An Isolated Bidirectional Converter with Zero Current Switching for Photovoltaic Applications

Subject Areas : Electronic Engineering

Abdulrahman  Salim ¹ (Independent High Electoral Commission, Baghdad, Iraq)
Babak  Keyvani ² (Department of Electrical Engineering, Broujen Branch, Islamic Azad University, Broujen, Iran|Energy Research Center, Shahrekord Branch, Islamic Azad University, Shahrekord, Iran)

Received: 2023-10-20 Accepted : 2024-01-22 Published : 2024-09-20

Keywords: isolation, Lossless snubbers, high efficiency, Bidirectional converter,

Abstract :

In this paper, a new isolated bidirectional converter is presented so that by using a new snubber without any additional switch, soft switching is provided for both main switches and the energy of the snubber circuit is transferred to the output. The number of proposed converter elements is low and its control is very simple because only one switc5h operates on each side and the other switch does not take command signal. One of its features is not using separate inductors in the snubber circuit and using the third coil for the snubber circuit. The performance of the proposed converter has been fully analyzed and simulated in PSPICE software, the results of which confirm the theoretical analysis of the converter. On the other hand, an 80W prototype has been made from it, and its practical results have been presented.

References:

1. R. K. Kanaparthi, J. P. Singh and M. S. Ballal, “A review on multi-port bidirectional isolated and non-isolated DC-DC converters for renewable applications,” 2022 IEEE International Conference on Power Electronics, Drives and Energy Systems (PEDES), Jaipur, India, pp. 1-6, 2022, doi: 10.1109/PEDES56012.2022.10080049.


2. M. Uno and K. Sugiyama, “Switched capacitor converter based multiport converter integrating bidirectional PWM and series-resonant converters for standalone photovoltaic systems,” IEEE Transactions on Power Electronics, vol. 34, no. 2, pp. 1394-1406, Feb. 2019, doi: 10.1109/TPEL.2018.2828984.


3. M. Delshad, A. T. Harchegani, M. Karimi and M. Mahdavi, “A new ZVT multi-input converter for hybrid sources systems,” 2016 International Conference on Applied Electronics (AE), Pilsen, Czech Republic, pp. 61-64, 2016, doi: 10.1109/AE.2016.7577242.


4. M. Delshad and H. Farzanehfard, “A soft switching flyback current-fed push pull dc-dc Converter with active clamp circuit,” 2008 IEEE 2nd International Power and Energy Conference, Johor Bahru, Malaysia, 2008, pp. 203-207, doi: 10.1109/PECON.2008.4762471.


5. I.O. Lee and G.W. Moon, “Soft-switching dc-dc converter with a full ZVS range and reduced output filter for high-voltage applications,” IEEE Trans. Power Electron., vol.28, no. 1, pp. 112-122, Jan. 2013, doi: 10.1109/TPEL.2012.2199520.


6. H. Cai, J. Xiang, and W. Wei, “Modelling, analysis and control design of a two-stage photovoltaic generation system,” IET Renewable Power Generation, vol. 10, no. 8, pp. 1195-1203, 2016, doi: 10.1049/iet-rpg.2015.0514.


7.  C. Yao, X. Ruan, X. Wang, and C. K. Tse, “Isolated buck-boost dc/dc converters suitable for wide input-voltage range,” IEEE Trans. Power Electron., vol. 26, no. 9, pp. 2599–2613, 2011, doi: 10.1109/TPEL.2011.2112672.


8. S. Shabani, M. Delshad, R. Sadeghi and H. H. Alhelou, “A high step-up PWM non-isolated dc-dc converter with soft switching operation,” IEEE Access, vol. 10, pp. 37761-37773, 2022, doi: 10.1109/ACCESS.2022.3163146.


9. G. Moschopoulos, “Bidirectional and dual active bridge converters, in dc-dc converter topologies: basic to advanced,” IEEE, 2024, pp.369-390, doi: 10.1002/9781119612490.ch16.


10. A. Iranpour Mobarakeh, R. Sadeghi, H. Saghafi Esfahani, and M. Delshad, “Optimal planning and operation of energy hub by considering demand response algorithms and uncertainties based on problem-solving approach in discrete and continuous space,” Electric Power Systems Research, vol. 214, Part A, 108859, ISSN 0378-7796, 2023, doi: 10.1016/j.epsr.2022.108859.


11. A. Belizario, J. C. Colque and J. L. Azcue, “A review of topologies, principles of operation, and modulation strategies for bidirectional LLC resonant converters,” 2023 15th IEEE International Conference on Industry Applications (INDUSCON), São Bernardo do Campo, Brazil, pp. 293-300, 2023, doi: 10.1109/INDUSCON58041.2023.10374577.


12. S. P. Gautam, M. K. Barwar, L. K. Sahu, S. Mohanty, S. K. Dash and K. M. Muttaqi, “A bidirectional single capacitor unit-based hybrid T-type converter topology with sensor-less voltage balancing capabilities,” IEEE Transactions on Circuits and Systems I: Regular Papers, vol. 71, no. 1, pp. 443-453, Jan. 2024, doi: 10.1109/TCSI.2023.3331035.


13. H. Ardi, A. Ajami, F. Kardan, and S. N. Avilagh, “Analysis and implementation of a nonisolated bidirectional DC-DC converter with high voltage gain,” IEEE Trans. Indust. Electron., vol. 63, no. 8, pp. 4878–4888, 2016, doi: 10.1109/TIE.2016.2552139.


14.  H. Ardi, R. R. Ahrabi, and S. N. Ravadanegh “Non‐isolated bidirectional DC–DC converter analysis and implementation,” IET Power Electron., vol. 7, no. 12, pp. 3033–3044, 2014, doi: 10.1049/iet-pel.2013.0898.


15.  B. L. Narasimharaju, S. P. Dubey, and S.P. Singh, “Design and analysis of coupled inductor bidirectional dc-dc convertor for high-voltage diversity applications,” IET Power Electron., vol. 5, no. 7, pp. 998–1007, Aug. 2012, doi: 10.1049/iet-pel.2011.0141.


16. M. Delshad and H. Farzanehfard, “A new isolated bidirectional buck-boost PWM converter,” 2010 1st Power Electronic & Drive Systems & Technologies Conference (PEDSTC), Tehran, Iran, 2010, pp. 41-45, doi: 10.1109/PEDSTC.2010.5471860. 


17. Y. P. Hsieh, J. F. Chen, L. Sh. Yang, C. Y. Wu, and W. S. Liu, “High-conversion-ratio bidirectional dc–dc converter with coupled inductor,” IEEE Trans. Indust. Electron., 2014, vol. 61, no. 1, pp. 210–222, 2014, doi: 10.1109/TIE.2013.2244541. 


18. E. Babaei, Z. Saadatizadeh, and S. Laali, “A new topology of bidirectional buck-boost dc/dc converter with capability of soft switching and input current ripple cancellation,” Iranian Journal of Electrical and Electronic Engineering, vol. 12, no. 2, pp. 134-146, June 2016, doi: 10.22068/IJEEE.12.2.134.


19. E. Babaei, Z. Saadatizadeh, and C. Cecati, “High step-up high step-down bidirectional dc/dc converter,” IET Power Electron., vol. 10, no. 12, pp. 1556-1571, 2017, doi: 10.1049/iet-pel.2016.0977.


20. M. Delshad; N. Asadi and M. R. Amini, “Implementation of soft-switching bidirectional flyback converter without auxiliary switch,” IET Power Electronics, vol. 6, no.9, pp.1884-1891., 2013, doi: 10.1049/iet-pel.2012.0472.