فهرست مقالات Micro-WEDM

• دسترسی آزاد مقاله
  • صفحه چکیده
  • متن کامل
  
  1 - Effect of the Micro Wire-EDM Process Parameters on the Recast Layer in the Molybdenum Micromachining
  Mohammad Tahmasebipour Y. Tahmasebipour A. Shabani M. Boujari Aliabadi
  The Micro wire electrical discharge machining (Micro wire-EDM) process is a modern machining process with various applications in manufacturing micro-parts. The recast layer remaining on the machined surfaces is an inevitable complication of this process. This layer can چکیده کامل

  The Micro wire electrical discharge machining (Micro wire-EDM) process is a modern machining process with various applications in manufacturing micro-parts. The recast layer remaining on the machined surfaces is an inevitable complication of this process. This layer can subsequently affect the machined parts performance. To optimize the recast layer in the micro wire-EDM of the molybdenum microparts, effect of the process parameters on the distribution amplitude of the recast layer was investigated using the Taguchi method. The obtained results showed that the optimal levels of the micro wire-EDM process parameters for achieving the optimal distribution amplitude of the recast layer are as follows: spark pulse-on time of 0.2 μs, cutting speed of 7 mm/min, process voltage of 17 V, and wire tension of 0.45 kg. Also the importance order of the effect of the process parameters on the distribution amplitude of recast layer is as follows: spark pulse-on time, process voltage, cutting speed, and wire tension. پرونده مقاله
• دسترسی آزاد مقاله
  • صفحه چکیده
  • متن کامل
  
  2 - Micro Wire Electrical Discharge Machining of MEMS Structures with Optimized Dimensional Deviation
  Mohammad Tahmasebipour Younes Tahmasebipour Ali Vafaie
  Metal-based microelectromechanical systems are widely used in applications such as micro-energy harvesters, micro-heat exchangers and micro-electromagnetic that require high strength and flexibility. In the fabrication of such systems, micro wire electrical discharge ma چکیده کامل

  Metal-based microelectromechanical systems are widely used in applications such as micro-energy harvesters, micro-heat exchangers and micro-electromagnetic that require high strength and flexibility. In the fabrication of such systems, micro wire electrical discharge machining (MicroWEDM) is majorly used. This paper studies the effect of the MicroWEDM process parameters on the dimensional deviation of machined MEMS structures including microcantilevers and micro-beams using the Taguchi method. Using optimal levels of the parameters including pulse duration (0.8 µs), cutting speed (8.4 mm/min), voltage (17 V) and wire tension (0.5 kg), the dimensional deviation is reduced about 8.65 times compared with the average of experiments results. The order of effect importance of the process parameters on the dimensional deviation of microstructures obtained by the ANOVA analysis of S/N ratios is as follows: pulse duration, wire tension, process voltage and cutting speed. Dimensional deviation of the micro-features was reduced to 1 μm using the optimal levels of the process parameters. پرونده مقاله