Modeling Water Quality of Rivers Using QUAL2Kw Model (Case Study: Shahroud River)

Subject Areas : Water and Environment

Rozita  Areeyaenezhad ¹ (MSc. Student Department of Water Engineering, Science and Reserch Branch, Islamic Azad University, Tehran, Iran.)
Mahdi  Sarai Tabrizi ² (Assistant Professor, Department of Water Engineering, Science and Reserch Branch, Islamic Azad University, Tehran, Iran.* (Corresponding Author))
Hossein  Babazadeh ³ (Associate Professor, Department of Water Engineering, Science and Reserch Branch, Islamic Azad University, Tehran, Iran.)

Received: 2017-09-20 Accepted : 2017-11-29 Published : 2019-09-23

Keywords: verification, Water quality modeling, QUAL2Kw Model, Shahrood River, Calibration,

Abstract :

Abstract Background and Objective: Modeling water quality of rivers can be used as one of the most effective tools for water quality management in rivers and reducing the environmental impacts of entering pollutants. The purpose of this paper is to use the valid QUAL2Kw 5.1 model to model water quality in Shahrood River. Method: In this paper, seven parameters of water quality have been used including dissolved oxygen (DO), biochemical demand oxygen (BOD), pH, total dissolved solids (TDS), total phosphorus, and total nitrogen four times in Shahrood River. Data from October of 2007 and July of 2008 were used to calibrate and data from September and October of 2008 were used to verify the model. Auto-calibration of model coefficients was done using genetic algorithm of the model. In order to compare simulated results with the observed data, determination coefficient and mean absolute error were used. Findings: The most important calibration coefficients of the model were related to TSS, BOD, total nitrogen and phosphorus. This model in simulation of pH and EC with mean absolute error of 0.19 and 163.89 during verification stage showed the most and the least accuracy, respectively. On average the minimum and maximum DO were measured 6.93 and 9.99 mg/L in September and October of 2008 respectively in Shahroud River. Also the highest and lowest accuracy of the model in simulating these parameters were related to July and October of 2008 with mean absolute error of 0.86 and 1.29, respectively. In addition the results showed accurate hydraulic modeling of hydraulic parameters changes of the river along the river had a great influence on modeling of the water river quality. Discussion and Conclusion: The results of this paper show the accuracy of the QUAL2Kw model in simulating water quality parameters of Shahrood River. On the other hand, the accuracy of the simulation of each parameter varies with the amount of its variation along the river so that the less the changes in a parameter along the river and at different intervals, the higher the accuracy of the model in simulating this parameter will be.

References:

1. Hashemi, S. H., Ghasemi Ziarani, E., 2011. Contamination of load input from sub-basins to Samadirkabir reservoir by using QUAL2K model. Journal of Environmental Studies; 37 (57): 1-8 (in Persian).


2. Shokri, S., Hooshmand, A., Moaz, H., 2015. Qualitative simulation of ammonium and nitrate in the Gregor River using the QUAL2KW model. Journal of Wetland Ecobiology; 7 (68): 23-57 (in Persian).


3. Khodam Mohammadi, M., Boustani, F., 2016. Assessment of self-healing power and the role of dissolved oxygen in the quality of water in the river of Khor (Case
   study: Droodzan Dam down to Lake Tashkh-Bakhtegan). Journal of Water Resources Engineering; 7 (27): 85-98 (in Persian).


4. Hosseini, P., Ildoromi, A.R., Hosseini, Y., 2016. The Study of Qual2kw Model Efficacy on River Self-purification (A Case Study of Karun River at Interval of Zargan to Kute Amir). Journal of Environmental Science and Technology; 18 (4): 103-122 (in Persian).


5. Hosseini, P., Hosseini, Y., 2017. Investigating the variation of self-propagation power of Karun River in 87 and 92 years using QUAL2KW model in Ahvaz city. AmirKabir Journal of Civil Engineering; 49 (1): 35-46 (in Persian).


6. Ashegh Moalla, M., Karimi, S., Malek Mohammadi, B., Jafari, H. R., 2015. Procedure of a comprehensive water quality management in rivers. Journal of Multidisciplinary Engineering Science and Technology (JMEST); 2(2): 4-8.


7. Mehrasbi, M. R., Farahmand Kiaa, Z., 2015.Water Quality Modeling and Evaluation of Nutrient Control Strategies Using QUAL2K in the Small Rivers. Journal of Human, Environment and Health Promotion; 1(1): 1-11.


8. Zolfagharipoor, M. A., Ahmadi, A., 2016.A decision-making framework for river water quality management under uncertainty: Application of social choice rules.Journal of Environmental Management; 183(1):152-163.

Sharma, D., Kansal, A., Pelletier, G., 2017. Water quality modeling for urban reach of Yamuna River, India (1999–2009), using QUAL2Kw. Applied Water Science; 7(3): 1535–155