Modal and Aeroelastic Analysis of A High-Aspect-Ratio Wing with Large Deflection Capability
الموضوعات :
R. Koohi
1
(Department of, Mechanical and Aerospace Engineering, Science and Research Branch, Islamic Azad University, Tehran, Iran)
H. Shahverdi
2
(Department of Aerospace Engineering and Center of Excellence in Computational Aerospace, Amirkabir University of Technology, Tehran, Iran)
H. Haddadpour
3
(Department of Aerospace Engineering,
Sharif University of Technology, Tehran, Iran)
الکلمات المفتاحية: FEM, Jone's Approximate Unsteady Aerodynamics, Wing Aeroelastic Stability, Large Deflection,
ملخص المقالة :
This paper describes a modified structural dynamics model for aeroelastic analysis of high-aspect-ratio wings undergoing large deformation behavior. To gain this aim, a moderate deflection beam model is modified with some important large deflection terms and then coupled with a state space unsteady aerodynamics model. Finite element method is used to discretize the equations of motion. A dynamic perturbation equation about a nonlinear static equilibrium is applied to determine the flutter boundary. The obtained results show good agreement in comparison with the other existing data such as high-altitude long-endurance (HALE) wing and Goland wing. It is found that the present aeroelastic tool have a good agreement in comparison with valid researches and also considering the effect of the geometric structural nonlinearity and higher order nonlinear terms on the flutter boundary determination is very significant.
[1] Hodges, D. H., Dowell, E., “Nonlinear Equations of Motion for the Elastic Bending and Torsion of Twisted Non uniform Rotor Blades”, NASA TN D-7818, 1974.
[2] Dowell, E., Traybar, J., and Hodges, D. H., “An Experimental-Theoretical Correlation Study of Nonlinear Bending and Torsion Deformations of a Cantilever beam”, Journal of Sound and Vibration, Vol. 50, 1977, pp. 533-544.
[3] Hodges, D. H., Crespo da Silva, M., and Peters, D., “Nonlinear Effects in the Static and Dynamic Behavior of Beams and Rotor Blades”, Vertica, Vol. 12, No. 3, 1988, pp. 243-256.
[4] Rosen, A., Freidmann, P. P., “The Nonlinear Behavior of Elastic Slender Straight Beams Undergoing Small Strains and Moderate Rotations”, Journal of Applied Mechanics, Vol. 46, 1979, pp. 161-168.
[5] Crespo da Silva, M., Glynn, C., “Nonlinear Flexural-Flexural-Torsional Dynamics of Inextensional Beams-I. Equations of Motions”, Journal of Structural Mechanics, Vol. 6, No. 4, 1978, pp. 437-448.
[6] Crespo da Silva, M., Glynn, C., “Nonlinear Flexural-Flexural-Torsional Dynamics of Inextensional Beams-I. Forced Motions”, Journal of Structural Mechanics, Vol. 6, No. 4, 1978, pp. 449-461.
[7] Pai, P., Nayfeh, A., “Three-Dimensional Nonlinear Vibrations of Composite Beams-I. Equations of Motion”, Nonlinear Dynamics, Vol. 1, 1990, pp. 477-502.
[8] Hodges, D. H., “A Mixed Variational Formulation Based on Exact Intrinsic Equations for Dynamics of Moving Beams”, International Journal of Solids and Structures, Vol. 26, No. 11, 1990, pp. 1253-1273.
[9] Tang, D., Dowell, E., “Experimental and Theoretical Study on Aeroelastic Response of High-Aspect-Ratio Wings”, AIAA Journal, Vol. 39, No. 8, 2001, pp. 1430-1441.
[10] Tang, D., Dowell, E., “Effects of Geometric Structural Nonlinearity on Flutter and Limit Cycle Oscillations of High-Aspect-Ratio Wings”, J Fluid Structure, Vol. 19, 2004, pp. 291-306.
[11] Patil, M. J., Hodges D. H., and Cesnik, C. E. S., “Nonlinear Aeroelasticity and Flight Dynamics of High-Altitude, Long-Endurance Aircraft”, Journal of Aircraft, Vol. 38, No. 1, 2001, pp. 88-94.
