فهرست مقالات Traveling speed

• دسترسی آزاد مقاله
  • صفحه چکیده
  • متن کامل
  
  1 - Effects of Friction Stir Process Parameters on Microstructure and Mechanical properties of Aluminum Powder Metallurgy Parts
  Mohsen Abbasi-Baharanchi Fathallah Karimzadeh Mohammad Hossein Enayati
  The effects of friction stir processing (FSP) on the microstructure and mechanical properties of aluminum powder metallurgy (PM) parts was investigated. PM parts were then subjected to FSP at advancing speeds (v) of 40-200 mm/min and tool rotational speeds (ω) of چکیده کامل

  The effects of friction stir processing (FSP) on the microstructure and mechanical properties of aluminum powder metallurgy (PM) parts was investigated. PM parts were then subjected to FSP at advancing speeds (v) of 40-200 mm/min and tool rotational speeds (ω) of 800-1600 rpm. Microhardness (HV) and tensile tests at room temperature were used to evaluate the mechanical properties of the friction stir processed specimens. In order to evaluate microstructure of processed zone, cross-sections of FS processed specimens were observed optically. Based on the results obtained from investigation of the Zener-Holloman parameter (Z), average grain size decreased with decreasing working temperature and increasing working strain rate (equal to increasing Z). The finest grain size was ~ 5.4µm obtained at ω=1000 and v =100 mm/min corresponding to a strain rate of 27s-1 at 414 . This sample exhibited, the best mechanical properties with microhardness, yield stress, and tensile strength of the 43 Hv, 82 MPa, and 118.3 MPa, respectively. پرونده مقاله