Proposing a New Approach to Optimize the Windcatcher's Performance

محورهای موضوعی : Architecture

Mona Mohtaj ¹ , Mansoureh Tahbaz ² , Atefeh Dehghan Touran Poshti ³

1 - Ph.D. Candidate, Faculty of Architecture, West Tehran Branch, Islamic Azad University, Tehran, Iran.
2 - Associate Professor, Shahid Beheshti University, School of Architecture, Department of Cons‌truction, Tehran, Iran
3 - Department of Architecture, West Tehran Branch, Islamic Azad University, Tehran, Iran.

تاریخ دریافت : 1402/06/06 تاریخ پذیرش : 1403/02/16 تاریخ انتشار : 1403/03/20

کلید واژه: Natural Ventilation, Vernacular houses, Hot and Humid, Simulation, Thermal comfort,

چکیده مقاله :

Hot and humid climate is one of the robust climates in the world. Vernacular architecture in this area answer to climate conditions with solutions, one of these solutions are windcatchers. Nowadays most of these windcatchers are closed because they are not responsive to current thermal comfort conditions. The reduction of wind speed and the lack of control over the entering hot weather can be considered as two main weaknesses of the windcatchers in these areas. This research suggested to install Damper and Fan to improve the performance of windcatchers in vernacular houses of Bandar-Kong. five windcatchers have been selected as case studies and their performance has been simulated and measured in 24 different modes: open windcatcher (past method), closed windcatcher (current state), windcatcher with valve and windcatcher with fan are four general modes wich are divided to 6 subset. Design Builder 7.0.0.116 is used for simulations. operative temperature is calculated for each space in 24 different modes. The results show that using fan and damper, increase thermal comfort hours from about 43 to 52 percent. Besides using fans and dampers can obviously reduce temperatures over 35degrees.

چکیده انگلیسی:

Hot and humid climate is one of the robust climates in the world. Vernacular architecture in this area answer to climate conditions with solutions, one of these solutions are windcatchers. Nowadays most of these windcatchers are closed because they are not responsive to current thermal comfort conditions. The reduction of wind speed and the lack of control over the entering hot weather can be considered as two main weaknesses of the windcatchers in these areas. This research suggested to install Damper and Fan to improve the performance of windcatchers in vernacular houses of Bandar-Kong. five windcatchers have been selected as case studies and their performance has been simulated and measured in 24 different modes: open windcatcher (past method), closed windcatcher (current state), windcatcher with valve and windcatcher with fan are four general modes wich are divided to 6 subset. Design Builder 7.0.0.116 is used for simulations. operative temperature is calculated for each space in 24 different modes. The results show that using fan and damper, increase thermal comfort hours from about 43 to 52 percent. Besides using fans and dampers can obviously reduce temperatures over 35degrees.

منابع و مأخذ:

