The vibratory finishing is one of the important mass finishing processes. This can be applied for finishing many metallic and non- metallic components using abrasive materials such as steel, ceramic, natural materials and etc. The vibratory finishing process is used for some purposes such as surfaces polishing, deburring, oxide layer removing and rounding the edges. Evaluation of surface roughness changes with time that is one of the important parameters during the vibratory finishing process. In this study, the effects of the working time and abrasive materials are investigated on the surface roughness changes of CK45 steel samples. The ceramic, glass and mixed abrasive particles are used as the abrasive media. The experiments are performed at different time from 10 to 120 minutes in the dry environment. Finally, the surface roughness values of samples were measured and then fitted by a regression equation for description of the surface roughness changes with time. According to the results, the maximum surface finish was obtained after 120 minutes by using mixed abrasive materials. The surface roughness improved approximately 60%. تفاصيل المقالة

Barrel finishing is a common technique for surface finishing of industrial parts. Many factors such as working time, abrasive media, initial roughness and machining parameters of rotary barrel affect the final surface roughness of workpieces. Analysing these input parameters in order to obtain the least surface roughness as well as the least working time for barrel finishing of the specific samples, is not possible except by applying Design of Experiments method. Thus, the aim of the present paper is to improve the surface quality of the steel alloy CK45 samples in barrel finishing process, by investigating different combination of three abrasive particles including ceramics, steel balls and aluminium oxide as the abrasive media through design of experiments method. Initial roughness, working time and the combination of abrasive media are the input factors in the designed experiments, while the surface roughness is the output factor. Results show that the best surface roughness and working time have been achieved with the specific combination of steel balls and aluminium oxide particles as the abrasive media. تفاصيل المقالة

Formation of the burrs in the industrial parts after manufacturing processes such as blanking, punching, machining, cutting and etc. is inevitable. The burring phenomenon decreases the geometrical and dimensional tolerance and makes assembling parts together difficult. Radiusing the corners of workpieces is a common technique to reduce the stress concentrations at corners and also facilitate their assembly. By means of barrel finishing, a number of workpieces undergo deburring and radiusing coincidently in one process. In barrel finishing which is one of the mass finishing techniques, many workpieces with abrasive media are loaded in a rotary barrel. By rotation of the barrel, the parts and abrasive media are collided to each other and rub themselves, resulting in deburring and polishing the workpieces. The working time of this process is normally long. The aim of this study is to decrease the working time by using proper abrasive media. Here, a number of experiments is designed on combination of three abrasive media: steel balls, ceramics and aluminum oxide particles, in different working periods, to achieve appropriate radius and reducing burrs height of CK45 steel alloy samples in reduced working time. تفاصيل المقالة