Efficiency Improvement of InGaP/SiGe Tandem Solar Cell Using Si0.18Ge0.82 Graded Buffer Regions
محورهای موضوعی : فصلنامه نانوساختارهای اپتوالکترونیکیMojtaba Shahraki 1 , Majid Ghadrdan 2
1 - Faculty of Electrical and Computer Engineering, University of Sistan and Baluchestan, Zahedan, Iran
2 - Faculty of Electrical and Computer Engineering, University of Sistan and Baluchestan, Zahedan, Iran
کلید واژه: Efficiency (Eff), Graded Buffer, Open Circuit Voltage (Voc), Short Circuit Current Density (Jsh) ,
چکیده مقاله :
In this paper, the effect of SiGe graded buffers on the performance of an InGaP/SiGe tandem solar cells is investigated. It is shown that, by the proper design of graded buffer layers, the efficiency of solar cells can be improved considerably. The proposed structure consists of an InGaP top cell and a SiGe bottom cell, which are separated by a tunnel junction and a window layer. Each part has a BSF layer and graded buffers are used between window and bottom cell as well as the bottom cell and the substrate.
Different parameters of the solar cell, involving photogeneration rate, electric field and the built-in potential, are calculated. Using the PSO algorithm for the proposed solar cell, the optimized dimensions and doping are determined to reach the maximum efficiency. The short circuit current density (Jsh) of 21.5 mA/cm2, Open circuit voltage (Voc) of 2.14 V, efficiency (η) of 38.18% and fill factor (FF) of 83% are obtained, which show the applicable improvement compared to other works.
In this paper, the effect of SiGe graded buffers on the performance of an InGaP/SiGe tandem solar cells is investigated. It is shown that, by the proper design of graded buffer layers, the efficiency of solar cells can be improved considerably. The proposed structure consists of an InGaP top cell and a SiGe bottom cell, which are separated by a tunnel junction and a window layer. Each part has a BSF layer and graded buffers are used between window and bottom cell as well as the bottom cell and the substrate.
Different parameters of the solar cell, involving photogeneration rate, electric field and the built-in potential, are calculated. Using the PSO algorithm for the proposed solar cell, the optimized dimensions and doping are determined to reach the maximum efficiency. The short circuit current density (Jsh) of 21.5 mA/cm2, Open circuit voltage (Voc) of 2.14 V, efficiency (η) of 38.18% and fill factor (FF) of 83% are obtained, which show the applicable improvement compared to other works.
[1] M. Amirhoseiny, M. Zandi, A. Kheiri, A comparative study of BSF layers for InGaN single-junction and multi-junction solar cells. journal of optoelectronical nanostructures. 9(1) published online (2024).
https://jopn.marvdasht.iau.ir/article_6220.html
[2] A. Mahmoudloo, Investigation and Simulation of Recombination Models in Virtual Organic Solar Cell. journal of optoelectronical nanostructures.7(4) (2022) 1-12.
https://jopn.marvdasht.iau.ir/article_5674.html
[3] S. R. Hosseini, M. Bahramgour, N. Delibas, A. Niaei. A simulation study around investigating the effect of polymers on the structure and performance of a perovskite solar cell. journal of optoelectronical nanostructures, 7(2) (2022) 37-50.
https://jopn.marvdasht.iau.ir/article_5264.html
[4] M. rajaee, S. Rabiee. Analysis and Implementation of a New Method to Increase the Efficiency of Photovoltaic Cells by Applying a Dual Axis Sun Tracking System and Fresnel Lens Array. journal of optoelectronical nanostructures. 6 (3) (2021) 59-80.
https://jopn.marvdasht.iau.ir/article_4981.html
[5] R. yahyazadeh, Z. hashempour. Effect of Hydrostatic Pressure on Optical Absorption Coefficient of InGaN/GaN of Multiple Quantum Well Solar Cells. journal of optoelectronical nanostructures. 6(2) (2021) 1-22.
https://jopn.marvdasht.iau.ir/article_4768.html
[6] S. Fonash, Semiconductor–semiconductor Heterojunction Cells, in Solar Cell Device Physics, 2nd ed., United States of America, Academic Press, Elsevier, 2010, 183-262.