[12] Patil, M. J., Hodges, D. H., and Cesnik, C. E. S., “Nonlinear Aeroelastic Analysis of Complete Aircraft in Subsonic Flow”, Journal of Aircraft, Vol. 37, No. 5, 2000, pp. 753-760.
[13] Patil, M. J., Hodges, D. H., “Limit-Cycle Oscillations in High-Aspect-Ratio Wings”, J Fluids Structure, Vol. 15, 2001, pp. 107-132.
[14] Yuan, K. A., Friedmann, P. P., “Aeroelasticity and Structural Optimization of Composite Helicopter Rotor Blades with Swept Tips”, NASA CR 4665, 1995.
[15] Yuan, K. A., Friedmann, P. P., “Structural Optimization for Vibratory Loads Reduction of Composite Helicopter Rotor Blades with Advanced Geometry Tips”, Journal of the American Helicopter Society, Vol. 43, No. 3, 1998, pp. 246-256.
[16] Friedmann, P. P., Glaz, B., and Palacios, R., “A Moderate Deflection Composite Helicopter Rotor Blade Model with an Improved Cross-Sectional Analysis”, International Journal of Solids and Structures, Vol. 46, 2009, pp. 2186-2200.
[17] Hodges, D. H., “Nonlinear Composite Beam Theory”, AIAA, Reston, VA, 2006.
[18] Hodges, D. H., Yu, W., “A Rigorous, Engineer-Friendly Approach for Modeling Realistic, Composite Rotor Blades”, Wind Energy, Vol. 10, 2007, pp. 179-193.
[19] Murugan, S., Ganguli, R., and Harursampath, D., “Effects of Structural Uncertainty on Aeroelastic Response of Composite Helicopter Rotor”, 48th AIAA/ASME/ASCE/AHS/ACS Structures, Structural Dynamics and Materials Conference, Honolulu, HI, AIAA Paper 2298, 2007, pp. 1-18.
[20] Patil, M. J, Hodges, D. H., “On the Importance of Aerodynamic and Structural Geometrical Nonlinearities in Aeroelastic Behavior of High-Aspect-Ratio Wings”, Journal of Fluids and Structures, Vol. 19, 2004, pp. 905-915.
[21] Librescu, L., Chiocchia, G., and Marzocca, P., “Implications of Cubic Physical/Aerodynamic Non-linearities on the Character of the Flutter Instability Boundary”, International Journal of Non-linear Mechanics, Vol. 38, 2003, pp. 173-199.
[22] Ghadiri, B., Razi, M., “Limite Cycle Oscillations of Rectangular Cantilever Wings Containing Cubic Nonlinearity in an Incompressible Flow”, Journal of solid and structures, Vol. 23, 2007, pp. 665-680.
[23] Hodges, D. H., “Nonlinear Equations for Dynamics of Pretwisted Beams Undergoing Small Strains and Large Rotations”, NASA TP 2470, 1985.
[24] Razavi Kermanshahi, M., Lotfi Neyestanak, A. A., “Exact Vibration and Buckling Solution of Levy Type Initially Stressed Rectangular Thin Plates”, Int J Advanced Design and Manufacturing Technology, Vol. 6, No. 4, 2013, pp. 65-73.
[25] Karbaschi, K., Hasanzadeh, H., “Numerical Analysis of Plate’s Vibration Behavior with Non-linear Edge under Various Boundary Conditions”, Int J Advanced Design and Manufacturing Technology, Vol. 1, No. 2, 2008, pp. 52-65.
[26] Kargarnovin, M. H., Karbaschi, K., and Hasanzadeh, H., “Numerical Study of Increasing Error Order in Finite Difference Method Used for Analyzing the Rectangular Isotropic Plate's Vibration Behavior”, Int J Advanced Design and Manufacturing Technology, Vol. 1, No. 2, 2008, pp. 1-9.
[27] Greenberg, J. M., “Airfoil in Sinusoidal Motion in a Pulsating Stream”, NACA TN 1326, 1947.
[28] Peters, D. A., Cao, W. M., “Finite State Induced Flow Models Part I: Two Dimensional Thin Airfoil”, Journal of Aircraft, Vol. 32, No. 2, 1995, pp. 313-322.
[29] Patil, M. J. “Aeroelastic Tailoring of Composite Box Beams”, In Proceedings of the 35th Aerospace Sciences Meeting and Exhibit, Reno, Nevada, 1997.
