Doping TiO2 by Cr from tannery wastewater for improving its activity under visible light in the dye degradation

الموضوعات : Iranian Journal of Catalysis

Endang Wahyuni ¹ ( Chemistry Department, Faculty of Mathematics and Natural Sciences, Yogyakarta, Universitas Gadjah Mada Sekip Utara POB Bls 21, Yogyakarta, Indonesia, 55284 )
Sri Wahyuni ² ( Chemistry Department, Faculty of Mathematics and Natural Sciences, Yogyakarta, Universitas Gadjah Mada Sekip Utara POB Bls 21, Yogyakarta, Indonesia, 55284 )
Mandrea Nora ³ ( Chemistry Department, Faculty of Mathematics and Natural Sciences, Yogyakarta, Universitas Gadjah Mada Sekip Utara POB Bls 21, Yogyakarta, Indonesia, 55284 )
Novianti Lestari ⁴ ( Chemistry Department, Faculty of Mathematics and Natural Sciences, Yogyakarta, Universitas Gadjah Mada Sekip Utara POB Bls 21, Yogyakarta, Indonesia, 55284 )
Suherman Suherman ⁵ ( Chemistry Department, Faculty of Mathematics and Natural Sciences, Yogyakarta, Universitas Gadjah Mada Sekip Utara POB Bls 21, Yogyakarta, Indonesia, 55284 )

تاريخ الإرسال : 06 الأربعاء , جمادى الأولى, 1444 تاريخ التأكيد : 22 الجمعة , شوال, 1444 تاريخ الإصدار : 13 السبت , ذو الحجة, 1444

الکلمات المفتاحية: TiO2, Cr, doping, Photodegradation, Congo red dye, Tannery wastewater,

ملخص المقالة :

This paper deals with the comparison of the Cr (III) dopant from tannery wastewater to the Cr (III) from the pure salt solution on the character and activity of TiO2. The doping was conducted by hydrothermal method, and the Cr-doped TiO2 prepared was characterized by UV specular reflectance (SRUV), X-ray diffraction (XRD), and X-ray fluorescence instruments. The effect of the Cr (III) doping on the activity of the TiO2 was evaluated by Congo red photodegradation. The research results reveal that Cr (III) doping on TiO2 has been successfully reducing remarkably the band gap energy (Eg) from 3.13 eV to 2.64 eV, shifting into the visible region, and further noticeably improving TiO2 activity. The effect of the Cr (III) doping from the wastewater is found to be slightly higher than that of the salt solution. The highest degradation of 10 mg/L Congo red in 50 mL solution, can be reached by applying 30 mg of the photocatalyst in 60 mins and at pH 7.

المصادر:

[1]        A. Eslami, M.M. Amini, A.R. Yazdanbakhsh, A. Mohseni-Bandpei, A.A. Safari, A. Asadi, J. Chem. Technol. Biotechnol. 91 (2016) 2693–2704.

[2]        X. Zhu, D. Zhou, L. Cang, Y. Wang, J. Soils Sediments 12 (2012) 376–385.

[3]        M.L.P. Dalida, K.M.S. Amer, C.C. Su, M.C. Lu, Environ. Sci. Pollut. Res. 21 (2014) 1208–1216.

[4]        S. Wu, H. Hu, Y. Lin, J. Zhang, Y.H. Hu, Chem. Eng. J. 382 (2020) 122842.

[5]        M. Shaban, A.M. Ahmed, N. Shehata, M.A. Betiha, A.M. Rabie, J. Colloid Interface Sci. 555 (2019) 31–41.

[6]        R. Kaur, P. Singla, K. Singh, Int. J. Environ. Sci. Technol. 15 (2018) 2359–2368.

[7]        M.L. Matias, A. Pimentel, A.S. Reis-Machado, J. Rodrigues, J. Deuermeier, E. Fortunato, R. Martins, D. Nunes, Nanomaterials 12 (2022) 1–23.

