Investigation on Composition and Microstructural Morphology of the Fe-B-C Hardfacing Layers

Subject Areas : Journal of Environmental Friendly Materials

M. R. Tavakoli Shoushtari ¹

1 - Department of Materials Science and Engineering, Faculty of Engineering, Shahid Chamran University of Ahvaz, Iran

Received: 2018-08-12 Accepted : 2019-01-04 Published : 2019-03-15

Keywords:

Abstract :

The application of hardfacing materials for producing wear-resistant coatings on components working in wear conditions is one of the important advices in environmental protection and increasing the service life of engineering equipment. In this study, the microstructure of the hardfaced layers made by two cored wires containing Fe-B and Fe-B-C powder-based were investigated. ST37 plain carbon steel was used as the substrate and the deposition of the hardfaced layers was conducted by the flux cored arc welding (FCAW) process under single-, two-, and three-pass conditions. The microstructural and phase analyses were carried out by field emission scanning electron microscopy (FE-SEM) and X-ray diffraction (XRD), respectively. The results showed that the characteristic microstructures of the Fe-B hardfacing alloy layers comprised a matrix containing elliptical dendritic ferrite and the eutectic of (α-Fe2B). But, the Fe-B-C hardfacing alloy layers included columnar-like Fe2B, skeletal-like Fe2B, daisy like Fe3(C, B) and the eutectic of (P-Fe2B).

References:

[1] I. Kováč, R. Mikuš, J. Žarnovský, R. Drlička, J. Žitňanský and A. Výrostková, Kovove. Mater., 2014, 52, 387.

[2] J. Gou, Y. Wang, J. Sun and X. Li, J. Alloys Compd., 2017, 713, 255.

[3] J. Gou, P. Lu, Y. Wang, S. Liu and Z. Zou, Alloy. Appl. Surf. Sci., 2016, 360, 849.

[4] J. H. Kim, K. H. Ko, S. D. Noh, G. G. Kim and S. J. Kim, Alloys. Wear, )267(2009, 1415.

[5] L. Rovatti, J. N. Lemke, A. Emami, O. Stejskal and M. Vedani , J. Mater. Eng. Perform., 2015, 24, 4755.

[6] K. Gunther, J. P. Bergmann and D. Surf. Coat. Technol., 2018, 334, 420.

[7] E. O. Correa, N. G. Alcântara, L. C. Valeriano, N. D. Barbedo and R. R. Chaves, process. Surf. Coat. Technol., 2015, 276, 479.

[8] N. Yuksel and S. Sahin, Mater. Des., 2014, 58,  491.

[9] A. Gualco, H. G. Svoboda and E. S. Surian, Wear, 2016, 360-361, 14.

[10] M. H. Amushahi, F. Ashrafizadeh and M. Shamanian, processes. Surf. Coat. Technol., 2010, 204, 2723.

[11] I. Manna, J. D. Majumdar, B. R. Chandra, S. Nayak and N. B. Dahotre, Steel. Surf. Coat. Technol., 2006, 201, 434.

[12] W. Xibao, W. Xiaofeng and S. Zhongquan, Surf. Coat. Technol., 2005, 192, 257.

[13] R. Zahiri, R. Sundaramoorthy, P. Lysz and C. Subramanian, Surf. Coat. Technol., 2014, 260, 220.

[14] J. J. Coronado, H. F. Caicedo and A. L. Gomez, deposits. Tribol Int., 2009, 42, 745.

[15] V. V. Kozyrev, M. Petrov, L. G. Yu, and L. V. Kozyreva, Technologies. Weld Int., 2016, 30, 895

[16] J. N. Lemke, L. Rovatti, M. Colombo and M. Vedani, Alloys. Mater. Des., 2016, 91, 368.

[17] K. Yang, Y. Gao, K. Yang, Y. Bao and Y. Jiang, Addition. Wear, 2017, 376-377, 1091.

[18] A. Gualco, H. G. Svoboda, E. S. Surian, Weld Int., (19)2016, 255.

[19] H. Sabet, Sh. Khierandish, S. Mirdamadi and M. Goodarzi, Tribol Lett., (44)2011, 237.

[20] M. Zhuang, L. Li, J. Wang, S. Ma and S. Yuan, Microstructure and Alloys. J. Mater. Eng. Perform., (26)2017, 6182.

[21] D. Yi, J. Xing, H. Fu, Z. Zhang, J. Chen, J. Zhang, J. Peng and Y. Shi, Cast alloy. CHINA FOUNDRY, (14)2017, 145.

[22] J. Zhang, Y. Gao, J. Xing, S. Ma, D. Yi and J. Yan, Cast Alloy. Tribol Lett., (44)2011, 31.

[23] Y. Jian, Z. Huang, J. Xing and B. Wang, crystals. Mater. Charact., (110)2015, 138.

[24] L. G. Yu, X. J. Chen, K. A. Khor and G. Sundararajan, Acta Mater., (53)2005, 2361.

[25] M. Eroglu. Surf. Coat. Technol., (203)2009, 2229.

[26] Y. Jian, Z. Huang, J. Xing, B. Zheng, L. Sun,Y. Liu and Y. Liu, Tribol Int., (101)2016, 331.

[27] A. Motallebzadeh, E. Dilektasli, M. Baydogan, E. Atar and H. Cimenoglu, Evaluat. Wear., (328-329)2015, 110.

[28] Z. Huang, J. Xing and C. Guo, Addition. Mater. Des., (31)2010, 3084.

[29] D. Yi, J. Xing, Z. Zhang, H. Fu and C. Yang, Cast Alloys. Tribol. Lett., (54)2014, 107.

[30] Y. K. Singla, N. Arora and D. K. Dwivedi, A Statistical Analysis. Tribol. Int., (105)2017, 229.

[31] Y. Dawei, X. Jiandong, F. Hanguang, M. Shengqiang and L. Zhuxin, Cast Alloy. Key Eng. Mater., (457)2011, 213.

[32] Z. Huang, J. Xing and L. Lv, Cast Alloy. Mater. Charact., (75)2013, 63.