Semiconducting properties of passive films formed on AISI 420 stainless steel in nitric acid solutions

Subject Areas : Corrosion and protection of materials

Arash Fattah-alhosseini ¹ , Mohammad Mehdi Khalvan ²

1 - Department of Engineering, Bu-Ali Sina University, Hamedan, Iran
2 - Department of Engineering, Bu-Ali Sina University, Hamedan, Iran

Received: 2013-11-09 Accepted : 2013-12-09 Published : 2013-10-01

Keywords: Stainless steel, Passive film, Mott–Schottky, Donor density,

Abstract :

This study focuses on the semiconductor properties of passive films formed on AISI 420 stainless steel immersed in four nitric acid solutions under open circuit potential (OCP) conditions. For this purpose, the passivation parameters and semiconductor properties of passive films were derived from potentiodynamic polarization and Mott–Schottky analysis, respectively. The OCP plots showed that the open circuit potential of AISI 420 stainless steel is directed towards positive amount, which are indicative of the formation of passive film and its role in increasing protectivity with time. The potentiodynamic polarization results showed that the corrosion current density of AISI 420 stainless steel increased with the increase in the concentration of solutions. Mott–Schottky analysis revealed that the existence of a duplex passive film structure composed of two oxide layers of distinct semiconductivities (n-type and p-type). Also, Mott–Schottky analysis indicated that the donor densities are in the range 1021 cm-3 and increased with solution concentration.

References:

1. X. P. Ma, L. J. Wang, C. M. Liu, S. V. Subramanian, “Microstructure and properties of 13Cr5Ni1Mo0.025Nb0.09V0.06N super martensitic stainless steel”, Mater. Sci. Eng. A, Vol. 539, 2012, pp. 271–279.


2. D. Thibault, P. Bocher, M. Thomas, “Residual stress and microstructure in welds of 13%Cr–4%Ni martensitic stainless steel”, J. Mater. Process. Tech., Vol. 209, 2009, pp. 2195–2202.


3. J.S. Kim, E.A. Cho, H.S. Kwan, “Photoelectrochemical study on the passive film on Fe”, Corros. Sci., Vol. 43, 2001, pp. 1403–1415.


4. T. Ohtsuka, H. Yamada, “Effect of ferrous ion in solution on the formation of anodic oxide film on iron”, Corros. Sci., Vol. 40, 1998, pp. 1131–1138.


5. N. Le Bozec, C. Compère, M. L’Her, A. Laouenan, D. Costa, P. Marcus, “Influence of stainless steel surface treatment on the oxygen reduction reaction in seawater”, Corros. Sci., Vol. 43, 2001, pp. 765–786.


6. N.E. Hakiki, M. Da Cunha Belo, A.M.P. Simões, M.G.S. Ferreira, “Semiconducting properties of passive films on stainless steel. Influence of the alloying elements”, J Electrochem. Soc., Vol. 145, 1998, pp. 3821–3289.


7. M. Da Cunha Belo, N.E. Hakiki, M.G.S. Ferreira, “Semiconducting properties of passive films formed on nickel-base alloys type alloy 600. Influence of the alloying elements”, Electrochim. Acta, Vol. 44, 1999, pp. 2473–2481.


8. K. Sugimoto, Y. Sawada, “The role of molibdenum additions to austenitc stainless steels in the inhibition of pitting in acid chloride solutions”, Corros. Sci., Vol. 17, 1997, pp. 425–445.


9. M. F. Montemor, A. M. P. Simões, M. G. S. Ferreira, M. Da Cunha Belo, “The role of Mo in the chemical composition and semiconductive behaviour of oxide films formed on stainless steels”, Corros. Sci., Vol. 41, 1999, pp. 17–34.


10. J. Amri, T. Souier, B. Malki, B. Baroux, “Effect of the final annealing of cold rolled stainless steels sheets on the electronfic properties and pit nucleation resistance of passive films”,  Corros. Sci., Vol. 50, 2008, pp. 431–435.


11. S. Ningshen, U. K. Mudali, V.K. Mittal, H.S. Khatak, “Semiconducting and passive film properties of nitrogen-containing type 316LN stainless steels”, Corros. Sci., Vol. 49, 2007, pp. 481–496.


12. A. M. P. Simões, M. G. S. Ferreira, B. Rondot, M. da Cunha Belo, “Study of Passive Films Formed on AISI 304 Stainless Steel by Impedance Measurements and Photoelectrochemistry”, J. Electrochem. Soc., Vol. 137, 1990, pp. 82–87.