[8]        S. Sood, A. Umar, S. Kumar, S. Kumar, J. Colloid Interface Sci. 450 (2015) 213–223.

[9]        H. Lee, H.S. Jang, N.Y. Kim, J.B. Joo, J. Ind. Eng. Chem. 99 (2021) 352–363.

[10]      K.P. Suwondo, N.H. Aprilita, E.T. Wahyuni, React. Kinet. Mech. Catal. 135 (2022) 479–497.

[11]      R.A. Saleh, O.N. Salman, M.O. Dawood, J. Nanostructures 11 (2021) 678–683.

[12]      X. Li, Z. Guo, T. He, Phys. Chem. 15 (2013) 20037–20045.

[13]      M. Asemi, S. Maleki, M. Ghanaatshoar, J. Sol-Gel Sci. Technol. 81 (2017) 645–651.

[14]      L. Yuan, X. Weng, M. Zhou, Q. Zhang, L. Deng, Nanoscale Res. Lett. 12 (2017) 597-604.

[15]      G.C. Vásquez, D. Maestre, A. Cremades, J. Ramírez-Castellanos, E. Magnano, S. Nappini, S.Z. Karazhanov, Sci. Rep. 8 (2018) 1–12.

[16]      A. Nezamzadeh, M. Khorsandi, J. Hazard. Mater. 176 (2010) 629–637.

[17]      I. Ben Jemaa, F. Chaabouni, A. Ranguis, J. Alloys Compd. 825 (2020) 153988.

[18]      W. H. Rimawi, S. Shaheen, H. Salim, Orient. J. Chem. 36 (2020) 132–138.

[19]      O.C. O, E.W. Nthiga, G.K. Muthakia, D. Onyancha, Int. J. Sci. Res. Chem. Sci. 8 (2021) 4–9.

[20]      A.Y. Ugya, X. Hua, J. Ma, Appl. Ecol. Environ. Res. 17 (2019) 1773–1787.

[21]      M. Harja, G. Buema, D. Bucur, Sci. Rep. 12 (2022) 1–18.

[22]      T. Tapalad, A. Neramittagapong, S. Neramittagapong, M. Boonmee, Chiang Mai J. Sci. 35 (2008) 63–68.

[23]      S.A. Dhahir, K.A. Al-Saade, I.S. Al-Jobouri, Anal. Chem. an Indian J. 15 (2015) 117–124.

[24]      M. Shaban, M.R. Abukhadra, S.S. Ibrahim, M.G. Shahien, Appl. Water Sci. 7 (2017) 4743–4756.

[25]      I. Mironyuk, N. Danyliuk, T. Tatarchuk, I. Mykytyn, V. Kotsyubynsky, Phys. Chem. Solid State 22 (2021) 697–710.

[26]      T.K. Roy, N.K. Mondal, Appl. Water Sci. 7 (2017) 1841–1854.

[27]      W.C. Wanyonyi, J.M. Onyari, P.M. Shiundu, Energy Procedia 50 (2014) 862–869.

[28]      E. Zhang, J. Wu, G. Wang, B. Zhang, Y. Xie, J. Nanosci. Nanotechnol. 16 (2016) 4727–4732.

[29]      P. Gharbani, S.M. Tabatabaii, A. Mehrizad, Int. J. Environ. Sci. Technol. 5 (2008) 495–500.

[30]      P.W. Koh, M.H.M. Hatta, S.T. Ong, L. Yuliati, S.L. Lee, J. Photochem. Photobiol. A Chem. 332 (2017) 215–223.

[31]      E.T. Wahyuni, S. Wahyuni, N.D. Lestari, S. Suherman, React. Kinet. Mech. Catal. 136 (2023) 1067-1084.

[32]      M. Chowdhury, M.G. Mostafa, T.K. Biswas, A. Mandal, A.K. Saha, Environ. Process. 2 (2015) 173–187.