Sensitivity Analysis of Constructional Specifications on Thermal Performance of Naturally Ventilated Box Window Double Skin Facade in Hot Arid Climate of Iran (Tehran)
Subject Areas :
architecture
Faryal sadat Siadati
1
,
Rima Fayaz
2
,
Nilofar Nikghadam
3
1 - PhD researcher, Department of Art and Architecture, South Teharn Branch, Islamic Azad University, Tehran, Iran
2 - Associate Professor, Department of Architecture and Energy, Faculty of Architecture and Urbanism, University of Art, Tehran, Iran
3 - Associate Professor, Department of Art and Architecture, South Teharn Branch, Islamic Azad University, Tehran, Iran
Received: 2021-10-27
Accepted : 2022-06-23
Published : 2023-04-21
Keywords:
Computational Fluid Dynamics,
Hot and dry climate,
Sensitivity analysis,
Box window double skin façade,
Natural ventilation,
Simulation,
Abstract :
The function of the double-skin facade with natural ventilation is based on the thermal performance and airflow of the cavity. Structural features of a naturally ventilated double-skin façade that affect its thermal performance and fluid dynamics include geometric features such as cavity dimensions, airflow path, air inlet, and outlet areas, shading devices material and their location in the cavity, and material properties that are optical and thermal characteristics of transparent skin. In this research, Fluent Software was used to simulate the computational fluid dynamics, and by sensitivity analysis, the effect of changes in structural properties on thermal performance was evaluated. For this aim, 144 simulation scenarios with cavity depths of 30, 60, 90, and 120 cm, inlet and outlet cross-sections of 0.2, 0.4, and 0.8 m2, louver shadings with 0, 30, 45, 60, and 90 degree angles located at one third distance close to the exterior wall of the façade, the model without shading, exterior glass with regular and low emission layer were investigated, and the following results were obtained:- Cavity Depth: It was observed that as the depth increases, the velocity of airflow in the cavity decreases. Changing the width of the hole changes the surface temperature of the inner glass up to a maximum of 0.80 ° C (up to 2%). As the depth of the cavity increases, the heat flux transmitted through the inner glass surface decreases in most cases (up to 6.5%).- Cross-section: As the cross-section increases, the air velocity in the cavity increases the temperature of the inner glass surface changes irregularly but, in most cases, decreases. In addition, the heat flux passing through the inner glass surface often increases (up to a maximum of 16.3%).- Shading: In the case without shading, the air velocity in the cavity is 0.30 to 0.70 m/s, and in the case with 45 degrees of shading, the air velocity in the cavity is between 0.30 and 0.92 m/s. In the case without shading, the temperature of the inner glass surface changes from 39.3 to 41.0 ° C, and in the case with 45 degrees, changes are between 38.65 to 39.5 ° C. In the case without shading, the heat flux transmitted through the inner glass surface changes from 78.0 to 120.0 W/m2, and in the case with 45 degrees shading, differences between 43.0 to 48.2 W/m2. The sensitivity of the heat flux transmitted through the inner glass surface to the presence or absence of shading can lead to a reduction of the heat flux transmittance through the inner glass surface by up to 61.0%.- Exterior glass type of DSF: In the case without shading, the reduction rate of heat flux from the inner glass surface is 19.44% to 29.78%, and in the case with 45-degree shading is from 17.71% to 24.44%. By changing the exterior glass's material (low emission or regular), the heat flux transmitted through the inner glass surface changes by 32.2 and 120 W/m2.
References:
Ahmed, Mostafa M.S., Abel-Rahman, Ali K., Ali, Ahmed Hamza H., & Suzuki, M. (2016). Double skin façade: the state of art on building energy efficiency. Journal of Clean Energy Technology, 4 (1), 84–89.
Aldawoud, A., Salameh, T., & Kim, Y. K. (2020). Double skin façade: energy performance in the United Arab Emirates. Energy Sources, Part B: Economics. Planning, and Policy. 16 (5), 387-405.
Barbosa, S., & Ip, K. (2014). Perspectives of double skin façades for naturally ventilated buildings: a review. Renewable and Sustainable Energy Reviews, 40, 1019–1029.
Cherif, Y., Sassine, E., Lassue, S., & Zalewski, L. (2020). Experimental and numerical natural convection in an asymmetrically heated double vertical façade. International Journal of Thermal Sciences, 152, 106288.
Cho, K., & Cho, D. (2018). Solar heat gain coefficient analysis of a slim-type double skin window system: using an experimental and a simulation method. Energies, 11 (1), 115.
Choi, H., An, Y., Kang, K., Yoon, S., & Kim, T. (2019). Cooling energy performance and thermal characteristics of a naturally ventilated slim double-skin window. Applied Thermal Engineering, 160, 114113.
Colombo, E., Zwahlen, M., Frey, M., & Loux, J. (2017). Design of a glazed double-façade by means of coupled CFD and building performance simulation. Energy Procedia 122, 355–360.
El Ahmar, S., Battista, F., & Fioravanti, A. (2019). Simulation of the thermal performance of a geometrically complex Double-Skin Facade for hot climates: EnergyPlus vs OpenFOAM. Building Simulation, 12 (5), 781–795.
