Effect of Cross-Section Shape on Seismic Behavior of Moment Frames with CFT Columns under Near- and Far-Field Earthquakes

Subject Areas : Seismic Analysis and Design

Javad Mahdian pari ^{1 *} , Farhang Farahbod ² , alireza faroughi ³

1 - Ph.D. Candidate, Department of Civil Engineering, WT.C., Islamic Azad University, Tehran, Iran
2 - Assistant Professor, Department of Civil Engineering, WT.C., Islamic Azad University, Tehran, Iran
3 - Assistant Professor, Department of Civil Engineering, ET.C., Islamic Azad University, Tehran, Iran

Received: 2025-03-24 Accepted : 2025-04-26 Published : 2024-04-20

Keywords: Concrete-Filled Tube (CFT), Seismic Behavior, Moment-Resisting Frames, Cross-Section Shape, Finite Element Method.,

Abstract :

This study examines the effect of cross-sectional shape on the nonlinear seismic behavior of Concrete-Filled Tube (CFT) columns in moment-resisting steel frames subjected to near- and far-field earthquakes. Two-dimensional frames with varying heights were modeled using finite element analysis in ABAQUS, incorporating square, circular, and rectangular CFT columns. Nonlinear dynamic analysis was performed to evaluate seismic performance in terms of displacement, base shear, inter-story drift, and bending moment. Results show that circular CFT columns outperform others in low-rise frames, exhibiting up to 27% lower displacement and reduced drift under far-field earthquakes. In contrast, rectangular CFT columns demonstrate superior performance in mid- to high-rise frames, with up to 59% less displacement and 44% lower base shear under both near- and far-field conditions. Square sections consistently exhibited the poorest performance. Far-field earthquakes induced higher responses, with an average increase of 27-34% in bending moment. These findings underscore the critical influence of cross-sectional shape on optimizing the seismic design of CFT columns in moment frames for earthquake-prone regions.

References:

