In this paper, the present investigation has been conducted keeping in mind some of the problems concerning the crack propagation direction and growth under constant loading in an inclined crack geometry. The present studies mainly focused on the development and modifications in the crack growth criterion to account the biaxial, shear loading and number of stress terms. Existing criteria for the prediction of crack initiation direction have been modified taking higher order stress terms. The effective methods of experimentally determining the stress intensity factor for a body containing a crack is to analyze the isochromatic pattern obtained from a photoelastic model. The effect of biaxial load factor, crack angle, Crack length/width of specimen and length of specimen/width of specimen were studied and a regression model was developed for geometry correction to predict stress intensity factor for tearing mode and intensity factor for shearing mode. This approach is being used to predict crack growth trajectory under biaxial cyclic loading by assuming that the crack may grow in a number of discrete steps using the vectorial method. MTS criterion (Maximum Tangential Stress criterion) is used for prediction of crack initiating angle. The crack growth trajectory has been determined by cycle simulation procedure. تفاصيل المقالة

A two dimensional finite model with inclined crack at different crack angles are being analyzed in mixed mode condition using photo elasticity method for the determination of Stress Intensity Factors. The well-known Sih’s equation and three points deterministic approach is used for the determination of stress intensity factors. The effects of biaxial load factor, crack angle, size factors were studied and a regression model was developed for geometry correction to predict Stress Intensity Factors. The results give a good compromise to the theoretical one. The experimental result also gives significant data for the two dimensional mixed mode loading conditions. تفاصيل المقالة