instrumentation amplifier using a new CMOS differential difference current conveyor realization,” International Journal of Electrical Engineering & Telecommunication, vol. 9, no. 3, pp. 132–141, 2020.
[8] S. Maheshwari, “High CMRR wide bandwidth instrumentation amplifier using current controlled conveyors,” Int. J. Electron, 89, 889–896, 2008.
[9] A. Baghi Rahin, Z. Daei Koozeh Kanani, “A Low-Voltage and Low-Power Programmable Gm-C Filter for Wireless Applications,” Journal of Intelligent Procedures in Electrical Technology (JIPET), Vol. 5(19), Dec. 2014, pp. 3-10.
[10] L. Safari, S. Minaei, “A novel COA-based electronically adjustable current-mode instrumentation amplifier topology,” AEU-Int J Electron Commun, 82, 285–93, 2017.
[11] L. Safari, S. Minaei, G. Ferri, & V. Stornelli, “Analysis and design of a new COA-based current-mode instrumentation amplifier with robust performance against mismatches,” AEU-Int J Electron Commun, 89,105–9, 2018.
[12] B. Chaturvedi, & A. Kumar, “Electronically tunable current-mode instrumentation amplifier with high CMRR and wide bandwidth,” AEU-Int J Electron Commun, 92, 116–23, 2018.
[13] C. Chanapromma, C. Tanaphatsiri, and M. Siripruchyanun, “An electronically controllable instrumentation amplifier based on CCCCTAs,” IEEE Int. Symp. Intelligent Signal Processing and Communications Systems (ISPACS2008), Bangkok, Thailand, pp. 1–4. (2009)
[14] N. Raj, S. Dutta, R. K. Ranjan, & et al., “VDTA Based Transadmittance Mode Instrumentation Amplifier with Experimental results,” 2023.