[1] Han, Y., & Bao, Y. H. (2022). Analysis on seismic performance of steel-reinforced concrete-filled circular steel tubular (SRCFST) members subjected to post-fire. Materials, 15(7), 2294. https://doi.org/10.3390/ma15072294
[2] Han, L. H. (2016). Concrete Filled Steel Tubular Structures - Theory and Practice. Science Press.
[3] Schneider, S. P., & Alostaz, Y. M. (1998). Experimental behavior of connections to concrete-filled steel tubes. Journal of Constructional Steel Research, 45(3), 321–352. https://doi.org/10.1016/S0143-974X(97)00071-8
[4] Saribas, I., Goksu, C., & Ilki, A. (2021). Shear-flexure interaction in RAC columns under simulated seismic actions. Engineering Structures, 231, 111746. https://doi.org/10.1016/j.engstruct.2020.111746
[5] Lie, T. T. (1994). Fire resistance of circular steel columns filled with bar-reinforced concrete. Journal of Structural Engineering, 120(5), 1489–1509. https://doi.org/10.1061/(ASCE)0733-9445(1994)120:5(1489)
[6] Li, X. K. (2006). Cyclic Performance of Concrete-filled Steel Tubular Columns after Exposure to Fire. PhD Thesis, Fuzhou University.
[7] Liu, J., Yu, W., Fang, Y., & Pan, Z. (2024). Experimental study on the seismic performance of concrete-filled steel tube columns with a multiple-chamber round-ended cross-section. Frontiers in Materials, 11, 1363206. https://doi.org/10.3389/fmats.2024.1363206
[8] Sun, J. X., & Gao, W. (1994). Comprehensive Fire Protection Design for Buildings. Tianjin Science and Technology Translation and Publishing Company.
[9] Zhou, Z., Gan, D., Denavit, M. D., & Zhou, X. H. (2022). Seismic performance of square concrete-filled steel tubular columns with diagonal binding ribs. Journal of Constructional Steel Research, 189, 107074. https://doi.org/10.1016/j.jcsr.2021.107074
[10] Shen, Q. H., Wang, F. Q., Wang, J. F., & Ma, X. (2022). Cyclic behaviour of cold-formed round-ended concrete-filled steel tube columns. Journal of Constructional Steel Research, 190, 107089. https://doi.org/10.1016/j.jcsr.2021.107089
[11] Ren, Z. G., Wang, D. D., & Li, P. P. (2022). Axial compressive behaviour and confinement effect of round-ended rectangular CFST with different central angles. Composite Structures, 285, 115193. https://doi.org/10.1016/j.compstruct.2022.115193
[12] Raza, A., & Kumar, J. (2022). Collapse risk-targeted seismic design of concrete-filled steel tube frame-RC core tube structures. Structures, 46, 2022. https://doi.org/10.1016/j.istruc.2022.10.048
[13] Habib, M. M., Haque, M. M., & Alam, M. M. (2023). Experimental study on seismic behavior of concrete-filled steel tube with spherical-cap gap. Advances in Civil Engineering, 2023, 9812046. https://doi.org/10.1155/2023/9812046
[14] Fang, Y., Yu, W., Liu, J., & Pan, Z. (2023). Experimental investigation on seismic behaviour of concrete-filled corrugated steel tubes under cyclic torsional loads. Engineering Structures, 279, 115578. https://doi.org/10.1016/j.engstruct.2022.115578
[15] Han, L. H., & Yang, Y. F. (2004). Dynamic behavior of joints between concrete-filled steel tubes and beams. Journal of Harbin University of Civil Engineering and Architecture, 2004.
[16] Li, W., Xu, L. F., & Qian, W. W. (2018). Seismic behavior of special shaped column composed of concrete filled steel tubes. Journal of Constructional Steel Research, 144, 153–165. https://doi.org/10.1016/j.jcsr.2018.01.018
[17] Ding, F. X., Liu, J., Liu, X. M., Zhi-wu, Y., & Yong-suo, L. (2018). Experimental investigation on hysteretic behavior of simply supported steel-concrete composite beam. Journal of Constructional Steel Research, 144, 153–165. https://doi.org/10.1016/j.jcsr.2018.01.018
[18] Sakino, K., Sun, Y. P., & Aklan, A. (1985). Effects of wall thickness of steel tube on the behavior of square tubed R/C columns. Transactions of the Japan Concrete Institute, 7, 231–238.
[19] Hu, R., Fang, Z., & Xu, B. D. (2022). Cyclic behavior of ultra-high-performance concrete shear walls with different axial-load ratios. ACI Structural Journal, 119(2), 233–246. https://doi.org/10.14359/51734339
[20] Tomii, M., Sakino, K., & Xiao, Y. (1985). Ultimate moment of reinforced concrete short columns confined in steel tube. Pacific Conference on Earthquake Engineering, 1985.
[21] JGJ/T 101-2015. Specification for Test Methods of Seismic Buildings. Architecture Industrial Press of China, 1997.
[22] Tang, Y., Wang, Y., Wu, D., Liu, Z., Zhang, H., Zhu, M., Chen, Z., Sun, J., & Wang, X. (2022). An experimental investigation and machine learning-based prediction for seismic performance of steel tubular column filled with recycled aggregate concrete. Reviews on Advanced Materials Science, 61(1), 849–872. https://doi.org/10.1515/rams-2022-0274
[23] Yang, S. L., Zhang, L., Zhang, J. W., Fu, B., Tong, G. S., & Jing, T. (2022). Seismic behavior of concrete-filled wide rectangular steel tubular (CFWRST) stub columns. Thin-Walled Structures, 181, 110138. https://doi.org/10.1016/j.tws.2022.110138
[24] Zhang, J. W., Yang, S. L., Fu, B., & Tong, G. S. (2023). Seismic performance of
wall-type concrete-filled steel tubular column with internal diaphragms. Journal of Constructional Steel Research, 205, 107879. https://doi.org/10.1016/j.jcsr.2023.107879
[25] Li, J., Chen, Z., & Zhang, X. (2024). Seismic behavior of high-strength concrete-filled steel tube columns under cyclic loading. Engineering Structures, 298, 117054. https://doi.org/10.1016/j.engstruct.2023.117054
[26] Liu, J., Zhou, x., Zhang s. (2008). Seismic behaviour of square CFT beam–columns under biaxial bending moment. Journal of Constructional Steel Research 64 (2008) 1473–1482. https://doi.org/10.1016/j.jcsr.2008.01.013