Experimental Investigation on the dissimilar laser weld joints between Inconel 625 Superalloy and AISI 430 Ferritic Stainless Steel
الموضوعات :
Hossein Mostaan
1
(Arak University)
Mahdi Rafiei
2
(Advanced Materials Research Center, Department of Materials Engineering, Najafabad Branch, Islamic Azad University, Najafabad, Iran.)
Mohammad Emadi
3
(Advanced Materials Research Center, Department of Materials Engineering, Najafabad Branch, Islamic Azad University, Najafabad, Iran.)
الکلمات المفتاحية: Optimization, Inconel 625, Laser Welding, Dissimilar joint, 430 ferritic stainless steel,
ملخص المقالة :
Mechanical properties optimization of weldment such as tensile strength, microhardness and impact toughness are of prime importance in welding technology. The main aim of this research is to investigate the microstructural evolutions and also optimization of tensile strength in dissimilar laser welding between Inconel 625 superalloy and AISI 430 ferritic stainless steel. It was found from the microhardness measurements that the hardness is increased form AISI 430 base metal toward Inconel 625 superalloy. This can be attributed to the inherent higher hardness of Inconel 625 and formation of very fine structure and also fine precipitations in the weld metal which are distributed uniformly. Formation of very fine structure and precipitations is due to the rapid cooling rate of the weld metal during laser welding process. Design of experiment based on the response surface method was used in order to optimize the tensile strength of the weld joints. Three process parameters i. e. pulse duration, lamping current and also travel speed were chosen as the main parameters which are considerably affecting the tensile strength of the weld joint. It was found that the lamping current has a higher impact on the tensile strength of the weld joints.
