Turn-on Angle Control Using Modified Torque Sharing Function for Torque Ripple Reduction in Switched Reluctance Motors

Subject Areas : Electric machine design and control

Mehrdad Daryanush ¹ , Milad Dowlatshahi ² , Javad Pourabadeh ³

1 - Islamic Azad University, Khomeynishahr
2 - Islamic Azad University, Khomeynishahr
3 - Esfahan University of Technology

Received: 2014-12-20 Accepted : 2015-01-24 Published : 2015-04-21

Keywords: Switched Reluctance Motor, torque ripple reduction, turn-on angle control,

Abstract :

In the recent years, the use of switched reluctance motors (SRM) in industrial applications has been increased. In this regard, a large amount of research studies have been conducted on controlling the speed and torque of the aforementioned motors. These motors not only have a simple and stable structure, but also production cost is low. In addition, these motors take advantage of great power, the ability to work in high speeds and inadequate environments (hot and dusty), reliability, control-ability, and high efficiency. However, discrete torque production of SRM along with enormous magnetic saturation in their cores reduces the variety of their industrial applications and also causes the inappropriate torque ripples. In this paper, a modified logical-rule-based method is proposed which employs the technique of controlling torque sharing function. Moreover, the optimized turn-on angle for conducting each phase is achieved by estimating the inductance curve in the vicinity of unaligned position and based on an analytical solution. Simulation results on a four-phase switched reluctance motor and a comparison with the conventional methods indicates validity and effectiveness of the proposed modified method.

References:

[1] S.K. Sahoo, S. Dasgupta, S.K. Panda, J.X. Xu, "A lyapunov function based robust direct torque controller for switched reluctance motor drive system", IEEE Trans. on Power Electronics, Vol. 27, pp. 555-564, Feb. 2012.

[2] S. Saberian-Borojeni, “Fuzzy second order sliding mode speed observer for a synchronous reluctance motor with predictive control”, Journal of Intelligent Procedures in Electrical Technology, Vol. 4, No. 13, pp. 45-52, Winter 2013 (in Persian).

[3] R. Krishnan, "Switched reluctance motor drives modeling, simulation, analysis, design and applications", Boca Rotan, FL: CRC Press, 2001.

[4] V.P. Vujicic, "Minimization of torque ripple and copperlosses in switched reluctance drive", IEEE Trans. Power Electronics, Vol. 27, No. 1, pp. 388-399, Jan. 2012.

[5] B. Fahimi, G. Suresh, J.P. Johnson, M. Ehsani, M. Arefeen, I. Panahi, "Self-tuning control of switched reluctance motors for optimized torque per ampere at all operating points", Proceeding of the  IEEE/APEC, pp. 778–783, 1998.

[6] M.M. Beno, N.S. Marimuthu N.A. Singh, "Improving power factor in switched reluctance motor drive system by optimising the switching angles", Proceeding of the IEEE/TENCON, pp. 1–5, Hyderabad, Nov. 2008.

[7] Y. Sozer, D.A. Torrey, "Optimal turn-off angle control in the face of automatic turn-on angle control for switched-reluctance motors", IET Electric Power Applications, Vol. 1, No. 3, pp. 395–401, May 2007.

[8] X.D. Xue, K.W.E. Cheng, "Optimization and evaluation of torque-sharing functions for torque ripple minimization in switched reluctance motor drives", IEEE Trans. on Power Electronics, Vol. 24, No. 9, pp. 2076-2090, Sep. 2009.

[9] M. Dowlatshahi, S.M. Saghaiannejad, J.W. Ahn, M. Moallem, "Copper loss and torque-ripple minimization of switched reluctance motors considering nonlinear and magnetic saturation effects", Journal of Power Electronics, Vol. 14, No. 2, pp. 351-361, March. 2014.

[10] Y.Z. Xu, R. Zhong, S.L.Lu.L. Chen, "Analytical method to optimise turn-on angle and turn-off angle for switched reluctance motor drives", IET Electric Power Applications, Vol. 6, No. 9, pp. 593–603, Nov. 2012.

[11] M. Dowlatshahi, S.M. Saghaiannejad, J.W. Ahn, M. Moallem, “Minimization of torque-ripple in switched reluctance motors over wide speed range", J Electr Eng Technol, Vol .9, No. 2, pp. 478-488, 2014.

[12] M. Illic-spong, T.J.E. Miller, S.R. MacMinn, J.S. Thorp, "Instantaneous torque control of electric motor drives", IEEE Trans. Power Electron., Vol.2, pp. 55-61, Jan. 1987.

[13] D.S. Schramm, B.W. Williams, T.C. Green, "Torque ripple reduction of switched reluctance motors by PWM phase current optimal profiling", Proceeding of the IEEE/PESC, Vol. 2, pp. 857–860, 1992.

[14] I. Husain, M. Ehsani, "Torque ripple minimization in switched reluctance drives by PWM current control", IEEE Trans. on Power Electronics, Vol. 11, No. 1, pp.83–88, Jan. 1996.

[15] S.C. Sahoo, J.X. Xu, S.K. Panda, "Determination of current waveforms for torque ripple minimization in switched reluctance motors using iterative learning: An nvestigation", IEE Proceeding Electric Power Applications, Vol. 146, No. 4, pp. 369–377, Jul. 1999.