-
المقاله
1 - Transient Stability Improvement of a Hybrid Power System: A Novel Configuration of Compensating Type Custom Power Devices and Fault Current Limiters.Shahab Khormali Salman Amirkhan Ramin Mokhtari Hassan Pourvali Souraki Tatiana Kovacikova masoud radmehr Azadeh Sadat Naeimiسیستم های پویای کاربردی و کنترل , العدد 1 , السنة 6 , زمستان 2023Applying distributed energy resources (DERs) to power systems has been promoted as a promising option to meet the growing electricity demand. Despite significant economic, environmental, and resiliency benefits, integrating DER, including power electronic devices, into أکثرApplying distributed energy resources (DERs) to power systems has been promoted as a promising option to meet the growing electricity demand. Despite significant economic, environmental, and resiliency benefits, integrating DER, including power electronic devices, into the existing power networks causes stability and power quality issues. Therefore, to meet stability and power quality standard limits, a sort of compensation using cost-effective and energy-efficient technologies and power electronics-based concepts is needed. This paper presents a novel configuration of compensating type custom power devices (CPDs) and fault current limiters (FCLs) for limiting balanced and unbalanced faults and improving the transient performance of distributed generation (DG) sources in a hybrid power system. Moreover, three power grid operational scenarios are addressed to reflect the impact of the type of fault and variable power generation capacity of DGs on transient stability. Four configurations are implemented using two FCLs (BFCL and SFCL) and two energy compensation devices (DVR and UPQC). The transient performance of involved DGs with and without applying proposed compensation methods is simulated. Simulation experiments were carried out using MATLAB/SIMULINK software. The simulation results indicate that UPQC- BFCL is the best solution in all scenarios that improve the transient stability of the proposed power system under both balanced and unbalanced faults. تفاصيل المقالة -
المقاله
2 - Improvement of Power System Stability with Salp Swarm Algorithm and Fuzzy Type IIسیستم های پویای کاربردی و کنترل , العدد 1 , السنة 4 , بهار 2021The use of renewable resources in the power system is increasing day by day. Wind energy is one of the forms of renewable energy sources that has been widely available to humans due to the common nature of renewable energy with low concentration (low density). Due to th أکثرThe use of renewable resources in the power system is increasing day by day. Wind energy is one of the forms of renewable energy sources that has been widely available to humans due to the common nature of renewable energy with low concentration (low density). Due to the constant changes of wind and as a result of changes in the power produced by wind farms, uncertainty in the power of the power system will become an integral part. Now, if the permeability of these resources increases, they can directly affect the dynamic stability of the system and the margin of stability of the system will change in power systems expansion, instability was often due to a lack of synchronizing torque. Issues such as the small perturbation stability of local oscillation modes and low-frequency inter-zone oscillation modes became apparent with a significant improvement in power system performance. The paper presents an optimal and coordinated power oscillation damper based on a wind turbine and power system stabilizer (PSS) to maintain the stability of power system and damp inter-area oscillations. The optimal and coordinated design of the PSS located at the generator site and the damper installed in the control section of the doubly-fed induction generator (DFIG) is defined as an optimization problem. تفاصيل المقالة