Specifying the allowed remained bottom thickness after milling in CNG steel cylinders by FEM analysis and experimentation

Subject Areas : Journal of Simulation and Analysis of Novel Technologies in Mechanical Engineering

Mojtaba Esmailian ¹ , Mohsen Shahmoradi ² , Kamran Karimzadeh ³

1 - Faculty of Mechanical, Malek Ashtar University of Technology, Iran
2 - Department of Mechanical Engineering, Malek Ashtar University of Technology, Isfahan, Iran
3 - Engineering Department, Pars MCS Co, 8465197569 Esfahan, Iran

Received: 2022-06-15 Accepted : 2022-08-07 Published : 2022-03-01

Keywords:

References:

[1] Moss, Dennis R., (2004), Pressure vessel design manual, illustrated

procedures for solving major pressure Problems. 3rd.

[2] ISO 9809 Standard, (2010), Gas cylinders — Refillable seamless steel gas cylinders - Design, construction, and testing.

[3] ISO 11439 Standard, (2013), Gas cylinders, High-pressure cylinders for the on-board storage of natural gas as a fuel for automotive vehicles.

 [4] Li, H., Huang, X., Yang, P., Yang, H., (2017), A new pressure vessel design by analysis method avoiding stress categorization, International Journal of Pressure Vessels and Piping, 152, 38-45.

 [5] Ahmadi Borughani, Y.,  Faghani, H., (2009), Design and fatigue analysis of CNG cylinders type 1 according to international standards, Ninth international manufacturing conference, Birjand University, Iran, 2009.

 [6] Shariati, M., Mohammadi, E., Masoudi Nejad, R., (2017), Effect of new specimen size on fatigue crack growth behavior in thick-walled pressure vessels, International Journal of Pressure Vessels and Piping, 150, 1-10.

 [7] Zoghi, H., Fallahi Arezoodar, A., Sayeaftabi, M., (2013), Enhanced finite element analysis of material deformation and strain distribution in the spinning of 42CrMo steel tubes at elevated temperature, J Materials, and Design, 47, 234–242.

 [8] Huang, C-C., Hung, J-C., Hung, C., Lin, C-R., (2011), Finite element analysis on neck-Spinning process of tube at elevated temperature, The International Journal of Advanced Manufacturing Technology, 56, 1039–48.

 [9] Lexian, H., Dariani, BM., (2008), An analytical contact model for finite element analysis of tube spinning process, Proceeding of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture, 222, 1375–85.

 [10] Liu, JH. Yang, H., Li, YQ., (2002), A study of the stress and strain distributions of first-pass conventional spinning under different roller-traces, Journal of Materials Processing, 129,  326–329.

 [11] Zhang, X., Zhao, L., Wen, T., (2017) An optimized neck-spinning method for improving the inner surface quality of titanium domes, International Conference on the Technology of Plasticity, 17-22.

 [12] Maghsoodi, M., H., Monajatizadeh, Alaee, A.R., (2013), Hot pressing effects on the mechanical properties after hot spinning in CNG cylinders, NCME Conference, Tehran, Iran.

 [13] Hibbitt K, Sorensen. (2001)  ABAQUS CAE user’s manual. Hibbitt, Karlsson & Sorensen, Inc.