- Alessandro Araldi, D.; Emsellem, G.; Fusco, A.; Tettamanzi, D. O. (2021). Exploring building typologies through fast iterative Bayesian clustering. SAGEO 2021 Proceedings, Avignon, UMR ESPACE, 113-124
- Afshin, M., Sohankar, A., Manshadi, M. D., & Esfeh, M. K. (2016). An experimental study on the evaluation of natural ventilation performance of a two-sided wind-catcher for various wind angles. Renewable Energy, 85, 1068-1078. 10.1016/j.renene.2015.07.036
- Bahadori, M., Mazidi, M., & Dehghani, A. (2008). Experimental investigation of new designs of wind towers. Renewable Energy, 33(10), 2273-2281. DOI:10.1016/j.renene.2007.12.018
- Babakhani, R., Keifari, A. (2021). Explaining the Evolution of Iranian Traditional House Spaces Based
on Distance Measurement Method of Plan Similarity Vector, Space Ontology International Journal,10(39), 97-103
- Calautit, J. K., & Hughes, B. R. (2014). Integration and application of passive cooling within a wind tower for hot climates. HVAC&R Research, 20(7), 722-730. DOI:10.1080/10789669.2014.936795
- Calautit, J. K., Hughes, B. R., & Shahzad, S. S. (2015). C.F.D. and wind tunnel study of the performance of a uni-directional wind catcher with heat transfer devices. Renewable Energy, 83, 85-99. DOI:10.1016/j.renene.2015.04.005
- Chenari, B., Carrilho, J. D., & da Silva, M. G. (2016). Towards sustainable, energy-efficient and healthy ventilation strategies in buildings: A review. Renewable and Sustainable Energy Reviews, 59, 1426-1447. DOI:10.1016/j.rser.2016.01.074
- Chohan, A. H., & Awad, J. (2022). Wind Catchers: An Element of Passive Ventilation in Hot, Arid and Humid Regions, a Comparative Analysis of Their Design and Function. Sustainability, 14(17), 11088. DOI:10.3390/su141711088
- Dehghan, A., Esfeh, M. K., & Manshadi, M. D. (2013). Natural ventilation characteristics of one-sided wind catchers: experimental and analytical evaluation. Energy and buildings, 61, 366-377. DOI:10.1016/j.enbuild.2013.02.048
- Dehghani-sanij, A. R., Soltani, M., & Raahemifar, K. (2015). A new design of wind tower for passive ventilation in buildings to reduce energy consumption in windy regions. Renewable and Sustainable Energy Reviews, 42, 182-195. DOI: 10.1016/j.rser.2014.10.018
- Farhadi, M., Jamzadeh, M. (2017) Examining similarity criteria in content-based image retrieval. Computer Science, (21), 13-27.
- Fanood, M. R. (2014). The role of four key structures in the creation and survival of cultural landscapes in the desert environment of Iran. Journal of Architectural Conservation, 20(3), 184-196. DOI:10.3390/heritage4040219
- Farouk, M. (2020). Comparative study of hexagon & square wind catchers using C.F.D. simulations. Journal of Building Engineering, 31, 101366. DOI:10.1016/j.jobe.2020.101366
- Haghighi, A., Pakdel, S., & Jafari, A. (2016). A study of a wind catcher assisted adsorption cooling channel for natural cooling of a 2-storey building. Energy, 102, 118-138. channel for natural cooling of a 2-storey building. Energy, 102, 118-138.
- Hosseinnia, S. M., Saffari, H., & Abdous, M. A. (2013). Effects of different internal designs of traditional wind towers on their thermal behavior. Energy and buildings, 62, 51-58. DOI:10.1016/j.enbuild.2012.10.058
- Hughes, B. R., Calautit, J. K., & Ghani, S. A. (2012). The development of commercial wind towers for natural ventilation: A review. Applied energy, 92, 606-627. DOI:10.1016/j.apenergy.2011.11.066
- Hu, R.; Huang, Z.; Tang, Y.; Van Kaick, O.; Zhang, H.; Huang, H., (2020), Graph2 Plan: Learning Floorplan Generation from Layout Graphs, arXiv:2004.13204, April 2020
- Jomehzadeh, F., Hussen, H. M., Calautit, J. K., Nejat, P., & Ferwati, M. S. (2020). Natural ventilation by windcatcher (Badgir): A review on the impacts of geometry, microclimate and macroclimate. Energy and buildings, 226, 110396. DOI:10.1016/j.enbuild.2020.110396
