Optimal Current Meter Placement for Accurate Fault Location Purpose using Dynamic Time Warping

Subject Areas : International Journal of Smart Electrical Engineering

K. G. Firouzjah ¹ , A Sheikholeslam ²

1 - Faculty of Electrical and Computer Engineering, Babol (Noshirvani) University of Technology, Babol, Iran.
2 - Faculty of Electrical and Computer Engineering, Babol (Noshirvani) University of Technology, Babol, Iran.

Received: 2015-04-13 Accepted : 2015-04-13 Published : 2012-09-01

Keywords:

References:

[1]

A. Sauhats, M. Danilova, "Fault location algorithms for super high voltage power transmission lines", Power Tech, in Proc IEEE, Vol. 3, pp. 3, 2003.

[2]

Z. Galijasevic, A. Abur, "Fault location using voltage measurements", IEEE Trans. Power Delivery, Vol. 17, No. 2, pp. 441 – 445, 2002.

[3]

P. Bastard, L. Garcia-Santander, X.Le. Pivert, I. Gal, E.L. Parra, "A voltage-based fault location method for radial distribution networks", in Proc IEEE, Power System Management and Control International Conference, No. 488, pp. 216 – 221, 2002.

[4]

C.E. de Morais Pereira, L.C. Zanetta, "Fault location in transmission lines using one-terminal postfault voltage data", IEEE Trans. Power Delivery, Vol. 19, No. 2, pp. 570 – 575, 2004.

[5]

Li Yongli; Yi. Zhang; Ma. Zhiyu,"Fault location method based on the periodicity of the transient voltage traveling wave", TENCON, IEEE Region 10 Conference, Vol. 3, pp.

389 – 392, 2004.

[6]

Y.J. Xia, X.G. Yin, Z.H. Wang, J.C. Yang, X.B. Zhang, "A novel fault location scheme using voltage traveling-wave of CVTs", UPEC 2004, Vol. 2, pp. 768 – 772, 2004.

[7]

J.A. Jiang, J.Z. Yang, Y.H. Lin, C.W. Liu, J.C. Ma, "An adaptive PMU based fault detection/location technique for transmission lines, Part I: Theory and algorithms", IEEE Trans. Power Delivery, Vol. 15, pp. 486–493, 2000.

[8]

J.A. Jiang, Y.H. Lin, J.Z. Yang, T.M. Too, C.W. Liu, "An adaptive PMU based fault detection/location technique for transmission lines, Part II: PMU implementation and performance evaluation", IEEE Trans. Power Delivery, Vol. 15, pp. 1136–1146, 2000.

[9]

S.M. Brahma, "New fault-location method for a single multi terminal transmission line using synchronized phasor measurements", IEEE Trans. Power Delivery, Vol. 21, No. 3, pp. 1148 – 1153, 2006.

[10]

S.M. Brahma, A.A. Girgis, "Fault location on a transmission line using synchronized Voltage measurements", IEEE Trans. Power Delivery, Vol. 19, No. 4, pp. 1619 – 1622, 2004.

[11]

S.M. Brahma,"Fault location scheme for a multi-terminal transmission line using synchronized Voltage measurements", IEEE Trans. Power Delivery, Vol. 20, No. 2, Part 2, pp. 1325 – 1331, 2005.

[12]

K. G. Firouzjah, A. Sheikholeslami, "Current Independent Method Based on Synchronized Voltage Measurement for Fault Location on Transmission Lines,” Simulation Modelling Practice and Theory, Vol. 17, No.4, pp. 692-707, April 2009.

[13]

M.H.J. Bollen, Understanding Power Quality previous Problems: Voltage Sags and Interruptions, New York: Wiley, 2000.

[14]

R.F. Nuqui, and A.G. Phadke, "Phasor measurement unit placement techniques for complete and incomplete observability," IEEE Trans. Power Delivery, Vol. 20, No. 4, Oct. 2005.

[15]

A. Ahmadi, Y. Alinejad-Beromi and M. Moradi, "Optimal PMU placement for power system observability using binary particle swarm optimization and considering measurement redundancy," Expert Systems with Applications, Vol. 38, No. 6, pp. 7263-7269, 2011.

[16]

R. Sodhi, S. C. Srivastava and S. N. Singh , "Optimal PMU placement method for complete topological and numerical observability of power system," Electric Power Systems Research, Vol. 80, No. 9, pp. 1154-1159, 2010.

[17]

S. Chakrabarti and E. Kyriakides, "Optimal placement of phasor measurement units for power system observability," IEEE Trans. Power Systems, Vol. 23, No. 3, pp. 1433–1440, 2008.

[18]

D.-J. Won and S.-I. Moon, "Optimal Number and Locations of Power Quality Monitors Considering System Topology," IEEE Trans. Power Delivery, Vol. 23, No. 1, pp. 288–295, 2008.

