Optimization of scheduling information in a network-based Standard IEEE802. 17 and measurement for video transmission
محورهای موضوعی : Majlesi Journal of Telecommunication DevicesEhsan Korbekandi 1 , Mohsen Ashourian 2 , Sayed Ali Hashemi 3
1 -
2 -
3 -
کلید واژه: en, return- closed loop network scheduling priority queue-scheduling DRR- timing DRR,
چکیده مقاله :
One of looped networks that in recent years has been much noticed is standard known as IEEE 802.17 RPR ring network or the return packet. Architecture RPR ring network protocol that transmits data between nodes connected in a double ring structure to support. RPR has two single transit buffer structure (STB) and double transit buffer (DTB), respectively. Single transit buffer architecture, just a high-priority traffic buffering (HP) and low priority (LP) passing through the ring buffer architecture serves and double, two separate buffer for high-priority and low priority traffic is considered passing.Send information for scheduling algorithms used in network nodes RPR, queue priority (Priority-Queue), respectively. In this way, the separation of traffic based on priority and high priority traffic has absolute priority over lower priority traffic so that always the highest priority to transit buffer appropriated therefore of high priority traffic such as video packet, the nodes access to congested suffered numerous delays and instability vibration are ring (Jitter).In this thesis addition to scheduling priority queue, plans, schedules DRR and DRR + to increase the quality of service to traffic with high priority on congested node in a network with a ring structure with 10 nodes software Opnet simulation and the performance timing of passing information about at least two network nodes in the hub scenario (hUB) in which all the nodes transmit information to a node with video traffic conditions, congestion were examined happened and qualitative results were compared to that, the display shows the relative improvements in reducing delays and instability shaking changes in the timing of DRR and DRR + compared to the recommended standard.
1. Alharbi, Fahd, and Nirwan Ansari. "Distributed bandwidth allocation for resilient packet ring networks." U.S. Patent No. 7948881. 24 May 2011.
2. Bonald, Thomas, Sara Oueslati, and James Roberts. "Technique for communication between a plurality of nodes." U.S. Patent No. 8797894. 5 Aug. 2014.
3. Domzal, Jerzy. "Congestion control in Flow-Aware Resilient Multi-ring Networks." Computing, Networking and Communications (ICNC), 2014 International Conference on. IEEE, 2014.
4. Francisco, Mark Joseph, et al. "A comparison of two buffer insertion ring architectures with fairness algorithms." Communications, 2003. ICC'03. IEEE International Conference on. Vol. 1. IEEE, 2003.
5. Ji, Liang, T. N. Arvanitis, and S. I. Woolley. "Fair weighted round robin scheduling scheme for DiffServ networks." Electronics Letters 39.3 (2003): 333-335.
6. Kao, J. "Darwin Proposal for IEEE Standard 802.17." (2002).
7. Kleinrock, Leonard, and Simon S. Lam. "Packet switching in a multiaccess broadcast channel: Performance evaluation." Communications, IEEE Transactions on 23.4 (1975): 410-423.
8. M. Kaiser, "suggested scheduling information using DRR + node in a network based on IEEE802.17 of standard and comparing the results of simulation in other methods", Master Thesis, 1391, Islamic Azad Majlesi University.
9. Takefman, M. 2004. IEEE Draft P802.17, Draft 3.3. September 20, "http://www.ieee802.org/17/ performance_committee.htm".
10. Tsiang, D., and G. Suwala. The Cisco SRP MAC layer protocol. No. RFC 2892. 2000.
11. Yilmaz, Mete, and Nirwan Ansari. "Achieving destination differentiation in ingress aggregated fairness for resilient packet rings by weighted destination based fair dropping." Computer Networks 62 (2014): 43-54.
