Production and Characterization of Nano Crystalline Fe85Si10Ni5 Soft Magnetic Alloys by Mechanical Alloying
محورهای موضوعی : Materials synthesis and charachterizationArash Dezhsetan 1 , Ali Saidi 2 , Reza Ebrahimi-Kahrizsangi 3
1 - Department of Material Engineering, Najafabad Branch, Islamic Azad University, Isfahan, Iran
2 - Department of Materials Engineering, Isfahan University of Technology, Isfahan, Iran
3 - Department of Material Engineering, Najafabad Branch, Islamic Azad University, Isfahan, Iran
کلید واژه: mechanical alloying, Magnetic properties, Nano crystalline materials, Soft magnetic powders,
چکیده مقاله :
Abstract There are various methods to produce iron based nano crystalline magnetic alloys. Among these methods, mechanical alloying is one of the most important. In this research, nano crystalline Fe85Si10Ni5 soft magnetic alloy was synthesized by mechanical alloying. The effect of alloying time on phase constituents and magnetic properties of the produced powders was investigated, by X-ray diffraction (XRD) and alternating gradient force magnetometer (AGFM). The XRD results showed that alloy formation started after 2 hours of milling. Further milling resulted in the reduction of the grain size and lattice parameter. After 60 hours of milling, the grain size was reduced to 8 nm. AGFM results showed that magnetic saturation and coercivity depends on the alloying time. Increasing the alloying time, causes the increase of magnetic saturation and decrease of coercivity. Abstract There are various methods to produce iron based nano crystalline magnetic alloys. Among these methods, mechanical alloying is one of the most important. In this research, nano crystalline Fe85Si10Ni5 soft magnetic alloy was synthesized by mechanical alloying. The effect of alloying time on phase constituents and magnetic properties of the produced powders was investigated, by X-ray diffraction (XRD) and alternating gradient force magnetometer (AGFM). The XRD results showed that alloy formation started after 2 hours of milling. Further milling resulted in the reduction of the grain size and lattice parameter. After 60 hours of milling, the grain size was reduced to 8 nm. AGFM results showed that magnetic saturation and coercivity depends on the alloying time.