https://www.sciencedirect.com/book/9780123747747/solar-cell-device-physics
[7] A. Goetzberger, J. Knobloch, and B. Voß, The Physics of Solar Cells, in Crystalline Silicon Solar Cells, Chichester, UK, John Wiley & Sons, 2014, 67–86.
https://www.wiley.com/en-us/Crystalline+Silicon+Solar+Cells-p-9780471971443
[8] A. Luque and S. Hegedus, The Physics of the Solar Cell, in Handbook of Photovoltaic Science and Engineering, vol. 1. Chichester, UK, John Wiley & Sons, 2003.
https://onlinelibrary.wiley.com/doi/book/10.1002/0470014008
[9] M. R. Salehi, M. Shahraki. Circuit modeling of waveguide grating nanostructures in ultrathin solar cells. IEEE Transactions on Nanotechnology, 16(4) (2017) 616-623.
https://ieeexplore.ieee.org/document/7912409
[10] S. L. Mortazavifar, M. R. Salehi, M. Shahraki. Ultrathin nano-ring metasurface absorber in visible regime based on circuit model. The European Physical Journal Plus. 137(9) (2022) 1072.
https://epjplus.epj.org/articles/epjplus/abs/2022/09/13360_2022_Article_3272/13360_2022_Article_3272.html
[11] A. Willoughby and G. Conibeer, Solar Cell Materials: Developing Technologies, 1st ed. Chichester, UK: John Wiley & Sons, 2014.
https://www.wiley.com/en-us/Solar+Cell+Materials%3A+Developing+Technologies-p-9781118695814
[12] K. Gledhill. High-efficiency multi-junction space solar cells. presented at the Space Programs and Technologies Conference, 32 (1995) 1-4.
https://arc.aiaa.org/doi/10.2514/6.1995-3540
[13] L. Fara and M. Yamaguchi, Advanced Solar Cell Materials, Technology, Modeling, and Simulation. IGI Global, (2013).
https://www.igi-global.com/book/advanced-solar-cell-materials-technology/63885
[14] G. S. Sahoo and G. P. Mishra. Effective use of spectrum by an ARC less dual junction solar cell to achieve higher efficiency: A simulation study. Superlattices and Microstructures, 109 (2017) 794–804.
https://www.sciencedirect.com/science/article/abs/pii/S0749603617309175
[15] R. Oshima, M. Yamanaka, H. Kawanami, I. Sakata, and K. Matsubara. Fabrication of 0.9 eV bandgap a-Si/c-Si1-xGe1-x heterojunction solar cells presented at the 2014 IEEE 40th Photovoltaic Specialist Conference (PVSC), (2014) 0202–0205.
https://ieeexplore.ieee.org/document/6925575
[16] A. Aissat, F. Benyettou, S. Nacer, and J. P. Vilcot. Modeling and simulation of solar cells quantum well based on SiGe/Si. International Journal of Hydrogen Energy. 42(13) (2017) 8790–8794.
https://www.sciencedirect.com/science/article/abs/pii/S0360319916308114
[17] A. K. Singh, J. Tiwari, A. Yadav, and R. K. Jha, Analysis of Si/SiGe Heterostructure Solar Cell. Journal of Energy, 2014 (2014) 1–7.
https://www.hindawi.com/journals/jen/2014/946406/
[18] E. Polyzoeva, S. Abdul Hadi, A. Nayfeh, and J. L. Hoyt. Reducing optical and resistive losses in graded silicon-germanium buffer layers for silicon based tandem cells using step-cell design. AIP Advances. 5(5) (2015) 057161.
https://pubs.aip.org/aip/jap/article-abstract/119/7/073104/142365/Theoretical-efficiency-limit-for-a-two-terminal?redirectedFrom=fulltext
[19] K. J. Singh, S. K. Sarkar. Highly efficient ARC less InGaP/GaAs DJ solar cell numerical modeling using optimized InAlGaP BSF layers. Optical and Quantum Electronics. 38(4) (2012) 1-20.
https://link.springer.com/article/10.1007/s11082-011-9499-y
[20] M. Diaz et al., Tandem GaAsP/SiGe on Si solar cells. Solar Energy Materials and Solar Cells. 143 (2015) 113–119.
