پیش بینی صافی سطح قطعات تنگستن کاربایدی (CO10%-WC) درفرایند EDM با استفاده ازالگوریتم فازی

Subject Areas :

محمدرضا شبگرد ¹ , گوهر رنجبری ²

1 - استادیار گروه مهندسی ساخت و تولید دانشگاه تبریز
2 - مدرس دانشگاه آزاد اسلامی واحد هادیشهر

Received: 2014-01-09 Accepted : 2014-01-09 Published : 1389-02-01

Keywords:

References:

1- Lee,S., Li,X., “study of the surface integrity of the machined workpiece in the EDM of tungsten carbide” "Journal of material processing Technology".,No.139,pp.315-321,2003.

2- Tzeng,Y., Chen.F,“Multi-objective optimization of high-speed electrical discharge machining process using a Taguchi fuzzy-based approach.”," Journal of Materials and design", No.28,pp.1159-1168,2007.

3- Lin.T., Chung, I., Huang. Sh., “Improvement of mchining accuracy by fuzzy logic at corner parts for Wire-EDM”, "Fuzzy sets and systems" No.122 ,pp. 499-511,2001.

4- Yilmaz.O., Eyercioglu,O., Gindy,N., “A user-friendly fuzzy- base system for the selection of electro discharge machining process parameters", "Journal of material processing Technology",No.172.pp.363-371,2006.

5- Lin.y.Ch., Yan.B.H ., Chang.Y.S.“ Machining characteristics of titanium alloy (Ti-6Al-4V) using a combination process of EDM with USM”," Journal of material processing Technology.",No. 104,pp.171-177, 2000.

6- Abdollah, A., shabgard,M.R,“effect of ultrasonic vibration of tool on Electrical Discharge Machining of Tungsten Carbide(WC-Co) ”,Proc of 1^st conf.TICME,Tehran,pp.1-16,2005