- Jomehzadeh, F., Nejat, P., Calautit, J. K., Yusof, M. B. M., Zaki, S. A., Hughes, B. R., & Yazid, M. N. A. W. M. (2017). A review on windcatcher for passive cooling and natural ventilation in buildings, Part 1: Indoor air quality and thermal comfort assessment. Renewable and Sustainable Energy Reviews, 70, 736-756. DOI:10.3390/buildings12060791
- Khan, N., Su, Y., & Riffat, S. B. (2008). A review on wind driven ventilation techniques. Energy and buildings, 40(8), 1586-1604. DOI:10.1016/j.enbuild.2008.02.015
- Mostafaeipour, A., Bardel, B., Mohammadi, K., Sedaghat, A., & Dinpashoh, Y. (2014). Economic evaluation for cooling and ventilation of medicine storage warehouses utilizing wind catchers. Renewable and Sustainable Energy Reviews, 38, 12-19. DOI:10.1016/j.rser.2014.05.087
- Nejat, P., Calautit, J. K., Majid, M. Z. A., Hughes, B. R., Zeynali, I., & Jomehzadeh, F. (2016). Evaluation of a two-sided windcatcher integrated with wing wall (as a new design) and comparison with a conventional windcatcher. Energy and buildings, 126, 287-300. DOI:10.1016/j.enbuild.2016.05.025
- Nikghadam, N., & Mofidi Shemirani, S. M. (2018). Impact of Airflow on Moderating Thermal Conditions in Vernacular Houses; Case Study: Bandar-e Lengeh Houses in Hot and Humid Climate of Iran, Armanshahr, 11(24), 41-52. https://doi.org/10.30475/isau.2017.62028
- O'Connor, D., Calautit, J. K., & Hughes, B. R. (2016). A novel design of a desiccant rotary wheel for passive ventilation applications. Applied energy, 179, 99-109. DOI:10.1016/j.apenergy.2016.06.029
- Patel, D., Rajan, S., Patel, D. D., & Rajan, S. (2015). Design of a passive and wind speed responsive wind catcher for energy efficient buildings. IJIRST–International Journal for Innovative Research in Science & Technology, 1(8), 125-128. DOI:10.6092/issn.2281-4485/8240
- Saadatian, O., Haw, L. C., Sopian, K., & Sulaiman, M. Y. (2012). Review of windcatcher technologies. Renewable and Sustainable Energy Reviews, 16(3), 1477-1495. https://doi.org/10.1016/j.scs.2017.12.002
- Sadeghi, H., & Kalantar, V. (2018). Performance analysis of a wind tower in combination with an underground channel. Sustainable Cities and Society, 37, 427-437.
- Shaeri, J., Yaghoubi, M., Aflaki, A., & Habibi, A. (2018). Evaluation of thermal comfort in traditional houses in a tropical climate. Buildings, 8(9), 126. DOI:10.3390/buildings8090126
- Shah Mohammadi, N., Babakhani, R. (2020). Analysis of the writing pattern of Nasir al-Molk mosque sashes based on the effects of environmental psychology on the psychological perceptions of users. Environmental Science and Technology, 23(8): 37-46
- Valipour, E., & Oshrieh, R. (2013). Survey of Traditional Wind Catchers of the Middle East. In ICSDEC 2012: Developing the Frontier of Sustainable Design, Engineering, and Construction (pp. 912-920). https://doi.org/10.1061/9780784412688.109
- Varela-Boydo, C., & Moya, S. (2020). Inlet extensions for wind towers to improve natural ventilation in buildings. Sustainable Cities and Society, 53, 101933. https://doi.org/10.1016/j.scs.2019.101933
- Varela-Boydo, C., Moya, S., & Watkins, R. (2020). Study of wind towers with different funnels attached to increase natural ventilation in an underground building. Frontiers of Architectural Research, 9(4), 925-939. https://doi.org/10.1016/j.foar.2020.05.007
- Yousif, S. & Wei, Y. (2019). Shape clustering using k-medoids in architectural form finding. In Computer-Aided Architectural Design. 18th international conference, CAAD Futures 2019. DOI:10.1007/978-981-13-8410-3_32
- Zafarmandi, S., & Mahdavinejad, M. (2021). Technology of modern windcatchers: A review. Int. J. Architect. Eng. Urban Plan, 31(3), 1-11. DOI: 10.22068/ijaup.31.3.549
- Zarandi, M. M. (2015). Comparative analysis on architectural characters of Iranian wind catchers in hot arid (case study: Yazd & Bandar Lengeh). International Journal of Advanced and Applied Sciences, 2(8), 17-22.