Experimental Investigation and Modeling of Bubble Departure Frequency for Nucleate Pool Boiling Heat Transfer of Pure Liquids on Flat Heater

Subject Areas : Mechanical Engineering

Samane Hamzekhani ¹ , Farhad Shahraki ² , Davood Mohebi- kalhori ³ , Mohammad Reza Fardinpour ⁴

1 - Department of Chemical Engineering, University of Sistan and Baluchestan, P.O. Box 98164-161, Zahedan, Iran
2 - Department of Chemical Engineering, University of Sistan and Baluchestan, P.O. Box 98164-161, Zahedan, Iran
3 - Department of Chemical Engineering, University of Sistan and Baluchestan, P.O. Box 98164-161, Zahedan, Iran
4 - Department of Chemical Engineering, Mahshahr Branch, Islamic Azad University, Mahshahr, Iran

Received: 2022-06-02 Accepted : 2022-09-17 Published : 2022-12-01

Keywords: response surface methodology, Bubbles Departure Frequency, Pool Boiling, Pure Liquid,

Abstract :

In the present study, the response surface methodology is used to predict the bubble departure frequency of pure liquids using experimental data. Water, ethanol and methanol pure liquids were used as the testing fluid. The effects of vapor and liquid density difference, vapor and liquid viscosity, surface tension, thermal conductivity, heat flux on the vapor bubbles departure frequency on the heat transfer of boiling pool of pure liquids were investigated by response surface methodology. The results showed that the output of the Response surface methodology had a good overlap with the data of bubbles departure frequency of pure liquids. Also, the results for the bubble departure frequency show a good overlap between the models presented by the researchers and the experimental data and have good accuracy. In this research, a new model for the prediction of vapor bubble departure frequency, based on the Buckingham theory, in nucleate boiling is proposed, which predicts the experimental data with a satisfactory accuracy (9%).

References:

• Vasei Moghadam, A., Goshayeshi, H. R., Experimental Investigation of Pool Boiling of Single Wall Carbon Nanotubes (SWCNTs) with Different Grooved Surfaces, Int J Advanced Design and Manufacturing Technology, Vol. 12, 2019, pp. 77-84.


• Gajghate, S. S., Barathula, S., Das, S., Saha, B. B., and Bhaumik, S., Experimental Investigation and Optimization of Pool Boiling Heat Transfer Enhancement Over Graphene-Coated Copper Surface, J. Therm. Anal. Calorim, Vol. 140, 2020, pp. 1393–1411.


• Hamzekhani, S., Maniavi Falahieh, M., Kamalizadeh, M. R., and Salmaninejad, M., Bubble Dynamics for Nucleate Pool Boiling of Water, Ethanol and Methanol Pure Liquids under the Atmospheric Pressure, Journal of Applied Fluid Mechanics, Vol. 8, 2015, pp. 893-898.


• Khooshehchin, M., Mohammadidoust, A., and Ghotbinasab, S., An Optimization Study on Heat Transfer of Pool Boiling Exposed Ultrasonic Waves and Particles Addition, International Communications in Heat and Mass Transfer, Vol. 114, 2020, pp. 104558.


• Sarafraz, M. M., Experimental Investigation on Pool Boiling Heat Transfer to Formic Acid, Propanol And 2- Butanol Pure Liquids the Atmospheric Pressure, Journal of Applied Fluid Mechanics, Vol. 6, 2013, pp. 73-79.


• Sitter, J. S., Snyder, T. J., Chung, T. N., and Marslon, P. L., Terrestrial and Microgravity Pool Boiling Heat Transfer from A Wire in An Acoustic Field, Int. J. Heat Transfer, Vol. 41, 1998, pp. 2143-2155.


• Hamzekani, S., Maniav Falahieh, M., and Akhbari, A., Bubble Departure Diameter in Nucleate Pool Boiling at Saturation: Pure Liquids and Binary Mixtures, Int. J. Refrigeration, Vol. 46, 2014, pp. 50-58


• Gupta, S. K, Misra, R. D., Experimental Study of Pool Boiling Heat Transfer on Copper Surfaces with Cu- Al2O3 Nanocomposite Coatings, International Communications in Heat and Mass Transfer, Vol. 97, 2018, pp. 47-55.


