Numerical Study of Effective Parameters in the Deep Drawing Process of a Cylindrical Cup and Comparison with Experimental Results
الموضوعات :
Hamidreza Gharehchahi
1
,
Mohammad Javad Kazemzadeh-Parsi
2
,
Ahmad Afsari
3
,
Mehrdad Mohammadi
4
1 - Ph.D. Student, Department of Mechanical Engineering, Shiraz Branch, Islamic Azad University, Shiraz, Iran
2 - Associate Professor, Department of Mechanical Engineering, Shiraz Branch, Islamic Azad University, Shiraz, Iran
3 - Associate Professor, Department of Mechanical Engineering, Shiraz Branch, Islamic Azad University, Shiraz, Iran
4 - Assistant Professor, Department of Mechanical Engineering, Shiraz Branch, Islamic Azad University, Shiraz, Iran
الکلمات المفتاحية: numerical simulation, Finite Element Method, Deep drawing, Metal forming,
ملخص المقالة :
Today, metal forming is considered one of the essential methods of manufacturing and producing parts. Therefore, the more accurate knowledge of it leads the industrialists to produce higher quality parts. Deep drawing is one of the most important methods in metal forming processes used to produce cup-shaped products. In this paper, numerical simulation of the deep drawing process based on the finite element method is performed using Abaqus software for a cylindrical cup. Then, the results obtained from numerical simulation are compared with the experimental results in the sources, and the validation of the simulation is performed. In the deep drawing process, effective parameters such as circumferential strain distribution, thickness strain distribution, and radial force distribution are extracted from numerical simulations and compared with experimental results in the sources. The effect of friction coefficient, blank holder force, and punch radius on the deep drawing process has also been investigated. Because experimental methods based on trial and error are time-consuming and costly to achieve the shape of the primary blank, researchers use numerical methods to simulate and design metal sheet forming processes such as deep drawing. It is necessary to compare the results with experimental works to validate the simulations performed by numerical methods.
[1] Woo, DM. 1968. On the complete solutions of the deep drawing problem. International Journal of Mechanical Sciences. 10(2):83–94.
[2] Swift, H. W. Plastic bending under tension. Engineering.166:333-359.
[3] Park, S. H., Yoon, J. W., Yang, D. Y. and Kim, Y.H. 1999. Optimum blank design in sheet metal forming by the deformation path iteration method. International Journal of Mechanical Sciences. 41(10):1217-1232.
[4] Son, K. and Shim, H. 2003. Optimal blank shape design using the initial velocity of boundary nodes. Journal of Material Processing Technology. 134(1):92–98.
[5] Hammami, W., Padmanabhan, R., Oliveira, M. C., BelHadjSalah, H., Alves, J. L., Menezeset, L. F. 2009. A deformation based blank design method for formed parts. International Journal of Mechanics and Materials in Design. 5(4):303-314.
[6] Fazli, A. and Arezoo, B. 2012. A comparison of numerical iteration based algorithms in blank optimization. Finite Element in Analysis and Design. 50:207-216.
[7] Itoh, T. 1989. Numerical Techniques for Microwave and Millimeter and Millimeter-Wave Passive Structures. Second Edition, New York: Wiley.