[19]

M. A. Eldery, E. F. El-Saadany, M. M. A. Salama and A. Vannelia, "A Novel Power Quality Monitoring Allocation Algorithm," IEEE Trans. Power Delivery, Vol. 21, No. 2, pp. 768 – 777, 2006.

[20]

J. Chen and A. Abur, "Placement of PMUs to Enable Bad Data Detection in State Estimation", IEEE Trans. Power System, Vol. 21, No. 4, pp. 1608-1615, 2006.

[21]

B. Xu and A. Abur, "Observability analysis and measurement placement for system with PMUs," in Proc. 2004 IEEE Power Systtem Conf., Vol. 2, pp. 943–946.

[22]

Yang X et al. "Coordinated algorithms for distributed state estimation with synchronized phasor measurements," Applied Energy, 2011, doi:10.1016/j.apenergy.2011.11.010

[23]

M. Hajian, A. M. Ranjbar, T. Amraee, and B. Mozafari,

International Journal of Smart Electrical Engineering, Vol.1, No.3, Fall 2012 ISSN: 2251-9246

173

“Optimal placement of PMUs to maintain network observability using a modified BPSO algorithm,” Int. J. Electric Power Energy System, Vol. 33, no. 1, pp. 28–34, Jan. 2011.

[24]

F. Aminifar, A. Khodaei, M. Fotuhi-Firuzabad, M. Shahidehpour, “Contingency constrained PMU placement in power networks,” IEEE Trans. Power System, Vol. 25, No. 1, pp. 516–23, 2010.

[25]

S. Chakrabarti, E. Kyriakides, DG. Eliades, “Placement of synchronized measurements for power system observability,” IEEE Trans. Power Delivery, Vol. 24, No. 1, pp. 12–9, 2009.

[26]

A. Enshaee, R. A. Hooshmand, F. H. Fesharaki, “A new method for optimal placement of phasor measurement units to maintain full network observability under various contingencies,” Electric Power Systems Research, Vol. 89 pp. 1-10, 2012.

[27]

K. -P. Lien, C. -W. Liu, C. –S. Yu, and J.-A. Jiang, “Transmission network fault location observability with minimal PMU placement,” IEEE Trans.Power Del.,vol.21, no. 3, pp.1128-1136, Jul. 2006.

[28]

K. Mazlumi, H. A. Askarian, S. H. Sadegi, and S. S. Geramian, “ Determination of optimal pmu placement for fault-location observability,” in Third international conference on Electric UtilityDeregulation and Restructuring and Power Technologies, Apr. 6-9, 2008, pp. 1938-1942.

[29]

S. S. Geramian, H. A. Askarian, K. Mazlumi, “Determination of optimal PMU placement for fault location using genetic algorithm,” ICHQP-2008 13th International conference on Harmonics and Quality of power, pp. 1-5, 2008.

[30]

S. P. Pokharel, S. Brahma, “Optimal PMU placement for fault location in a power system,” North American Power Symposium (NAPS), pp. 1-5, 2009.

[31]

W. Pedrycz, Knowledge-Based Clustering - From Data to

Information Granules, John Wiley & Sons, 2005.

[32]

A. Zehtabian, H. Hassanpour, A Non-destructive Approach for Noise Reduction in Time Domain, World Applied Sciences Journal 6 (1) (2009) 53-63.

[33]

M. Muller, Information Retrieval for Music and Motion, Ch. 4, Springer, 2007.

[34]

P. Senin, Dynamic Time Warping Algorithm Review, University of Hawaii, 2008.

[35]

D. T. Pham, A. Ghanbarzadeh, E. Koç, S. Otri , S. Rahim , M. Zaidi, The Bees Algorithm – A Novel Tool for Complex Optimisation Problems. Intelligent Production Machines and Systems. D.T. Pham, E.E. Eldukhri and A.J. Soroka (eds) . Cardiff University, Manufacturing Engineering Centre, Cardiff, UK. Published by Elsevier Ltd. 2006.

[36]

Pham, D.T., Castellani, M., 2009. The Bees Algorithm – modeling foraging behaviour to solve continuous optimization problems. Proc. ImechE, Part C 223 (12), 2919–2938.

[37]

Seeley, T.D., 1996. The Wisdom of the Hive: The Social Physiology of Honey Bee Colonies. Harvard University Press, Cambridge, Massachusetts.

[38]

A.A. Fahmy, Using the Bees Algorithm to select the optimal speed parameters for wind turbine generators, Journal of King Saud University - Computer and Information Sciences, Vol. 24, No. 1, pp. 17–26, January 2012.

[39]

P. M. Anderson and A. A. Fouad, Power System Control and Stability: Galgotia publications, 1981.