• Choi, G., Shim, D. I., Lee, D., Kim. B. S., and Cho, H. H., Enhanced Nucleate Boiling Using a Reduced Graphene Oxide-Coated Micropillar, International Communications in Heat and Mass Transfer, Vol. 109, 2019, pp.104331.


• Alavi Fazel, S. A., A Genetic Algorithm-Based Optimization Model for Pool Boiling Heat Transfer on Horizontal Rod Heaters at Isolated Bubble Regime, Heat Mass Transfer, Vol. 53, 2017, pp. 2731-2744


• Peebles, F. N., Garber, H. J., Studies on Motion of Gas Bubbles in Liquids, Chem. Eng. Prog, Vol. 49, 1953, pp. 88–97.


• R., Bubble Frequencies and Departure Volumes at Sub Atmospheric Pressures, AICHE J, Vol. 13, 1967, pp. 779-783


• McFadden, P. W., Grassman, P., The Relation Between Bubble Frequency and Diameter During Nucleation Pool Boiling, International Journal Heat Mass Transfer, Vol. 5, 1962, pp.169-173


• Zuber, N., Nucleate Boiling the Region of Isolated Bubbles Similarity with Natural Convection, Int. J. Heat Mass Transfer, Vol. 6, 1963, pp. 53–65.


• Ivey, H., Relationships Between Bubble Frequency Departure Diameter and Rise Velocity in Nucleate Boiling, International Journal Heat and Mass Transfer, Vol. 10,1967, pp 1023-1040.


• Stephan, K., Abdelsalam, K., Heat Transfer Correlation for Natural Convection Boiling, International Journal of Heat and Mass Transfer, Vol. 23, 1980, pp. 73-87.


• Chen, Y., Groll, M., Mertz, R., and Kulenovic, R., Bubble Dynamics of Boiling of Propane and Iso-Butane on Smooth and Enhanced Tubes, Experimental Thermal and Fluid Science, Vol. 28, 2004, pp. 171–178.


• Kim, J., Kim, M. H., On the Departure Behaviors of Bubble at Nucleate Pool Boiling, International Journal of Multiphase Flow, Vol. 32, 2006, pp. 1269–1286.


• Hamzekhani, S., Maniavi Falahieh, M., Kamalizadeh, M. R., and Salmaninejad, M., Bubble Dynamics for Nucleate Pool Boiling of Water, Ethanol and Methanol Pure Liquids under the Atmospheric Pressure, Journal of Applied Fluid Mechanics, Vol. 8, 2015, pp. 893-898.


• Sarafraz, M. M., Hormozi, F., Experimental Investigation on The Pool Boiling Heat Transfer to Aqueous Multi-Walled Carbon Nanotube Nanofluids on The Micro-Finned Surfaces, International Journal of Thermal Sciences, Vol. 100, 2016, pp. 255-266.


• Gorenflo, D., Pool Boiling. In: VDI Heat Atlas (chapter Ha), 1993.


• Alavi fazel, S. A., Roumana, S., Bubble Dynamics for Nucleate Pool Boiling of Electrolyte Solutions, J. Heat Transfer, Vol. 132, 2010, pp. 1-7.


• Mikic, B. B., Rohsenow, W. M., Bubble Growth Rates in Non-Uniform Temperature Field, progress in Heat and Mass Transfer, Vol. 2, 1969, pp. 283-293.


• Kutatelaze, S. S., Gognim, I. I., Growth Rate and Detachment Dimeter of a Vapor Bubble in Free Convection Boiling of a Saturated Liquid, High Temp, Vol. 17, 1979, pp. 667-671.


• Hamzekhani, S., Sardashti Birjandi, M. R., and Shahraki, F., Modeling and Optimization of the Bubble Detachment Diameter for a Pool Boiling System, Chem. Eng, Technol, Vol. 45, 2022, pp. 1–13.


• Muthuvelayudham, R., Viruthagir, T., Application of Central Composite Design Based Response Surface Methodology Inparameter Optimization And On Cellulase Production Using agricultural Waste, International Journal of Agricultural and Biosystems Engineering, Vol. 4, 2010, pp. 12-19.