https://www.sciencedirect.com/science/article/abs/pii/S0927024815003025
[21] L. Wang et al. Current matched three-terminal dual junction GaAsP/SiGe tandem solar cell on Si. Solar Energy Materials and Solar Cells. 146 (2016) 80-86.
https://www.sciencedirect.com/science/article/abs/pii/S0927024815006212
[22] X. Zhao et al. Short circuit current and efficiency improvement of SiGe solar cell in a GaAsP-SiGe dual junction solar cell on a Si substrate. Solar Energy Materials and Solar Cells, 159 (2017) 86–93,
https://www.sciencedirect.com/science/article/abs/pii/S0927024816303282
[23] J. P. Dutta, P. P. Nayak, G.P. Mishra, Design and evaluation of ARC less InGaP/GaAs DJ solar cell with InGaP tunnel junction and optimized double top BSF layer. Optik, 127 (2016) 4156–4161.
https://www.sciencedirect.com/science/article/abs/pii/S0030402616000905
[24] G.S. Sahoo, G.P. Mishra, Effective use of spectrum by an ARC less dual junction solar cell to achieve higher efficiency: A simulation study. Superlattices and Microstructures. 109 (2017) 794-804.
https://www.sciencedirect.com/science/article/abs/pii/S0749603617309175
[25] P. Cano, M. Hinojosa, H. Nguyen, et al., Hybrid III-V/SiGe solar cells grown on Si substrates through reverse graded buffers. Solar Energy Materials and Solar Cells. 205 (2020) 110246.
https://www.sciencedirect.com/science/article/abs/pii/S0927024819305756
[26] E. Kim, M. A. Madarang, E. Ju, et al., GaAs/Si Tandem Solar Cells with an Optically Transparent InAlAs/GaAs Strained Layer Superlattices Dislocation
Filter Layer. Energies. 16 (2023) 1158.
https://www.mdpi.com/1996-1073/16/3/1158
[27] NJ. Hoboken , Solar Cells and their Applications, John Wiley & Sons, Inc., 2010.
https://www.wiley.com/en-us/Solar+Cells+and+Their+Applications%2C+2nd+Edition-p-9780470446331
[28] E. D. Palik, Handbook of Optical Constants of Solids, Academic Press, 1998.
https://www.sciencedirect.com/book/9780125444224/handbook-of-optical-constants-of-solids
[29] G. S. Sahoo, P. P. Nayak, and G. P. Mishra. An ARC less InGaP/GaAs DJ solar cell with hetero tunnel junction. Superlattices and Microstructures. 95 (2016) 115–127.
https://www.sciencedirect.com/science/article/abs/pii/S0749603616301975
[30] C. A. Gueymard, D. Myers, and K. Emery Proposed reference irradiance spectra for solar energy systems testing. Solar Energy. 73 (6) (2016) 443–467.
https://www.sciencedirect.com/science/article/abs/pii/S0038092X03000057
[31] J. W. Leem, Y. T. Lee, and J. S. Yu. Optimum design of InGaP/GaAs dual-junction solar cells with different tunnel diodes. Optical and Quantum Electronics, 41(8) (2009) 605–612.
https://link.springer.com/article/10.1007/s11082-010-9367-1
[32] N. Jain and M. K. Hudait. Design of metamorphic dual-junction InGaP/GaAs solar cell on Si with efficiency greater than 29% using finite element analysis presented at the 38th IEEE Photovoltaic Specialists Conference, (2012) 002056–002060.
https://ieeexplore.ieee.org/document/6318003
[33] L. Wang et al. Material and Device Improvement of GaAsP Top Solar Cells for GaAsP/SiGe Tandem Solar Cells Grown on Si Substrates. IEEE Journal of Photovoltaics, 5(6) (2015) 1800–1804.
https://ieeexplore.ieee.org/document/7194733
[34] J. Wang, Y.-J. Shen, N. Quitoriano. Growth evolution of SiGe graded buffers during LPE cooling process. Journal of Crystal Growth, 502(15) (2018) 54-63.
https://www.sciencedirect.com/science/article/abs/pii/S0022024818304068
[35] P. Caño, M. Hinojosa, I. García, et al. GaAsP/SiGe tandem solar cells on porous Si substrates. Solar Energy. 230 (2021) 925-934.
https://www.sciencedirect.com/science/article/abs/pii/S0038092X21009385