13. I. Olefjord, L. Wegrelius, “Surface analysis of passive state”, Corros. Sci., Vol. 31, 1990, pp. 89–98.


14. S. Mischler, A. Vogel, H. Mathieu, D. Landolt, “The chemical composition of the passive film on Fe-24Cr and Fe-24Cr-11Mo studied by AES, XPS and SIMS”, Corros Sci., Vol. 32, 1991, pp. 925–944.


15. M. F. Montemor, M. G. S. Ferreira, N. E. Hakiki, M. Da Cunha Belo, “Chemical composition and electronic structure of the oxide films formed on 316L stainless steel and nickel based alloys in high temperature aqueous environments”, Corros. Sci., Vol. 42, 2000, pp. 1635–1650.


16. C. Sunseri, S. Piazza, F. Di Quarto, “Photocurrent Spectroscopic Investigations of Passive Films on Chromium”, J. Electrochem. Soc., Vol. 137, 1990, pp. 2411–2417.


17. M. J. Carmezim, A. M. Simões, M. O. Figueiredo, M. Da Cunha Belo, “Electrochemical Behaviour of thermally treated Cr-oxide films deposited on stainless steels”, Corros. Sci., Vol. 44, 2002, pp. 451–465.


18. S. Haupt, H.-H. Strehblow, “A combined surface analytical and electrochemical study of the formation of passive layers on FeCr alloys in 0.5 M H2SO4”, Corros. Sci., Vol. 37, 1995, pp. 43–54.


19. M. V. Cardoso, S. T. Amaral, E. M. A. Martini, “Temperature effect in the corrosion resistance of Ni–Fe–Cr alloy in chloride medium”, Corros. Sci., Vol. 50, 2008, pp. 2429–2436.


20. G. Ruhi, O. P. Modi, I. B. Singh, “Pitting of AISI 304L stainless steel coated with nano structured sol–gel alumina coatings in chloride containing acidic environments”, Corros. Sci., Vol. 51, 2009, pp. 3057–3063.


21. K. Azumi, T. Ohtsuka, N. Sata, “Mott-Schottky Plot of the Passive Film Formed on Iron in Neutral Borate and Phosphate Solutions”, J. Electrochem. Soc., Vol. 134, 1987, pp. 1352–1358.


22. D. D. Macdonald, K. M. Ismail, E. Sikora, “Characterization of the passive state on zinc”, J. Electrochem. Soc., Vol. 145, 1998, pp. 3141–3149.


23. Y. X. Qiao, Y. G. Zheng, W. Ke, P.C. Okafor, “Electrochemical behaviour of high nitrogen stainless steel in acidic solutions”, Corros. Sci., Vol. 51, 2009, pp. 979–986.


24. Y. Yang, L. j. Guo, H. Liu, “Effect of fluoride ions on corrosion behavior of SS316L in simulated proton exchange membrane fuel cell (PEMFC) cathode environments”, J. Power Sourc., Vol. 195, 2010, pp. 5651–5659.


25. Y. F. Cheng, C. Yang, J.L. Luo, “Determination of the diffusivity of point defects in passive films on carbon steel”, Thin Solid Films, Vol. 416, 2002, pp. 169–173.


26. N. Li, Y. Li, S. Wang, F. Wang, “Electrochemical corrosion behavior of nanocrystallized bulk 304 stainless steel”, Electrochim. Acta, Vol. 52, 2006, pp. 760–765.


27. C. Escrivà-Cerdán, E. Blasco-Tamarit, D. M. García-García, J. García-Antóna, A. Guenbour, “Effect of potential formation on the electrochemical behaviour of a highly alloyed austenitic stainless steel in contaminated phosphoric acid at different temperatures”,  Electrochim. Acta, Vol. 80, 2012, pp. 248–256.


28. N. Sato, “An overview on passivity on metals”, Corros. Sci., Vol. 31, 1990, pp. 1–19.


29. M. G. S. Ferreira, N. E. Hakiki, G. Goodlet, S. Faty, A. M. P. Simões, M. Da Cunha Belo, “Influence of the temperature of film formation on the electronic structure of oxide films formed on 304 stainless steel”, Electrochim. Acta, Vol. 46, 2001, pp. 3767–3776.


30. E. E. Oguzie, J. Li, Y. Liu, D. Chen, Y. Li, K. Yang, F. Wang, “The effect of Cu addition on the electrochemical corrosion and passivation behavior of stainless steels”, Electrochim. Acta, Vol. 55, 2010, pp. 5028–5035.


31. D. D. Macdonald, “On the existence of our metals-based civilization I. Phase-space analysis”, J. Electrochem. Soc., Vol. 153, 2006, pp. B213–B224.