Design of a fuzzy adaptive controller for a ducted fan (UAV)
الموضوعات : فصلنامه شبیه سازی و تحلیل تکنولوژی های نوین در مهندسی مکانیک
1 - Department of Electrical Engineering
Dehagh Branch, Islamic Azad university, Dehagh, Iran
الکلمات المفتاحية: Fuzzy controller, Ducted Fan UAV, Dynamic Model,
ملخص المقالة :
Vertical take-off and landing (VTOL) unmanned aircrafts have many applications due to their floating capability, their ability in vertical take-off and landing and flying in limited areas. Since providing a safe flight without causing any damages whether to itself or its surrounding environment is very important for this vehicle, a particular kind of VTOL aircraft is presented in this article which satisfies the above-mentioned requirement. To increase safety, a cylindrical chamber called duct is used around the propellers. This enhances the efficiency of the system while reducing losses, increasing the thrust, decreasing noises, and improving the safety of the aircraft and its surrounding area. Moreover, aerodynamic characteristics of the aircraft are modified. This vehicle is applied in indoor environments. In this research, firstly, aerodynamical and mechanical design of a kind of VTOL aircrafts called ducted fan is accomplished. Then, the desired controller is designed and the simulations results are given. Finally, the proposed scheme is improved and implemented on which navigation and control systems are installed, and many practical experiments are performed. In order to control the vehicle, optimization techniques are used, and the desired properties are evaluated
[1] Zhao, H.W., Bil, C, “Aerodynamic Design and Analysis of a VTOL Ducted-Fan UAV,” 26th AIAA Applied Aerodynamics Conference, 18- 21 Aug 2008.
[2] Chung Chang, I., Rajagopalan, R., “CFD Analysis for Ducted Fanswith Validation,” 21st AIAA Applied Aerodynamics Conference, 23-26 June 2003.
[3] Spaulding, M., Mansur, H., Tischler, B., Hess, R., Franklin, A., “Non-linear Inversion Control for a Ducted Fan UAV,”AIAA Atmospheric flight mechanics conference and exhibit,15-18 AUG 2005:p.pp.1-26.
[4] Zhao, H.W., Bil, C., “Ducted Fan VTOL UAV Simulation in Pre-liminary Design,”9TH AIAA viation technology,and operations conference(ATIO),21-23 sep 2009.
[5] Anderson, J. D., “Fundamentals of Aerodynamics,” 4th Edition, McGraw-Hill, New York, 2007.
[6] Demasi, L., “Investigation on Conditions of Minimum Induced Drag of Closed Wing Systems and C-Wings,” Journal of Aircraft, Vol.44, No.1, January-February 2007, pp.81-99.
[7] Yu Li, Chen Guoding., “Robust Control of Uncertain Linear System with Disk Pole Constraints, ” Acta utomatica Sinca 2000, Vol, No. 1,pp. 116-120
[8] Jonathan Fleming and Troy Jones., “Improving control system effectiveness for ducted fan VTOL UAVs operating in crosswinds,”2nd AIAA“Unmanned Unlimited ” systems.Technologies,and operations.Aerospace, 15-18 september 2003,San Diego,California.
[9] PhD thesis, Roberto Naldi, 2008., “Prototyping, Modeling and Control of a Class of VTOL Aerial Robots”. PhD Thesis, University of Bologna, Italy.
[10] Iain K. Peddle, Thomas Jones, Johann Treurnicht, 2008., “Practical near hover flight control of a ducted fan (SLADe)”. Journal of Control Engineering Practice, 17, pp. 48-58.
[11] S. Saripalli, J.F. Montgomery and G.S. Sukhatme., “Vision-based Autonomous Landing of an Unmanned Aerial Vehicle”, IEEE Inter-national Conference on Robotics and Au tomation, pp 2799-2804, May2002., Washington D.C., USA
[12] B.G. Crawford, D.R. Downing., “Design and Evaluation of an Autonomous, Obstacle Avoiding, Flight Control System Using Simulated Visual Sensors”, AIAA, 2004-6576
[13] Tal Shima, Steven Rasmussen., “UAV Cooperative Decision and Control, ” Siam, Philadelphia, USA.2009.
[14] E. Frew, T. Mc Gee, Zu Whan Kim, Xiao Xiao, S. Jackson, M.Morimoto, S. Rahinam, J. Padial, R. Dengupta, , “Vision-Based Road-Following Using a Small Autonomous Aircraft, ”IEEEAC paper#1479,2004.