Hachem-Vermette, C. (2020). Selected High-Performance Building Envelopes BT - Solar Buildings and Neighborhoods: Design Considerations for High Energy Performance. Springer, Cham, 67–100.
Hassanli, S., Kwok, K.C.S., & Zhao, M (2018). Performance assessment of a special Double Skin Façade system for wind energy harvesting and a case study. Journal of Wind Engineering and Industrial Aerodynamics, 175, 292–304.
Hens, Hugo S.L. (2017). Building Physics - Heat, Air and Moisture: Fundamentals and Engineering Methods with Examples and Exercises.
Hensen, J.L.M., & Lamberts, R. (2012). Building Performance Simulation for Design and operation.
Hong, X., Leung, M.K.H., & He, W. (2019). Effective use of Venetian blind in Trombe wall for solar space conditioning control. Applied Energy, 250, 452–460.
Hou, K., Li, S., & Wang, H. (2020). Simulation and experimental verification of energy saving effect of passive preheating natural ventilation double skin façade. Energy Exploration & Exploitation, 39(1), 464-487.
Ikrima Amaireh, A.E.K.M. (2017). Numerical Investigation into a Double Skin Façade System Integrated with Shading Devices, with Reference to the City of Amman. University of Nottingham, Jordan.
Iyi, D., Hasan, R., Penlington, R., & Underwood, C. (2014). Double Skin Façade: Modelling Technique and Influence of Venetian Blinds on the Airflow and Heat Transfer. Applied Thermal Engineering, 71 (1), 219-229.
Jankovic, A., & Goia, F. (2021). Impact of double skin facade constructional features on heat transfer and fluid dynamic behavior. Building and Environment, 196, 107796.
Kim, D.D. (2020). Computational fluid dynamics assessment for the thermal performance of double-skin façades in office buildings under hot climatic condition. Building Services Engineering Research and Technology, 42(1).
Li, Y., Darkwa, J., Kokogiannakis, G., & Su, W. (2019). Phase change material blind system for double skin façade integration: system development and thermal performance evaluation. Applied Energy, 252.
Mei, L., Loveday, D.L., Infield, D.G., Hanby, V., Cook, M., Li, Y., Holmes, M., & Bates, J. (2007). The influence of blinds on temperatures and air flows within ventilated double-skin façades. Proceedings of clima, WellBeing Indoors. http:// usir.salford.ac.uk/15870/1/Clima_2007_B02E1606.pdf
Oh, M.H., Lee, K.H., & Yoon, J.H. (2012). Automated control strategies of inside slat-type blind considering visual comfort and building energy performance. Energy and Buildings. 55, 728–737.
Parra, J., Guardo, A., Egusquiza, E., & Alavedra, P. (2015). Thermal performance of ventilated double skin façades with Venetian blinds. Energies, 8 (6), 4882–4898.
Pasut, W., & Di Carli, M. (2012). Evaluation of various CFD modelling strategies in predicting airflow and temperature in a naturally ventilated double skin façade. Applied Thermal Engineering 37, 267-274.
Pourshab, N., Tehrani, M.D., Toghraie, D., & Rostami, S. (2020). Application of double glazed façades with horizontal and vertical louvers to increase natural air flow in office buildings. Energy 200, 117486.
Sanchez, E., Rolando, A., Sant, R., & Ayuso, L. (2016). Influence of natural ventilation due to buoyancy and heat transfer in the energy efficiency of a double skin façade building. Energy for Sustainable Development. 33, 139–148.
Shameri, M.A., Alghoul, M.A., Sopian, K., Zain, M.F.M., & Elayeb, O. (2011). Perspectives of double skin façade systems in buildings and energy saving. Renewable and Sustainable Energy Reviews. 15 (3), 1468–1475.
Sharma, M. K., Preet, S., Mathur, J., Chowdhury, A., & Mathur, S. (2021). Thermal performance analysis of naturally ventilated and perforated sheet based double skin facade system for hot summer conditions. International Journal of Ventilation.
Tao, Y., Zhang, H., Zhang, L., Zhang, G., Tu, J., & Shi, L. (2021). Ventilation performance of a naturally ventilated double-skin façade in buildings. Renewable Energy, 167, 184-198.
Tao, Y., Fang, X., Setunge, S., Tu, J., Liu, J., & Shi, L. (2021). Naturally ventilated double-skin façade with adjustable louvers. Solar Energy 225, 33–43.
Tao, Y., Fang, X., Chew, M. Y. L., Zhang, L., Tu, J., & Shi, L. (2021). Predicting airflow in naturally ventilated double-skin facades: theoretical analysis and modelling. Renewable Energy, 179, 1940-1954.
Tkachenko, S., Timchenko, V., Yeoh, G., & Reizes, J. (2019). Effects of radiation on turbulent natural convection in channel flows. International Journal of Heat and Fluid Flow, 77, 122–133.
Zhang, T., & Yang, H. (2019). Flow and heat transfer characteristics of natural convection in vertical air channels of double-skin solar façades. Applied Energy, 242, 107–120.
Zomorodian, Z.S., & Tahsildoost, M. (2018). Energy and carbon analysis of double skin façades in the hot and dry climate. Journal of Cleaner Production 197, 85-96.
_||_
